The fuel pump is not getting any power
SOURCE: need location of fuel pump relay
This relay will be in the Power Distribution Center under the hood in the engine bay. Thanks for using fixya!
Sincerely,
jC
SOURCE: Ford Escort 1998 fuel pump not working.
good old ford lol, try looking at the crank sensor its located at the front of the engine tucked in right hand side of exhaust manifold and gearbox, two pin plug, i have also known these to have no end of faults with the fusebox.
easy to remove, and solder the connections inside they all suffer eventually, if your not to handy with cars i recommend taking to a auto electrician, easy if you know how. Good luck Davelee
SOURCE: no power at fuel pump chev.S-10 looking for fuel pump relay and fuse
The fuel pump relay is located Under hood, driver side, upper firewall, mounted in
relay block.
The fuse is located under the instrument panel to the left of the steering column.
The fuse block should be visible from underneath the steering column,
near the pedal bracket. If the panel is not visible, check for a
removable compartment door or trim panel which may be used on later
models to hide the block.
SOURCE: Fuel pump relay location 1997 celica
The relay and fuse is located under the hood in the relay box. It will be labeled on the lid. If fuse is good, then test the relay. Pull it out and with a test light see if there is power. If there is then remember that one. Have some one turn the key on and find another power wire. There should be 2 powers.If there is only one power then there maybe a problem in the ignition switch. If there is 2 powers then you need to get to the top of the fuel tank and see if power is getting to the pump. The power at the pump will be there for only a few seconds once the key is turned on and then will drop off. Let us know how it goes.
SOURCE: where is the fuel pump relay located on a 1998
Passenger compartment relay box next the ECM
you will see 5 relay
2 to the left & 1 in the middle & 2 to the right
The one in the middle is the fuel pump relay
MPI CONTROL RELAY AND FUEL PUMP
RELAY CONTINUITY CHECK
UNDO THE RELAY CONNECTOR
1) Without Battery Voltage: check continuity between connector terminals 2 & 4
2) With Battery Voltage: connect 12v battery power to connector terminals 2 (-) & 4 (+) . Then, check continuity between connector terminals 1 & 3. Refer to diagram below:
If the relay connector does not measure the correct continuity, then replace the relay.
Cheers,
"If this solution has helped you resolve your problem, please be kind enough to leave a testimonial"
66 views
Usually answered in minutes!
×