Question about 2006 Volvo XC90
From a website:
The Check Engine Light may illuminate with five EVAP system related fault codes stored. Our technicians tell us this is generally caused by a faulty EVAP system pump module, which is an integral part of the charcoal canister. A revised canister is available to correct this concern.
Posted on Nov 15, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Simply hold down the button you want to use (there are 3 for up to 3 different garage doors) until the light flashes and keep holding it down. Now place the garage door opener up near the sun visor and hold it's button down until the light on the on button you are programming flashes. It is now programed. The other 2 are done the same way. Good luck. It took me a while to find the info, it's not in any Volvo manuals I could find.
Posted on Jul 03, 2009
You may have accidentally switched off the STC. Your car battery voltage may bee too low (this should remedy itself after a while driving). There may be damage to the breaks.
Best thing to do is to take it to the Volvo-service and let the guys check the system with their diagnostic software.
Posted on Jan 15, 2010
SOURCE: Fuel Pump replacement
you have to remove the rear seats and roll back the carpet. if it is a seven seater you have to take out some ac ducts. then there are two access ports on each side of the floor. they are usually black and have four nuts holding them down you remove those and then you have access to the pump. you need some volvo special tools to remove it. volvo has recall 220 going right now and your fuel pump maybe covered under it. i would definitely talk to the dealership about it. because that would be no out of pocket cost to you
Posted on Jul 04, 2010
CODE P1171 SYSTEM TOO LEAN BANK 1 PART LOAD. POSSIBLE CAUSE - INTAKE/EXHAUST LEAK , FAULTY MAF SENSOR , FAULTY MAP SENSOR OR FUEL PRESSURE TOO LOW DUE TO STOPPED UP FUEL FILTER.WEAK FUEL PUMP.
Posted on Aug 13, 2010
It often is the laserunit but not always. Prints, laserunits and complete loader units for volvo cars. you find here
Repair for Volvo and loaders for volvo cars and trucks
Posted on Sep 13, 2010
Tips for a great answer:
Aug 16, 2017 | Volvo Cars & Trucks
Jul 17, 2017 | Volvo Cars & Trucks
Nov 09, 2016 | Volvo Cars & Trucks
Jun 11, 2015 | Volvo XC90 Cars & Trucks
Dec 11, 2012 | 2005 Volvo XC-90 2.5
Dec 10, 2012 | 2004 Volvo XC90
Dec 05, 2012 | Cars & Trucks
Feb 12, 2011 | 2005 Volvo XC90
Aug 13, 2010 | 2000 Volvo V70
Jun 12, 2009 | 2004 Volvo XC90
364 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: