Tried programing and extra remote and the ariginal remote will start the pickup although it dies after starting
SOURCE: 1999 NISSAN ALTIMA KEYLESS REMOTE PROGRAMMING
1999-2003
Enter vehicle, close and lock all doors.
slowly insert and remove key from ignition 6 times within 10 seconds. The tail lamps will flash to indicate original code has been erased. Turn ignition to the ACC position.
Press any button on 1st transmitter.
Hazard lamps will flash to confirm programming.
TO enter additional transmitters, unlock then lock the doors using the power lock switch located on the driver door.
Press any button on additional transmitter (up to 4 tansmitters total possible). Hazard lamps will flash to confirm programming.
open the driver's door.
Turn ignition off.
You must re-program all existing transmitters as this process erases codes from car.
SOURCE: program a keyless enrty remote start 2004 chevy malibu
Dealer only If you find a different means let me know
SOURCE: 2004 Toyota Camry key fob programation
sit in car all doors closed put key in ignition and turn from OFF to ACC 3 times as fast as you can leaving it in ACC on the last cycle then press your remote button. your blinkers should flash to tell you this has worked.... may take you a couple of tries to get it!!
SOURCE: program a new fob to my 2002 f150 supercrew lariat
if it is a ford remote or ford factory alarm remote cycle the key from off to run(usually 8 times) untill you hear door locks activate. at this exact time key needs to be in the on position.touch unlock or lock on all remotes being programmed and make sure door locks respond to remotes. then turn key off ending programming mode.then try your fobs they should work
SOURCE: I tried the program instructions for my keyless
Here's what I found. Go to this page and select 2006 Grand Prix - http://www.programyourremote.com/classified/Browse.asp?cid=273
You can't program I guess, sorry
583 views
Usually answered in minutes!
×