Question about 2004 Nissan XTerra
My daughter rolled her SUV swerving to miss a deer and broke off the driver side mirror and crumbled driver side of truck, no shattered windows or injuries thank God. I know I need to remove door panel and connect wires to mirror properly etc. Will I need a drill or any other power equipment?
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
hey juan...if you're not familiar w/ it, which seems evident, its good that ya didnt tear into it anyways. is it fixed yet? it should be by now! eric dude
Posted on Oct 08, 2008
Quite possibly yes...I would first check any relays and/or fuses just in case. A few dollars for a fuse or relay is much cheeper than say $100.00 and a few hours of labor.
You can purchase just the window motors from any major auto parts stores. You can also purchase the window motor with the regulator. The regulator is kind of like a rope and pulley system to lift the window up and down and the motor is attached to this assembly. It is a little more expensive but I would change both. I always change both just in case the regulator is bad and it isn't the motor. You will have to remove the plastic interior of the door in order to change either the motor or the motor/regulator assembly.
Any questions, feel free to ask!
Posted on Feb 04, 2009
This is out of my haynes manual
1 disconnect negative battery cable
2 on manual window equipped modesl remove the window crank using a hooked tool to remove the retainer clip.
3 on power window equipped models pry out the armrest switch control plate and disconnect the electrical connections
4 detach the armrest pull handle retaining screw then remove the inside door handle trim bezel
5 insert a wide putty knife, a thin screwdriver or a special trim panel removal tool between the trim panel and the head of the retaining clip to disengage the door panel retaining clips.then remove the remaining door panel retaining screws at the lower edge of the door panel.
6 once all of the clips are screws are disengage detach the trim panel disconnect any electrical connectors and remoe the trim panel from the vehicle by gently pulling it up and out.
7 for access to the inner door remove the door panel support bracket then peel back the watershield taking care not to tear it. it install the trim panel first press the watershield back into place. if necessary add more sealant to hold it in place.
8 installation is the reverse of removal
Posted on Mar 20, 2009
Tips for a great answer:
Aug 05, 2017 | 2010 Nissan Xterra
Nov 15, 2012 | 2008 Nissan Xterra S
Jun 20, 2012 | 2004 Nissan XTerra
Jun 06, 2010 | 2004 Nissan XTerra
May 13, 2009 | 2004 Hyundai Elantra
Dec 07, 2008 | 2002 Nissan Xterra
Nov 06, 2008 | 2004 Nissan XTerra
145 people viewed this question
Usually answered in minutes!