Question about 2005 Hyundai Matrix 1.6

Open Question

How to remove the panel that has the engine management lights on

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace check engine light bulb on a 2002 toyota landcruiser


Hello Susan,

Your check engine light is located in your vehicles dash cluster and will only illuminate when a fault is detected..no detected faults..no light, although it should illuminate (to prove it is working) for a short period of time at each engine start up.

If your light does not confirm operation during the start cycle, explore for access to the lights wiring connector behind the instrument panel cluster to see if you can easily remove the lamp from the cluster...sometimes it it easier to remove the dash trim bezels and remove the cluster from the dash to change lamps.

Of course your Toyota's engine management systems are controlled by an computer generally referred to as a ECM (engine control unit (ECU), also commonly called an engine control module) so if your lamp fails to illuminate during the start cycle the problem may not be due to a simple lamp failure.

Jan 27, 2018 | Toyota Land Cruiser Cars & Trucks

1 Answer

How do I turn off engine management warning light without taking it to a garage ?


Normally you would remove the fuse supplying power to the car's computer, for 30 seconds. However the light will just come back on again, because the computer is sensing a problem and trying to tell you.

Sep 01, 2014 | Cars & Trucks

1 Answer

How to remove mysearchdail tool bar


Use the settings menu in your browser. Look under manage search engines and delete the my search dial engine. Then go into add and remove programmes in the computers control panel and uninstall it from there to. Hope this helps.

Feb 03, 2014 | Cars & Trucks

1 Answer

Engine light is not switching off while driving


Run fault codes to find out what put the engine light on. Replace or repair asap as it is telling you that something serious has happened to the engine management systems. Check oil level and coolant level at the radiator. To ignore a warning light is an invitation to expensive disaster.

Nov 06, 2013 | 2008 Dodge Grand Caravan

2 Answers

Engine management light flashing and power in limp mode


i am sick off my sprinter shuting down on motarways. What can i do to remove engine management

Jan 23, 2013 | 2010 Mercedes-Benz Sprinter Cargo

1 Answer

Engine management light stays on


check whether you do have a smell of fuel or burnt gasket in the radiator after remove the cap. If so then you have an overheated engine and blown gasket. Or check whether if you have either water in engine oil or vice versa. Having any of the two,surely you have to remove cylinder head for renewing cylinder head gasket etc.

Oct 15, 2012 | 2001 Ford Focus

1 Answer

While trying to fix a brake light issue, I was instructed to replug in a connection somewhere in the steering column. After removing two panels on the front dash, and two panels on the column, I still...


if you have removed the bottom of ignition switch ,this has all the contacts in it for ignition lights and as you turn key more sends power to starter .you will find your just a notch out on refitting hence not starting .try turning it sligtly you will find should be something there to line it up

Sep 08, 2011 | 1987 Ford F 150

1 Answer

Cutting off for no reason and check engine light stays on


Have it checked as the engine management light will not stay on for no reason, must be a problem with the motor or computer. Is there any error codes showing on the dash display panel ?

Sep 21, 2010 | 2000 Oldsmobile Alero

2 Answers

How do I clear engine management light


Remove battery cable for a minute, then put it back on. The light will go out.

If there is a fault in the system that hasn't been repaired properly, the light will eventually come back on. Fixing the problem is usually the best solution.

Aug 20, 2010 | 2001 Ford Focus

3 Answers

Engine management light stays on


I HAVE A JAG XTYPE 2.0 V6 SPORT, HAVE THE SAME PROBLEM THE ENGINE MANAGEMENT LIGHT CAME ON AFTER A HARSH GEAR CHANGE (WHEN THE CLUTCH IS NOT FULLY PRESSED), HAD THE FAULT READ AND WAS ADVISED THE GEAR SENSOR HAD TRIGGERED AS THERE WAS A HARSH GEAR CHANGE, HAD THE CODES ALL READ AND CLEARED NOW THE LIGHT COMES ON INTERMITANTLY, AND GOES AWAY AFTER A COUPLE OF HOURS, I BELIEVE THIS A COMMON FAULT WITH JAGS SADLY THE ONLY THING YOU CAN DO IS EITHER LIVE WITH IT OR REMOVE THE BULB FROM THE INSTRUMENT PANEL.

Feb 18, 2010 | 2002 Jaguar X-Type

Not finding what you are looking for?
2005 Hyundai Matrix 1.6 Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...