Question about Cars & Trucks

1 Answer

Hi my 2005 triton v6 has no gears at the stick,even moves in gear like its in nutral

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Cars & Trucks Master
  • 733 Answers

IT SMELLS LIKE NO CLUTCH IS LEFT AND OR BROKEN DRIVE SHAFT.....

Posted on Dec 14, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 14 Answers

SOURCE: Prob's with my Audi A6 2003 Auto 3.0 V6 (gearbox)

Doubt it as the fault suggests you need to look into the range sensor. If similar to Renault there is a switch on the gearbox that senses where the select lever is (at the gearbox end). If the display is wrong then the sensor needs looking at and either it will need to be adjusted into a set position by moving it, or perhaps the connector to it or wiring to/from it have a fault.

Posted on May 08, 2010

tertri
  • 3 Answers

SOURCE: I have a 98 Concorde

You need to check the linkage. Under the car, the section that connects the gear shift stick to the transmission rods.

Posted on Dec 01, 2008

  • 346 Answers

SOURCE: '89 dodge dakota manual transmission A535 will not

Most likely solution is the gear selector fork in the transmission has broken and is no longer engaging the gears.

Repair requires transmission removal and partial overhaul.

Posted on Dec 26, 2009

Testimonial: "good diagnosis. right on the money"

Breed1956
  • 486 Answers

SOURCE: shift stick on saturn wont shift into gear moves

IT SOUNDS LIKE THE LINKAGE IS EITHER UNHOOKED, OR BROKEN! CHECK THERE FIRST!

Posted on Feb 19, 2011

jsmes1027
  • 749 Answers

SOURCE: I just changed my honda

You may need to find out if the transmission has a leak or is a cvt type of transmission.If the vehicle has a cvt transmission and the incorrect fluid type was used can cause major problems.You should contact the facility that performed your service. If the shop that performed your service used the wrong fluid type the liability falls to them for repairs unless you changed fluid because there was an issue already. If it was just maintenance to have serviced the tranny and this is end result definitely contact the repair facility.

Posted on Mar 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi i have a 2005 mitsubishi triton v6 at the gear stick i have no gears it roll like its in nutrel,its a manual box.


You might have lost a bolt from the gear shifting leaver, which holds it to the transmission, when that happens usually it feels like that.

Nov 19, 2014 | Mitsubishi Cars & Trucks

1 Answer

When i press brack gear lever is not moving


might be the break light/nutral shift switch.

May 01, 2014 | 2008 Nissan Almera 1.8

2 Answers

Gear


Master/Slave cylinder issues, check fluid levels of brake fluid reservoir and bleed system where it attaches to the transmission.
Have someone push on the clutch pedal as you watch for movement of the clutch fork where the Slave cylinder attaches to the transmission. If the Fork moves then it is either bent or slipped off the throw-out bearing, the throw-out bearing is seized maybe, the clutch disk itself could be worn or the syncro-mesh teeth inside the transmission are worn from missing gears while shifting.

Apr 21, 2014 | 2005 Toyota Corolla Verso

1 Answer

Can not shift gears in a 1998 crv


a/T or M/t (auto or stick) ????

Nov 30, 2013 | Honda CR-V Cars & Trucks

1 Answer

2002 jeep grand cherokee wont reverse when in gear. hear it get into gear but wont move...


first check fluid is full by starting the engine have it blocked put in in nutral( to fill the bell houseing ) then check fluid level, more than likely you need to add fluid exspecally if your checking it in park with engine on or off park gives you a false reading on the dip stick

Jul 31, 2011 | 2001 Jeep Grand Cherokee

2 Answers

My truck is stuck in nutral and wont go into any gear


Hi Rach,
Do the gears change with the engine off? If they change you have a clutch assembly problem. If the gears refuse when off the problem is with the gearbox.
Regards Johngee10

Mar 09, 2011 | Ford Econoline Cargo Cars & Trucks

2 Answers

Gear link or box problem


Sounds like a piece of linkage came loose. If it were an internal tranny problem, doubtful that the stick would be loose. Examine all linkage for something very obvious.

Oct 07, 2009 | 2005 Volkswagen Microbus

1 Answer

Starts fine, dies when put in gear


since you are under the 2005 mini van column, you have a 3.8l v6 or 3.3l v6, with a 41te trans, Is this a high mileage vehicle, if so, you have a issue with the trans torque convertor locking up when put into drive, there is a valve in the vavle body causing this, its called TCC valve, they tend to stick if the trans has not been serviced at change intervals, only a experinced tech should attempt this, I assume this happens in rev to, even if you give a little of gas pedal before putting in gear,( drive), it still stalls, it is in the vale body. Iv'e seen this happen many times and expensive to fix. there must be a mill light on with a trans code. GOOD LUCK RDJRP

Aug 02, 2009 | 2005 Dodge Caravan

1 Answer

92 toyota camry 5speed


it sounds like you ground the spacers between the gears. have a look under the gear shift. pull the gear shift off then look at the transmission spacers. you will see where the gear shift sits see if some spacers look like the rest.

Mar 04, 2009 | 1992 Toyota Camry V6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...