Question about 2009 Mercury Grand Marquis

1 Answer

Why don't the headlights work on my 2009 Mercury Marquis?

Nothing

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Mercury Master
  • 6,702 Answers

Could be a fuse, the on / off switch, the relais, defective cable or connector, or both bulbs are defect.
Use a multimeter to check if any of the needed 12 volt comes through, step by step.

Posted on Nov 19, 2014

Testimonial: "Usually it's a case of the regular headlights not working while the high beams (brights) still work if you hold them on while driving, but if you have a 1999-2011 Mercury Marquis, Mercury Marauder, or Crown Victoria, and your regular headlights and or tail lights don't work it probably is your LCM that used to cost around $1,000 to repair. The good news now is that Ford just finally extended the warranty on your LCM (Lighting Control Module) for free - both parts and labor and will install a new one for free! Ford has extended the warranty to 15 years/250,000 miles. THIS IS NOT A RECALL! They do not advertise this. Your regular headlights must be inoperable in order to get a new LCM on this new extended warranty. It must be done at a Ford Dealer and the fix is free. Call your local Ford Dealer and tell them you need to make an appointment because your headlights don't work and that Ford has extended your warranty on the LCM. They may act like they don't know what you are talking about, so tell them it is the Customer Satisfaction Program 14N01. Have your car's Vin number ready as they will ask for it. You don't have to be the original owner. If they still act like they don't know what you are talking about ask to talk to the manager or tell them to call Ford Motor Company and ask them, or you can call Ford yourself. We had ours done at a Ford dealer in August of 2014 in Scottsdale, AZ but first they checked out our LCM first to make sure it didn't work. As soon as they found out it didn't work, the installed a new LCM for free under the about new warranty called "Customer Satisfaction Program 14N01"."

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Monster80
  • 460 Answers

SOURCE: Parking and dash light wont turn on. Headlights will turn on.

Sounds like the the parking light fuse blew.Under the dash there is a fuse block.you will see fuses there and remove the fuse to see if blown.If so replace with same type fuse.Anymore questions will be glad to help you...

Posted on Mar 30, 2009

co7196
  • 3433 Answers

SOURCE: headlights work but dash lights and parking lights are dead

dash and tail sre tied together, so chk tail light fuse.

Posted on May 13, 2009

  • 1986 Answers

SOURCE: how do I adjust headlight beam on 2002 grand

a screwdriver or a socket

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

Posted on Sep 30, 2009

  • 5 Answers

SOURCE: how do I change out the Headlight/ Lighting

u can do it your self the lcm is a stand alone unit just unscrew dissconnect and reconnect and screw

Posted on Jul 10, 2010

shinehutt
  • 254 Answers

SOURCE: how do you replace headlight

you have to remove the whole lens usually two bolts onrad upper rad support remove grill and rmove lens unitturn on headlight mark which bulb to take out looking at other side light

Posted on Jan 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why don't my headlights work on my 2009 Mercury Grand Marquis?


Low Beam, and High Beam both are not working? There is a fuse you can check, review your owners manual for location, also could be headlight switch itself? Please check bulbs before expensive diagnosis...some times both bulbs blow out at the same time:( Hope this helps.

Aug 28, 2014 | Cars & Trucks

1 Answer

Headlights


Yes, all cars have two adjustments per headlight, one screw for up and down and the other for left and right. Any garage will have headlight aimers, Or when you locate the screws you can adjust them by pulling up to a garage door and turning them on.

Jan 29, 2014 | Cars & Trucks

4 Answers

Headlights don't work unless you hold high beams


Check the headlight Relay and/or fuses - should be in the fuse panel.
GL,
Td

Oct 01, 2012 | 2004 Mercury Grand Marquis

1 Answer

2009 mercury grand marquis horn not working


Could be the horn pad, horn relay, fuse, or the horn itself.
I would check the fuse first.

Jul 18, 2012 | 2009 Mercury Grand Marquis

1 Answer

1994 Grand Marquis, marker, tail and dash lights not working. Brake and turn signals work, fuses are all good, checked them all. Worked on passenger side door window, removed door panel, don't think this...


Your light switch is bad. The switch controls what you listed plus headlights,obviously. I've had this problem before. headlights would be on, but nothing else.

Feb 25, 2011 | 1994 Mercury Grand Marquis

3 Answers

How do I change out the Headlight/ Lighting Control Module on my 2005 Mercury Grand Marquis


u can do it your self the lcm is a stand alone unit just unscrew dissconnect and reconnect and screw

Mar 22, 2010 | 2005 Mercury Grand Marquis

Not finding what you are looking for?
2009 Mercury Grand Marquis Logo

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

fordexpert

Level 3 Expert

5520 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...