Question about Ford E-Series Van

1 Answer

Where is horn relay in 1998 ford econovan

Can't find the horn relay horn not working fuses test ok

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 38 Answers

I'm sure it'd be hard to find...
You could try asking for help from a Ford dealer.

Posted on Nov 19, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 200 Answers

SOURCE: 1986 toyota pickup horn malfunction

hi

Check whether power is coming to horn.

if ok means then check the horn

thank you

Posted on Oct 22, 2008

jagjeffery
  • 318 Answers

SOURCE: need to find the horn relay in a 1993 ford mustang

the horn relay is above the inside fuse box center of car i am sending you a pitcher in the next message

Posted on May 29, 2009

cj2176
  • 520 Answers

SOURCE: where is the horn located on a 1998 ford explorer

The horn is usually between the radiator and grill Assembly. The fuse is in fuse panel under the dash on the drivers side. Look at the lid and it shows the fuse placement and there use.

Posted on Jun 12, 2009

MNfisherman
  • 11896 Answers

SOURCE: 2000 mercury grand marquis horn doesn't work.

The horn is in the very front behind the grille on the drivers side. Eiher the horn is bad or disconnected or the switch in the steering wheel is bad.

Posted on Nov 10, 2010

Testimonial: "Thank you. I asssumed that the problem was between the relay socket and the horn. You told me the horn location and I found the cable unplugged."

c1apton15
  • 3400 Answers

SOURCE: howto replace the horn on my 2003 ford focus fuse

Your horns are behind the grill and can be a chore to get at. Before you dig into that, you know that clicking you hear? Find the box that's clicking - that's your horn relay. Try replacing that first before ripping your grill out.

Posted on Jan 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Horn quit working need to find out where it is located under the hood of a 1998 ford windstar. Does not toot any more


There is more involved then just the horns ! Fuse , horn relay in the I/P fuse box , clock spring located under the steering wheel . Is the air bag light lit on the instrument cluster ? If so the clock spring is probably the issue . The way to find out what the problem is by testing the electrical circuit . VEHICLE RELAYS Operation Diagnosis

Oct 30, 2016 | Ford Cars & Trucks

1 Answer

Sorry i forgot to mention with the lights only working on high beam it's a ford econovan maxi auto 94 do you think its a fuse?


could be the switch stalk if also no dash board lights. Check if voltage going to relay with volt meter or 12V light probe
you can pull out relay and check terminals or jump wire to do relay function to test fuse and globe. A determine if swich is faulty


25785300-5toaxnpomibennkke0mqwyu0-2-0.jpg

Jul 16, 2015 | Ford Cars & Trucks

2 Answers

Which fuses do I need to check? My 1996 Ford ranger horn is not working


Most times it is the spring and assembly in the steering wheel that is bad.

Jan 09, 2015 | Ford Cars & Trucks

2 Answers

1998ford explorer horn doesnt work


If the fuse is OK, check if you have power at the horn, if yes, replace the horn, if not check the switch or wire. make sure you have a good ground too.

Mar 21, 2013 | 1998 Ford Explorer

2 Answers

My horn is not working but the alarm go' s off and it works....


you need a test light .connect the clamp end to the battery positive post . then remove the horn relay .prob pin 86. have some hold the horn button down .it should light if the circuit is ok. if not then remove the 4 or 2 bolts that hold the air bag to the steering wheel .do not unplug or appliy power to the yellow connector it will deploy the air bag. you should see the two black wires to the horn buttons. with a ohm.meter mesure the one that gose to the clock spring assembley.it should be open untill you press the horn button then it should short to ground. if it dose the clock spring is bad. but you will want to test it first.sgm1115_48.png

May 03, 2011 | 1998 Ford Expedition

1 Answer

My horn stopped working on my 1998 Explorer. Is there two fuses box


There is One under hood and one under dash.Check owners manual under fuses.If fuse is ok it could be horn relay or horn itself bad.If you disconect horn and put a test lamp on horn wire,have someone blow the horn if test lamp. lights up ,horn is bad

Nov 23, 2010 | 1998 Ford Explorer

2 Answers

2005 ford taurus horn just doesn't work. I've


The problem can be with the horn pad, the horn relay or the horn itself. Find your horn relay, it should be in the engine compartment fuse box. Remove the relay and test for power at the legs. there should be two legs that have power. If there is power there, take the cover off the relay and plug it back in. Squeez the relay points together and see if the horn works. If the horn still does not work, it is probably the horn itself. If it does work it is probably the horn pad, but you don't want to mess with that because of the air bag. Let a pro do it.

All of this is predicated on the fact that you have checked all the fuses.

Hope this helps
Rich

Aug 18, 2009 | 2005 Ford Taurus

1 Answer

Mercedes ML 320 1998. My horn does not work


About four things to do, first check voltage at horn with key on and button pressed. If voltage there try moving the small gap screw back and fourth a few times. If that doen't work replace horn. If no voltage check fuse and horn relay, you should be able to hear the relay click when you push the horn button, If not and fuse is ok. Switch relay out with another on on the car. If that doesn't fix it check the horn button for continuity.

Dec 27, 2008 | 1998 Mercedes-Benz M-Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...