Question about Cars & Trucks

1 Answer

I have a D5805 STARTER-UP 400 Jump Starter and need instructions for it. where can I get them.

Portable jump/charge starter that can be used to jump start a car or charge a battery

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Cars & Trucks Master
  • 881 Answers

You can buy one at any good car sale shop and make sure you
read all the instructions before useing it as jump starting is always fit red [POS] cable to both cars or batterys first and then fit the black cable lead last,when finished remove the Earth lead [black]First with car doing the charging turned off.
When charging car to car let engine run for approx 4 minutes at 800 rpm then let it idle for 2 minutes before starting the second car

Posted on Nov 16, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 22 Answers

SOURCE: 06 pontiac grand prix wont start no clicking when you turn the key over even jump starting the battery, has dash lights & radio & parking lights. battery tested good. put a used starter & altinator on

Used parts such as starters and altinators don't last. It might **** but it sounds like you need to buy a new starter,altinator, and battery. Or just start with buying one at a time.

Posted on Dec 06, 2011

Testimonial: "kellertech1?? i tried something new.. my batt. was dead after sitting for 5hrs so i jumped it & later unhooked the batt. & hooked the batt. back up next day & car started ok kinda a weak start but started. so can a starter drain a batt or where should i look for a short or could this be a weak batt. that tested good but 2 weak 2 start the car."

  • 88 Answers

SOURCE: rover 400 battery

NOTORIOUS// replace the ignition switch and you'll be fine. switch is still live when you take your key out. there's a short from the switch to the battery.

Posted on Dec 23, 2008

  • 196 Answers

SOURCE: starter motor not turning car

If you can get to the starter have some one hold the key in the start position and tap on the starter with a hammer if it starts get to a shop and have it replaced.

Posted on Jan 11, 2009

GM Elec
  • 1000 Answers

SOURCE: car will not start

For clarification:
When you turn the key to start, the engine will not roll over?
When you turn the key to the run position, do you here the fuel pump prime, a humming noise from the gas tank?
Have you replaced any other electronic components, key cylinder, body control module?
Let me know.
Regards,

Posted on Apr 11, 2009

  • 7353 Answers

SOURCE: where is the starter solonoid located 04 aveo

You will need to verify if the starter solenoid is getting power when you are attempting to crank it. I dont have a diagram, but the clutch switch may be the problem if you must depress the clutch to start the engine.

Posted on Jan 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can I charge unit with a male to male on the 12 volt port asking about unit Stanley JS900CS Not Jump-N-Carry


Tool review: Jump-N-Carry jump starter -- Portable model ...

www.autoserviceprofessional.com/.../tool-review-jump-n-carry-jump-sta...
Jun 6, 2014 - The Jump-N-Carry's convenient charge indicator reveals the unit's stored voltage. ... By plugging the male/male adapter cable into the Jump-N-Carry ... This 12-volt DC port also can be used to power 12V accessories (up to 12 ...

Using The Unit As A 12 Volt Dc Portable Power Supply ...


Jan 01, 2016 | Cars & Trucks

4 Answers

My 2003 chevytrailblazer motor did roll over but now it dont


Check Battery, if you try to charge or jump starter you may hear a click. If you're sure its a good charged battery then consider starter. Try to jump starter by passing switch, cross small wire to larger wire on starter (you may get sparks) (please be careful if you try this) this should make the starter spin & kick in turning the engine. If it only spins then its probably the starter solenoid. If this checks out then check ignition switch & harness connections. That's it..

Nov 28, 2014 | 2003 Chevrolet TrailBlazer

1 Answer

I have a starter-up jump starter 400 and need to know the correct way to charge it so I can use it to jump start a battery


There should be an ac plug in the back of the unit. plug it up with an extension cord and the display will give you the percentage of the charge remaining. FL is full.

Nov 16, 2014 | Cars & Trucks

1 Answer

Ford ikon 1.8 is not starting every day morning


what are the symptoms, dead battery, do you need to jump it to start, did you drive at night the day before?, check your charging system, mast be over 13.5 volts, over 25 amps charge, check you battery CCA, cold cranking apps, over 400 amps, finally check the starter for power signal, check the solenoid, if you suspect the starter replace it. but first check you battery terminals, make sure the are tied, clean and making good contact. my money is on the starter.

Nov 09, 2013 | Cars & Trucks

2 Answers

Won't start but can hear starter make a click noise when trying to start with key


will it start with a jump ? if it does replace the battery and have the charging system tested, if it will not start with a jump then most likely you will need to replace the starter.

Dec 07, 2011 | 1999 Chrysler 300M

2 Answers

1991 Lexus 400 - engine doesn't start - battery seems charged - 12.3 volts - makes clicking sound only - doesn't turn over at all.


Is it one click or multiple clicks. If it's multiple clicks, it sounds like a dead battery. Voltage isn't always an indicator of a good battery, you need to have enough cranking amps to be able to start an engine also. If you have dash lights and it only clicks once, you could have a bad starter. An easy way to check this is to try and jump start the vehicle. If it starts up with a jump start, you need a new battery. If it still doesn't start up and it just clicks, you probably need a new starter.

Good Luck!
~Brandon

Jun 01, 2011 | 1991 Lexus LS 400

1 Answer

I have a 2001 chevy 2500hd. when i try to start it, i only have a click (one click per key turn) fron the starter. Will not start. any sugg


TRY GETTING JUMP START IF VECHICLE CRANK ON JUMP START.YOUR BATTERY WEAK NEED CHECKING.CHARGED LOAD TEST IF BAD NEED REPLACING.MAKE SURE BATTERY CABLES CLEAN TIGHT FREE FROM CORROSION.TRY THIS TEST TURN ON HEADLIGHTS TURN ON IGNITION SWITCH.IF HEAD LIGHTS GO DIM.STARTER OR STARTER SOLENOID FAULTY WEAK BATTERY.IF HEADLIGHTS REMAIN BRIGHT YOU HAVE OPEN CIRCUIT IN STARTER SOLENOID OR STARTER AMATUER OR FIELD WINDING.

Jan 18, 2011 | Chevrolet 2500 Cars & Trucks

1 Answer

I have a 96 Dodge Intrepid and it wil not start. it clicks when you try to start it. All of the lights in the car are on. the battery has been charged. it cut off on me a few days ago and i thought i...


solenoid clicking, troubleshooting steps: Run 3 tests to troubleshoot.

1. try to jump start at battery terminals
2. unhook the jumpers and try to jump the solenoid following procedures at http://www.fixya.com/cars/r6222268-engine_doesnt_crank_turn_over (see picture there--make sure car is in park or neutral)
3. Only if #1 and #2 fail to crank the engine, smack the starter motor (not the solenoid) with a hammer and then try to start.

Based on results of above tests, here are solution options:

If smacking the starter is the only test that worked, you have a dead spot on the starter commutator--replace the starter.

If it will jump start but will not crank by jumping the solenoid, check to make sure the battery terminals are clean and tight.

If it will not jump start and will not crank even by jumping the solenoid, the problem is either the cable to the starter or the starter/solenoid itself.
check the big red wire that goes from the battery to the starter and make sure it is strong and tight at both ends. If that is good, replace the starter/solenoid.

If it will not jump start but will crank when the solenoid is jumped, the problem is with the start circuit not getting sufficient current to the solenoid. This usually only happens when there is a separate starter relay (in the engine compartment relay box) that is worn out. Replace the starter relay.

Please let me know if you have questions.

Oct 17, 2010 | 1996 Dodge Intrepid

3 Answers

I have a kia sedona 2003. the car will not turn over. i hear a click, click, click sound. can someone help me how to fix this.


if the starter is faulty take it off and check the brushes,
also have a look at the solenoid on the starter and clean the contacts

Mar 11, 2010 | 2003 Kia Sedona

1 Answer

Won't start or jump


I just had this problem last week. The starter is definitely shot. Don't take it in to Nissan though. They will charge you at least 500 bucks for the starter and probably another 300-500 for labor.
Just call a couple shops and get a quote. I got mine replaced for 400 bucks and thats part and labor.

Dec 23, 2009 | 2000 Nissan Maxima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...