Question about 1995 GMC Yukon

1 Answer

Ok the wires are broken on the under carriage of my 95 yukon musta hooked them somewhere but anyways cant find where they go or where they lead to did a little research and it turns out that wires are

Tried lookin where wires lead to and where they go to fix prob>but cant find if they lead to a particular harness and where to from there

Posted by on

  • clayton mandes
    clayton mandes Nov 18, 2014

    wires are oink tan black and ourple

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 2,210 Answers

Where abouts on the underside were the wires hanging down? Auto box, axle lock operation, etc. Try a wiring diagram when you know approx. where and you know the colours already?

Posted on Nov 18, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 28 Answers

SOURCE: radio harness diagram for 95 chevy tahoe....rear

check wiring on passengers side near the rear hatch speaker, the rear door speakers are run through them also. i had the same problem and it was a unplugged connector at that location

Posted on Dec 12, 2010

  • 83 Answers

SOURCE: 2003 Pontiac Sunfire Right Headlights Dim

remove washer bootle assembly connection to main harnes on left side one 10 mm bolt on fram below rad hose remove both head light aasemblys and grill the can remove harness i have seen them break all across harness under tape etc.

Posted on Jan 03, 2009

  • 10865 Answers

SOURCE: 1998 4runner trailer light wiring not working

I recommend that you tighten the ground wire screw for starters. since the vehicle is ten years old corrosion may be the culprit.

Posted on Feb 01, 2009

  • 114 Answers

SOURCE: 95 maxima O2 sensor

Unless you have torches,take it to a garage, if you screw up the threads you are looking at a new pipe, if it is the front sensor it will be ahead of the cat converter,on some models you can open the hood and look down at the exhaust and see it right there.you will also need a speacial socket to remove this or if you are sure,you can cut the wires and use a 7/8" box end wrench.Your car is 14yrs old so don't ecpect it to "turn right out"

Posted on Mar 24, 2009

jyeager178
  • 2 Answers

SOURCE: oxygen sensor 1999 hyundai accent

Bosch website........free

Posted on Mar 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

96 nissan pickup battery ground


It looks as if you have a dead short in the alternator. Check that the insulators around the terminal are not broken or that the fibre washer under the nut that holds the terminal in place (the nut under the lead that allows you to tighten the outside nut up on) is not allowing the wire to touch the alternator housing If that is all ok maybe you need a replacement alternator

Jan 14, 2013 | 1996 Nissan Pickup

1 Answer

95 gmc yukon tailights not working


You can find wiring diagrams at http://www.bbbind.com/free_tsb.html free ! Enter your vehicle info. year , make , model an engine size . Under system click on lighting , subsystem click parking lights . Do the stop lamps work ? Turn signals etc.... Which fuse blows ? Also check fuse box diagram under power distribution ,fuse box .to see what all that fuse powers

Mar 25, 2017 | 1995 GMC Yukon

2 Answers

1999 GMC Yukon, Do I need to replace the stop light switch if my brake lights only come on when I push the pedal real hard to the floor. I have already replaced the brakes and did a new brake booster. Is...


Sounds like you are on the right road with the switch. Before I bought a new switch I would locate the switch, it will come in direct contact with the brake pedal arm, and see if there is an adjustment or if it has moved for some odd reason. Sometimes things just happen.

Jan 28, 2011 | 1999 GMC Yukon

1 Answer

I need to hook up a trailer brake controller on my 2008 GMC Yukon XL where do I find the wiring under the dash to hook up the controller?


Look in your users manual that came with you Yukon. If it has provisions, you should be able to locate this wire harness just below steering column or alittle to the right.(they at least give you room to get in so you dont hit your knees, where they usually mt. it.) Good luck, best regards.

Sep 16, 2010 | 2008 GMC Yukon Xl 4WD

1 Answer

How to set timing 95 yukon 5.7


There is a connector to disconnect . Yes it should be at "0". The connector is near the blower motor above the front passengers feet area. I think its a single wire connector with a tan wire

May 14, 2010 | 1995 GMC Yukon

1 Answer

My heater blower in my 95 yukon doesnt work on low , only on the 2 highest settings, and also doesnt blow hot


THE DIOED IN THE FAN SWITCH IS GONE. CHECK VACUUM LINES IN ENGINE BAY FOR LEAKS OR BROKEN CONNECTIONS ON PASSENGER SIDE, THEY FEED ACTUATORS UNDER DASH THAT CONTROL HEATER FUNCTIONS.OR A VACUUM ACTUATOR COULD HAVE FAILED.

Jan 09, 2010 | 1995 GMC Yukon

2 Answers

95 jetta wont start unless you pop start it i changed the starter i have all the power just when i turn the key nothing


check your fuses under the hood and under the dash
check polarity of battery (if you unhooked booth leads)
is the battery any good?
you probly conected the leads to the starter incorectly (recheck them)

(the following asume your tur n key ignition system is functioning properly)
to test your tur n key system simply hook up a test light to the small lead running to the starter cylynoid "while the wire is disconected" and have a friend turn the ignition over. [dont furget to test the test light first lol]

or even got the wrong starter completly (usaly a store problem)
did you " bench test" the new/used starter befor installing it ?
iv goten brand new starters doa

is the ground strap hooked up ? is there corosian on the battery posts or any of the high amperage conections?

is the cylynoid on the starter or somewhere else under the hood?
cautiously try to bypass the cylynoid ie run a hot wire to the small lead on the cylynoid
(this can usaly be done by jumping from the main red wire on the starter to the hot lead of the cylynoid)

notes: when bypassing the ingnition system (jumping the cylynoid)
DO NOT have the ignition in the on postion and it is best to remove the lead from the cylynoid (incase of a short in the wire's some place)

if nothing remove the large red wire on the cylynoid and touch it directly to the starter lead itself (there will be a fair amount of spark when doing this its normal) but make shur you are conecting to the starter lead and not a gound point as this will cause exsesive sparking that isn't good
dose the starter tur n the engine over
back track untill you find the fault be it starter itself,cyclynoid,wiring,blown fuse,corosion,bad battery,

still cant find the problem take it to a shop!
hope i helped yah

Dec 14, 2009 | 1995 Volkswagen Jetta

1 Answer

Fuel guage is not working on my 95 GMC Yukon it points past the full mark and it started when my fuel pump was replaced.


BINGO ! ! The fuel indicator mechanism is IN the fuel pump assembly (in the gas tank). Apparently the mechanic that did the work did NOT hook up the wiring harness OR the float is jammed. Go back to who ever did the work and COMPLAIN.

Nov 22, 2009 | 1995 GMC Yukon

1 Answer

Reverse lights dont work


follow the wire from the reverse lite and it should lead to the transmission somewhere along that wire you will most likely find that the wire is broken or corroded off. also check the groung wire that it is grounded properly in the reerse lite itself.

Oct 16, 2008 | 1995 Chevrolet Cavalier

Not finding what you are looking for?
1995 GMC Yukon Logo

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...