Question about 2006 Dodge Caravan

1 Answer

2006 dodge caravan what size nut is the battery hook up on starter and is it metric

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

It is metric not sure of the size. start with a 17mm and work from there

Posted on Nov 15, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
INSIGHTAEM
  • 1 Answer

SOURCE: starter for dodge caravan 2000

DISCONNECT THE BATTERY, JACK UP AND SUPPORT YOUR CARAVAN. LYING ON YOUR BACK LOCATE THE STARTER WHICH IS ATTACHED TO THE ENGINE THROUGH THE BELL HOUSING .THERE ARE TWO 15 MILIMETER BOLTS THAT HOLDS THE STARTER ON . AFTER BREAKING THE BOLTS A 15MM WRENCH WOULD BE USEFUL.

Posted on May 30, 2008

  • 104 Answers

SOURCE: Need install instruction for starter on 2002 Dodge Caravan

This is alittle tricky getting to some of the bolts but its not too hard to do otherwise. 2 bolts hold on the starter IIRC they are 13mm bolts. make sure your battery is dissconected by the black cable. then there will be 2 nuts holding on the starter wires. one will be 8mm and the other 13mm. remove them with care cause the wires may and can break. when you remove starter check wires for corrosion or if they look fraigle. repair them if damaged.
then to put it back in is the same way you took it out. should take about 1.5 hrs total if you have never done it before.

Overall i would say skill level 3/10 only cause its trickey getting to that top bolt sometimes.

good luck,
Michael

Posted on Apr 29, 2009

  • 749 Answers

SOURCE: Need battery size for 1996 Dodge Caravan

your cars battery might only need charging or battery acid replacement, but if you'd realy wish to buy new one, buy one with the same size and voltage and amps as the one you have right now, or you could buy a battery with the same voltage with a higher amppere-hour (Ah) rating!

Posted on May 21, 2009

tepfy
  • 319 Answers

SOURCE: tool for 2006 brake calipers I need size

buy a set of the torque bits they come in sets of 4 or 5

Posted on Jun 14, 2009

  • 297 Answers

SOURCE: 2005 grand caravan ? size allen wrench to remove rear calipers

6 mm to small 8 mm to big, how about 7 mm would you not think ??

Posted on Aug 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 grand caravan starter diagram and size bolts needed for the starter


To work on your vehicles, you need a basic set of wrenches and sockets, standard and metric sizes. To buy one wrench or one socket, just isn't feasible, in my opinion.
Try 15 mm

Dec 09, 2016 | 2006 Dodge Grand Caravan

1 Answer

I got 2006 dodge grand caravan and can't figure


Most vehicle bolts are a Metric Size
Have to know how to measure & figure
that out, or try some spare bolts in there
Ask a repair shop

Jul 18, 2013 | Cars & Trucks

3 Answers

I'm trying to get the starter out, but I can't find the right size socket or wrench to fit the bolts. A 5/8 is to big and a 9/16 is to small. Also how can I make the process simpler? The car I'm...


Hi!! You need a 15mm socket and a 6" long extension there, is only 2 bolts fastening the starter and 2 more for the electrical connections to the solenoid, one is 8mm and the other is 13mm.
DISCONNECT (-) NEGATIVE BATTERY CABLE BEFORE REMOVING STARTER.
DON'T FORGET TO RATE THIS POST!!!!!.

Aug 17, 2010 | 1993 Dodge Caravan

2 Answers

2006 Dodge Caravan engine will not turn over


i know you have checked everything .chech 1solinoid on top of starter.2netural wire from battery to starter.if this fails check small red wire from ign to solinoid.[small].adrian,,,

Jul 26, 2010 | 2006 Dodge Grand Caravan

1 Answer

I need to replace the starter on my 2001 dodge caravan sport. Where would I find instructions?


Caravan, Grand Voyager, Town and Country, Voyager, 2000-2004
Starter - Removal & Installation
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:
    Negative battery cable Starter harness connectors Starter motor
To install:
Install or connect the following:
Starter motor. Torque the bolts to 35 ft. lbs. (47 Nm). Starter harness connectors. Torque the battery cable nut to 100 inch lbs. (11 Nm). Negative battery cable


Hope this help (remember comment and rated this).

May 14, 2010 | 2001 Dodge Caravan

1 Answer

2006 Dodge Caravan, just clicks when I try to start it, and the speedometer and gauges move all the up then back down. Is this a starter, checked the battery, it is good. The battery and all are original,...


Could be a bad starter. You need to check the amperage the starter is using. Does it start with a boost could be a bad battery. Check battery with a volt meter and see what voltage you have there. Less than 12 volt the battery is no good.

Oct 13, 2009 | 2006 Dodge Caravan

2 Answers

2005 grand caravan ? size allen wrench to remove rear calipers


6 mm to small 8 mm to big, how about 7 mm would you not think ??

Aug 16, 2009 | 2002 Dodge Grand Caravan

1 Answer

Where is the starter located and what tool are required to remove


you have to look with a flash light depending on the vehicle, go under the vehicle and look left to the right of the bottom of the engine and you should see a elongated part no bigger than 12 inches(smaller) and it will have no more than three wires with a smaller cylinder attacked to it. most of the time there will be 3 bolts or nuts holding it on. tools= socket set; standard for domestic vehicles and metric for import vehicles, open end wrenches and wire cutters(just in case). most of the time on domestic cars you will use a size of 1/2 to 9/16 for you tools. start with disconnecting the battery then remove the starter. when putting the new one on just turn the teeth on the starter to line up with the wheel in the engine, you will see that when you remove the old starter. splice the new power wire if needed for the power, a new wire should come with the new starter if it is needed. hook the battery back up and enjoy!

Jan 12, 2009 | 2000 Dodge Caravan

1 Answer

Middle seat selt belt 99 caravan


it is bolted to the seat frame you have to remove the bolt and nut. it's a torx bit size #60 and a metric wrench size 15 mm that you will need. please rate the solution...thanks

Sep 26, 2008 | 2000 Dodge Grand Caravan

Not finding what you are looking for?
2006 Dodge Caravan Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...