Question about Cars & Trucks

1 Answer

Speedo meter on my wrf 250 has stopped working

Hi, could you help I've had the headlight shroud off an looked AT the plugs they seem tight enough but it still won't work, help please

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Cars & Trucks Expert
  • 473 Answers

Sounds like a problem with the cable

Posted on Nov 20, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

alicantecoli
  • 22156 Answers

SOURCE: speedo and milage counter

new unit complete

Posted on Dec 20, 2008

  • 26 Answers

SOURCE: 1999 vw passat 2.8 v6 speedo not working. trip

most of the older cars have a cable driven speedo but newer cars are elecitronic it could be the little motor behined the gages or the wiring going down to the tranny check the cheepest first

Posted on Jul 13, 2009

  • 30 Answers

SOURCE: 1999 996 carrera speedo and tach does not work(analog and digital

maybe the speedo drive has stripped some teeth. good luck!

Posted on Jul 28, 2009

  • 4 Answers

SOURCE: I have a 1993 F-250 4x4 speedo stopped working and

Hi I just thought you might like to know that the VSS sensor(vehical speed sensor) on a 93 f250 is actually on the top center of the rear differential. It is basically a proximity type sensor not the old school gear and cable. It will take a 1/2" or 13mm wrench I believe to remove the single bolt holding it in and the it pulls out. I think they are around 25 bucks so it's cheap enough to fix the speed sensor.

Posted on May 06, 2010

Molson02536
  • 3854 Answers

SOURCE: 1995 chevy suburban headlights won't come on

Common for the wire harness on the switch to go bad. Inspect the wire harness where it clips on to the switch and look for any signs of damage.

The plastic heats up from the current running through the switch and causes it to melt and then you loose connection caused from melted plastic between the contacts from the harness to the switch.

There is a upgrade to the headlight harness which is larger then the ones that came with the Suburban to address this issues. You can get them at the dealer or NAPA i believe.

Good luck and keep us posted. Thank you for using fixya and stay safe.

Molson02536

Posted on Nov 03, 2011

Testimonial: "I replaced the turn signal switch which solved the problem. It was that. The headlight wires had melted at the connector. The pain is the new turn signal switch has a malfunctioning wiper component causing the wiper delay to turn on with out being on. Now I have to do it all over. "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1987 Nissan pickup. With no headlights plugged in, I get 12 volts of power to the headlight plugs. As soon as I plug headlights in, I get no power on the volt-meter.


Are the headlights working ? If so they would pull current thru the switch and leave nothing for the meter.
If not you could have a weak connection between the headlight switch and the source of power, including inside the switch. The connection could be good enough to power the meter but not good enough to power the lights.

Sep 29, 2013 | 1987 Nissan Pickup

1 Answer

I have a 2002 Neon (MTX), My speedo died, I troubleshooted all the way down to the ******, replaced the speedo drive gear and a bearing. Filled ****** with fluid, started car after all engine components...


Try a bigger battery or a battery charger.swap it to give enough power to start the engine. If that doesnt work than try checking the starter solenoid at your local auto store

Nov 11, 2012 | 2002 Dodge Neon

1 Answer

Headlights wont come on


if fuse under hood has blown there will be one in main fuse box that has blown as well fuses can look good but are bad need a comunity tester or multy meter to check connection

Aug 12, 2012 | 1997 Dodge Ram 1500 Club Cab

1 Answer

I have a 99 plymouth voyager se 3.3 I just bought it & upon driving it awhile I began to notice that it shifts hard into 4th from 3rd depending on my aceleration & sometimes slams down into 1st...


check the transmition speed sensor take out and clean up all metal pices add on the sensor put this back and check the two drive shaftmake sure bot are all way in and loock if the car donot change anything check the speed sensor with one omh-meter conect the meter terminal on each pin of the sensor conector and pass a pice of metal up and down on the magnect side of the sensor you need see chages on the meterif donot dueany change put a new sensor

Jul 22, 2012 | Cars & Trucks

2 Answers

My bmw 316i 1996 2door has accelaeration problems. when accelerating at approx 60-70mph slight slugishness for approx 0.05 sec every 3-4 sec, ive changed the airflow pipe from engine to mass meter and aso...


Hi

I am assuming your old air flow pipe was ripped ? If that was the case it can often damage the air mass sensor / meter, they are quite delicate on these cars. the other alternative would be the throttle control module although these raely go, do all the air pipes have a good tight seal around them? any air leaks will cause the car to be sluggish.

Hope this helps, as regard to the clocks not showing mileage is the back light lit up?

Rergards
Dan

Jan 04, 2011 | 1994 BMW 3 Series

3 Answers

How easy is it to change the front left headlight on a 2004 Elantra . My knowledge maxs out at checking the oil.


  1. There is a shroud that has 3 push pins at the front and a 10 mm bolt at the rear that attaches to the top of the air cleaner box. Remove the bolt and the push pins, lift the shroud up and set it out of the way.
  2. There are 2 10 mm bolts at the top of the headlamp assembly and one at the bottom that you can see looking down between the radiator support and the battery. Remove the bolts. Now grab the assembly and carefully wiggle it forward as it will be a snug fit between the fender and bumper cover. Unplug the electrical connectors.
  3. Now you have the assembly free where you can move it around and actually see what you are doing! Turn the caps on the back of the headlamp counterclockwise until they stop and pull straight out. Now you should see the bulbs inside. Gently pull on the connector on the bulb to unplug it. Look at the retaining clip holding the bulb in its seat, note exactly how it is positioned, then unclip it from its holder and swing it out of the way. Pull the bulb out of the assembly.
  4. To install the bulbs, hold the bulb and put it back into the assembly, making sure to align the keyway on the bulb properly. Resecure the retaining clip and reconnect the bulb connector. Reinstall the caps by pushing in and turning clockwise until they stop.
  5. Now you are reversing the previous steps. Reconnect the assembly connectors, slide the assembly back into place and reinstall the 3 bolts, taking care not to overtighten them. We do not want to bust the plastic mounting tabs. Put the shroud back into place, and reinstall the push pins and bolt. Now turn on the headlamps, and check to make sure all lights are working.

Oct 16, 2009 | 2004 Hyundai Elantra

2 Answers

My speedometer works sometimes and sometimes it doesnt but the heat one works and gas one works what is causing this?


hi every car has a speedo meter cable in tat a worm gear attached in the wheel so i case of fails the speedo meter works some time and nt work . so u hav to change the speedo meter warm gear

Aug 25, 2009 | 1998 Dodge Neon

1 Answer

2006 Ford F250 Diesel


check the fuse for the speedo, (fuse #35 interior fuse box) if it is ok the electronic speedo will need repair, this is a common problem since Ford went to electronic speedometers.

Jan 06, 2009 | 2005 Ford F 250 Super Duty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...