Question about Cars & Trucks

1 Answer

If i have a block heater20003lincoln navigator wear do i plug in

Wear would I plug ablock heater in on the engine wear is it locaed 20003 Lincoln navigator

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

If you have the heater check for it in front of radiator coiled up on passenger side near bumper just under it

Posted on Nov 18, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76673 Answers

SOURCE: HOW TO REMOVE A HEATER CORE IN A 2003 LINCOLN NAVIGATOR

U must remove the entire dash assembly and then the heater core housing which is part of the air distribution box, time to do the job 10-15 hours.

Posted on Dec 01, 2008

chuck943
  • 783 Answers

SOURCE: where are the plugs on lincoln navigator 1998

They are under the coil packs. You will need an 8mm socket to remove the bolt on each coil pack then remove them to access spark plugs.

Posted on Feb 25, 2009

  • 155 Answers

SOURCE: 2004 Lincoln navigator misfire on cylinder 8 error code p318

Replace the coil pack once more. I went through 2 new ones on my f150 on one cylinder. One worked, the other didn't (both new off the shelf). Condensation build up in the boot caused mine to misfire. Anytime you replace a coil pack, squirt a little silicone grease inside. This will prevent condensation from hitting your plug. Fords are notorius for this problem, especially if you live in a humid area. Also, make sure and clear the codes after you make the repair.

Posted on Jun 10, 2009

  • 382 Answers

SOURCE: bad heater core on my 2001 lincoln navigator

This is definitely not a job for the at home mechanic. the dash will probably have to come out and this is a very time consuming and laborious task. I would recommend you find a job that you can trust, or get several estimates on the work before you decide who to let do the work. I would expect something like this to run at least $700.00 to $1000.00

Posted on Dec 08, 2009

  • 14 Answers

SOURCE: 2005 lincoln navigator 5.4 32 valves the engine

check the fuel cut off switch in the back on the left close to the back door

Posted on Jul 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Could freeze plugs cause my Lincoln navigator 5.4l engaging leak water from back of engine and oil from the side of engine


Yes, that is a possibility. I have a 4-liter V-6 in my 1993 Ford and it had two freeze plugs that had rusted and were leaking. It was easy enough to replace them because they were on the side of the block but I learned there are two freeze plugs hidden under the transmission bell housing. It they are leaking, antifreeze would be dripping off the back of the engine.

Freeze plugs should not cause oil leaks as they are a safety device for the water jacket.

Mar 09, 2015 | Lincoln Cars & Trucks

1 Answer

What do the heater hose to for a 2003 Lincoln navigator


The heater hoses let the hot coolant from the engines cooling system enter the heater core via the heater control valve in order for your vehicle to have heat!!!!

Oct 20, 2014 | 2003 Lincoln Navigator

1 Answer

Where is the engine block heater plug-in on 2008 Navigator


-Are you talking about diesel engine...? If so. Check with its manual.

Good luck

Mai

Mar 02, 2014 | 2008 Lincoln Navigator

1 Answer

Where is the block heater location on a 2005 Lincoln LS ?


It is on the side of the block you will need to jack the car up and look for the freeze plug that has the block heated connected to it.

Jan 21, 2012 | 2005 Lincoln LS

1 Answer

My 1990 k1500 with a 5.7 V8 is froze up and it has a cord for ablock heater but its not plugged into anything, its jus rolled up and strapped down, and i have been trying to find the location of the block...


One end of the power cord you found has a common plug that gets plugged into an extension cord to normal house power. You need to trace the other end back to the engine. The block heater is installed in one of the freeze plug holes in the side of the block. If you find the end of the wire goes nowhere and don't see a heater installed, likely at some point the one that was there failed and was replaced with a normal freeze plug. You'd then need to install a new one (may be tricky if the water in the block is frozen though) Do not attempt to start a frozen engine as any water in the water pump can damage the pump impeller if you try to turn it. Your best bet at thawing it out is either to tow it somewhere that is warm or build a tent over it with a large tarp and use electric room heaters to warm it. (keep heaters away from tarp and make sure there are no fuel leaks) It takes several hours to warm it so be patient.
Good luck

Dec 28, 2010 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

I have a 1999 Lincoln Navigator. The heater blows cold unless I have the engine revved up . . . any ideas ?


do you have the proper amount of antifreeze in vehicle not over full if so your thermostat is bad

Dec 13, 2010 | 1999 Lincoln Navigator

1 Answer

1999 Lincoln Navigator stops blowing hot air


Since your blower is working and it is a heat issue,thats where we'll start,First thing is have you checked the coolant level in the radiator when engine is cold,make sure it is filled to top,next verify you have coolant in reserve ,Start your van and get it up to normal operation temperature,If your heat gauge on the dash works correctly it should be 190 degrees,Now lift the hood and locate the two heater hoses going into the heater assembly at the fire wall,Both hoses should be hot to hold on to,if both are hot and no heat inside your problem will be the blend air door in heater assembly.
if neither hose is that hot you need to replace the thermostat in the engine to get it up to 195 degrees.
if one hose is hot and one is luke warm then the heater core is blocked and to blame. hope this helps you.

Jan 01, 2010 | 1999 Lincoln Navigator

1 Answer

Where is the ac condensate hose on a lincoln


IF YOU MEAN THE DRAIN FOR THE HEATER BOX.
LOW ON FIRE WALL RIGHT OF THE ENGINE .

Nov 26, 2009 | 2000 Lincoln Navigator

1 Answer

HOW TO REMOVE A HEATER CORE IN A 2003 LINCOLN NAVIGATOR


U must remove the entire dash assembly and then the heater core housing which is part of the air distribution box, time to do the job 10-15 hours.

Nov 24, 2008 | 2003 Lincoln Navigator

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...