Question about Cars & Trucks

1 Answer

How do I replaces oil level sensor

Trying diy

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 14,236 Answers

Need to know what kind of ride you have Bud....

Posted on Nov 19, 2014

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: fault code 0562.oil level sensor

You have two sensors that could cause the light to go on. The oil pressure sensor and oil level sensor. Both are easily replaced by someone relatively OK with cars (DIY). You would want to spend the $100 or so and have the dealership do a full diognostic to verify if its truly the sensor and which one. In my case, same problem, and it has been verified that it was the oil level sensor.

Posted on Aug 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil will not fill


i tink you over fill the engine posible need a oil level sensor or wiring dont start the engine you need to remove all oil and 3 to 5 quarts

Oct 15, 2014 | 2008 Hyundai Elantra

1 Answer

Oil level sensor is in the way of the starter.


the wire is clipped in to place.. it should be removeable.. then if the sensor is in the way, it should unscrew out of the block

Mar 04, 2014 | Cars & Trucks

1 Answer

How do i change fuel filter z4


The fuel filter is inside the fuel tank and is part of the fuel pump / fuel level unit. It is not normally replaced as a maintenance item like an air or oil filter unless there is a problem with the fuel supply. This is not an advisable DIY job. The tank must be removed and flushed of contamination, the fuel pump / filter / pressure regulator / level sensor are usually replaced at this time, and this is all dangerous should fuel be spilled or dripped on a hot light bulb.

Oct 27, 2013 | 2003 BMW Z4

1 Answer

Oil level sensor for Hyundai Trajet CRDi 2004?


The will be a oil level sensor located in the side of the engine oil pan under the car, it will likely have one wire going to it, replace it.

Mar 30, 2012 | Cars & Trucks

1 Answer

Code 0521 is the read out. What does it mean? I cannot find it in the catalog.


P0521 error indicates a problem with the oil pressure and/or sensing system Possible causes: Low oil level or motor mechanical fault
Open or short oil level sensor circuit condition
Poor oil level sensor electrical connection
Faulty oil pressure sensor The most likely cause is a faulty oil pressure sensor/switch Locate the sensor/switch and insure the wiring to the switch is in good condition ( CLEAN nad a solid connection) Replace the sensor

Feb 04, 2011 | Chevrolet Impala Cars & Trucks

2 Answers

My '99 Saturn Sedan is showing the red "Low Oil"


have your oil presure checked at a shop

Dec 28, 2010 | 1999 Saturn SL

1 Answer

2003 Dodge Neon Check Oil light wont go off. Car has oil-full, and just put in new Sensor.


Do you mean the oil level sensor was replaced, or do you mean the oil pressure sending unit was replaced?
If it was the oil pressure sensor was replaced, then I would look into an oil pump going bad, not supplying enough pressure to the oil pressure sensor. This can be tested by putting an oil pressure gauge into where the oil pressure sensor normally goes, bypassing the circuitry that leads to the dash light for the oil pressure.

If it was the oil level sensor, then check for bad wiring.

Oct 26, 2010 | 2003 Dodge Neon

3 Answers

I HAVE A ISB CUMMINS ENGINE AND LOW WATER CAME ON AND NO SIGN OF LEAKS , ADDED WATER AND AFTER 400 MILES (MILK) OIL/WATER CAME OUT OF BLOW BY TUBE.. I HAVE A FEELING ITS A BLOWN HEAD GASKET OR A CRACKED...


You may also have an oil cooler bad. Oil pressure 10 to 60 and coolant 15psi. Flex in the cooler can keep oil in but after engines off the coolant psi stays for 10 to 15 min slowly seeping into oil. Check it out. Price....i...don't know but could be about $200 to $!000. DIY new oil filter and lube, 10-15 10mm bolts>>$400

Mar 26, 2009 | 2005 Jaguar XK-Series

3 Answers

Fault code 0562.oil level sensor light on dash display.sensor replaced dash still displaying oil level


I also have a 2004 Audi A4 3.0 Quatro and the low oil sensor comes on periodically. I pull the oil dip stick and put it back and it goes away. Maybe it will work itself out.

Aug 05, 2008 | 2004 Audi A4

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...