Question about Cars & Trucks

1 Answer

Inline 6 when warms up check engine light comes on runs for 5 min r so then dies. After it dies won't crank just turns over an over

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Cars & Trucks Expert
  • 166 Answers

What brand and year inline 6?

Posted on Nov 17, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

tommyboinow
  • 324 Answers

SOURCE: Hard to start warm engine

Sounds like you have a problem with your fuel injectors, either they are working to much or not enough once they get warm....

Take it to a shop ant tell them you want the injectors tested.

Posted on Nov 26, 2008

Scorpedo
  • 111 Answers

SOURCE: car dies when driving,check engine light comes on.

There is a good chance it could be your fuel pump , however if the check engine light is coming on and the dealer cant tell you what is wrong , try a different dealer or another shop. Second opinions never hurt.

Posted on Dec 12, 2008

  • 1 Answer

SOURCE: 04 Dodge 3500 w/ 5.9 cummins difficult starting

sound like the lift pump!

Posted on Mar 09, 2009

cadman000
  • 607 Answers

SOURCE: 1990 Buick Century 3.3L Check Engine Light comes on, stalls.

Need to check for fault codes. Possibly a faulty sensor causing the fuel system to run rich or lean.

Posted on Mar 27, 2009

Molson02536
  • 3854 Answers

SOURCE: Engine will die

There is a Communication problem between the Transmission Control Module (TCM) and the Engine control module. That is the bad news and is why it's shutting down the engine. 
The good news is i believe there is a TSB recall on the 2004 - 2007 chevy aveo for the P0700 problem so it should be covered under warranty. 
Believe the TSB# 05-06-01-030D
Good luck and hope this helps and hope it's not a bad ECM. Check the wire harness to the ECM and TCM, look for broken wire or the harness it self gone apart. 

Posted on May 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause my 98 Tahoe to spit and putter then die but 10 mins later crank up just fine?


Hanna, is engine light on, do you have any codes, all this info would be of help.
My guess is moisture in the distributors system, under cap, cracked wires, etc. the moisture dissipates as engine warms, thus is why will run fine 10 min. later.
take to a good tech. and he will check for codes and repair.
check the link below, press the helpful button

Misfire Diagnostics P0300 GM

Jan 31, 2016 | Cars & Trucks

2 Answers

91 geo metro won't turn over, lights come on, starter doesnt engage


Hi Teresa thats ththhe sign of a battery going bad, how old is the battery? You might want to have it load tested so you can trouble shoot further, there could be more than 1 issue.

Dec 19, 2015 | 1991 Geo Metro

1 Answer

1995 ford 4.9 stright 6 runs for a couple min then dies


The parts you replaced don't typically fail due to heat/cold cycles.You need to see if it might be the ignition coil.Make the coil easily accessable(take of the engine cover).Have a 12v test light and some sort of spark tester handy.Start the engine,let it run until it quits.See if you have spark at the coil.If not, unplug the low voltage connector on the coil,and put the test light across the connector,and crank the engine.The light should flash on and off.If it does,replace the ignition coil. If it doesn't flash,you may have a bad crank sensor,but this usually won't make it shut off,instead,it will cause it not to restart after heat soaking for a couple minutes.(I'm betting on the igniton coil).

Oct 26, 2012 | 1995 Ford Econoline

1 Answer

I have a 1991 dodge ram250 van. When the engine warms up, it dies and the oil light comes on. When I check the oil, it is full. What it is the issue, and how do I correct it?


Anytime and engine dies, or is off, while the ignition key is still in the "run" position then the oil warning light should come on since there isn't any actual oil pressure in an engine that isn't running...so I dont think you have any problems related to that. What you'll need to know to diagnose this problem is if after the engine stalls if it is capable of making spark for the plugs when being cranked over. If it won't produce any spark while cranking then I would suspect the Hall Effect pick-up unit located inside/under the distributor cap as they are somewhat prone to failure and often will quit working when warm but will start working again after they have cooled off a bit. If you have spark when trying to restart the engine then its possible you have a fuel related problem such as a weak or failing fuel pump. Good luck, hope this helps a bit!

Apr 08, 2011 | 1992 Dodge Ram 250

1 Answer

1996 jeep cherokee country i have fuel and spark engine turns over but still will not start.at one point i crank it for the longest time it started i warm it up then the next day it did the same thing...


When the jeep is cold, turn the key to the on position, without cranking the engine, to see if the check engine light is lit up, on the dashboard. If it is not lit up then the ecu is going bad, slowly dying. If no check engine light is on, leave the ignition turned to the on position for a while(may take up to 30 mins) and the check engine light should then come on and the jeep should start. If this turns out to be the problem with your jeep, then your ecu is in need of repair.

Feb 17, 2011 | 1996 Jeep Cherokee Country

1 Answer

I HAVE A 1998 DODGE CUMMINGS ENGINE. WHEN I START THE ENGINE IT TURNS OVER AND STARTS BUT THE ENGINE JUST LOPES FOR 5 TO 10 SECONDS AND THEN DIES. IF YOU DO THIS FOR ABOUT 5 MIN AND KEEP TRYING TO START...


have u had the fuel filter replaced. that or the pressre regulator. theres a check valve in every fuel system. in cummins semi engins its in the filter or in the pump. if u loose prime over night it will die from the air in the lines. can be bad on ur starter doing this alot. check ur fuel lines to see if any have come loose. also is the check engine light on. fiding a troble code can be helpfull

Nov 17, 2010 | Dodge Ram 3500 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...