Question about Cars & Trucks

1 Answer

Blower fan went out for heater where is it located on a 1994 chevy beretta v6 engine

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,665 Answers

It should be under the hood, passenger side rear, do you see it? Sometimes I remove the alternator and alternator bracket, where applicable, in order to get the blower motor out. Just be sure blower motor is the problem, like checking voltage and ground at the blower motor, first.

Posted on Nov 18, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: heater fan not working in 05 Chevy Equinox

I suspect you also checked the fuses, some vehicles are double protected, especially since you usually have to remove the entire dash panel to get to the heater fan blower motor. It should be in the middle or under the glove box, should be located in a plastic box that has like a bell shape to where the motor is. check fuses then check wiring, and make absolutely certain the relay was the correct one that you changed, in a 3 year old vehicle the fan motor should not be bad yet.

Posted on Jan 09, 2009

  • 3 Answers

SOURCE: Changing a fuel filter and fuel pump on 1994 Beretta

the pump is inside the tank and the filter is in front of the tank. you will have to remove the tank to change the pump. get as much gas out of the tank as possible then remove all the hoses to the tank then drop it. have fun

Posted on Mar 07, 2009

  • 366 Answers

SOURCE: Knock sensor location

if its a cmfi or csefi injection system theres 2 knock sensors 1 on each side of engine block,1 under the left bank of block,the other under right bank of block,tbi inj. theres 1 in front of starter.

Posted on May 28, 2009

roniecon
  • 6826 Answers

SOURCE: Changing a blower motor resistor

There is two screws holding it in,unplug the resister,and remove the screws,pull it out,

Posted on Nov 08, 2009

  • 1 Answer

SOURCE: heater blower is not working in 1, 2, 3 and fan

MY 2003 MALIBU AC WORK VERY COOL FOR ABOUT ONE HOUR AND THEN TURN A BIT HOT AND THEN NO AIR COME OUT WHY I HAVE CHECK THE FREON AND ITS OK .

Posted on Dec 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

94 chevy beretta fan system not working


Are you saying the heater blower is not working ?
Have you checked the resistor and the blower motor for power and ground ?

Feb 09, 2013 | 1995 Ford Escort

1 Answer

Location for blower motor/heater/fan fuse?


Before you rip, check the 30A HEATER CIRCUIT BREAKER in the instrument panel fuse panel. The input is hot with the engine running. CB output connects directly to the heater blower motor. A cluster of heater blower motor resistors determines blower speed as selected by the blower switch in the heater control assembly. The switch setting is sent to the powertrain control module (PCM) which acts to turn the blower motor on at the selected speed.

Sep 22, 2012 | 1994 Ford Escort

1 Answer

Location for blower motor fuse on a 1994 ford escort hatch


this isnt the heatercore as it is producing heat and the blower is a fan. the issue could be there is a bad connection to the blower or that the fuse is no longer good.



this site should have what you need:
http://www.books4cars.com/

Sep 22, 2012 | 1994 Ford Escort

1 Answer

Where is the cooling fan relay located on a 94 Chevy Beretta 3.1?


It is located at the rear of the engine compartment behind the right strut tower. Thyere are 3 or 4 relays there in a cluster. The one you want has 4 wires: 2- RED 1- LIGHT BLUE and 1- DARK GREEN.

Both of the RED wires are HOT at all times. They come from fusible link [G] located at the starter solenoid (RUST colored).

The LIGHT BLUE wire goes to the cooling fan. This one should be hot whenever the Powertrain Control Module (PCM) turns the relay on. One of the RED wires provides battery positive voltage to the LIGHT BLUE wire when the PCM grounds the relay primary (coil) circuit to operate the relay.

The DARK GREEN wire is the relay control circuit from the PCM. One of the RED wires feeds battery positive voltage to the relay coil and the PCM controls the relay by providing GROUND for the relay coil. The DARK GREEN wire goes to Connector #2, PIN #2 at the PCM.

May 12, 2012 | 1994 Chevrolet Beretta

1 Answer

How to repalce heater fan blower motor on 85 chevy dooly with a diesel engine


THE HEATER FAN IS LOCATED UNDER THE HOOD ON THE PASSANGER SIDE FIRE WALL. IT SHOULD JUST BE HELD IN WITH FOUR SCREWS AND IT WILL HAVE ITS POWER SUPPLY WIRE CONNECTED. DISCONNECT POWER SUPPLY AND REMOVE THE FOUR SCREWS AND THE FAN SHOULD JUST PULL STRAIT OUT.

Dec 11, 2010 | 1985 Chevrolet Chevy

1 Answer

My heater coil went bad,and i recently bought a new heater coil and it was placed in the truck-1994 chevy blazer s10 4 door,vortex engine,the problem is now,that the blower is not working or the fan,and no...


I ASSUME you replaced the heater CORE? You need to find the ticking noise in front, just turn key on, turn blower on, and find out where its coming from. It cant catch fire, not from that anyhow. The radiator releases the heat from the engine, you are using a fraction of that heat for the cab of the truck. Rap on the blower motor and see if it starts to run, if so, replace it. Check the fuse.

Dec 06, 2010 | 1994 Chevrolet S-10 Blazer

1 Answer

The heater fan stopped working and I want to know how to get to it is it under the hood or under the dash for a 1994 chevy cavalier


The blower motor is located under the hood in the engine compartment on the rightside on the firewall, also check the blower resistor this goes bad often and it will also stop the fan from working, test the blower, hook it to power and a ground if it turns on then its the resistor. hope this helps.

Sep 21, 2010 | 1994 Chevrolet Cavalier

1 Answer

1997 Chevy S10 pickup Fan switch for heater runs on high only.


replace the blower motor resistor located on the heater box were the blower motor is located the wiring to the blower may go to it. This is very easy to locate if you buy the part first.

Jan 06, 2010 | 1997 Chevrolet S-10 Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...