Question about 2003 Cadillac CTS

1 Answer

<!-- from fixya rte -->Transmission oil fill place - 2003 Cadillac CTS

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

There should be an oil dip stick towards the driver side rear of the engine compartment.

Posted on Nov 15, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hello / I have a car maintenance workshop Question / How change Automatic oil gerbox Renault Megane 2005 Thank you


You need to get under the car, identify the transmission oil pan and look for the drain plug:


26062649-yytlcu2b3evmxr44xdn3gosb-1-0.jpg Place a large plastic dish beneath the drain plug and the undo the plug. Allow the old fluid to drain into the dish. Replace the drain plug.

Locate the filler plug - it will be on the side of the transmission, higher up. Use bottles with spouts to fill with the correct amount of transmission fluid .. or .. possible .. fill with fresh transmission fluid via the transmission dipstick.



26062649-yytlcu2b3evmxr44xdn3gosb-1-1.jpeg The filler plug

Jan 21, 2016 | Renault Cars & Trucks

1 Answer

I want to know the point to re-fill gear oil in my car


How to check & re-fill gear oil in automatic transmission on 1996 Audi A4:

At the bottom of the automatic gearbox (tiptronic) you will find 2 threaded plugs on below surface. First (in front of the car) is for emptying, and second is for filling up. Tightening torque is 24 Nm.

tdisline_63.jpg


Automatic Transmission Fluid (ATF) checking:
1. Requirements for check:
1.1. Vehicle standing on level surface.
1.2. Transmission must not be in fail-safe mode.
1.3. Shift lever in "P" position, parking brake applied.
1.4. Engine idling.
1.5. Air Conditioner and heater OFF.
1.6. ATF temperature must not exceed 104 Fahrenheit degree (40 Celsius degree) at start of test.
1.7. Only ATF with designation ESSO LT 71 141 may be used. Do not use any lubricant additives.
1.8. Automatic Transmission Fluid ATF - part number: G 052 162 A2 (1 liter wrapping)
1.9. An ATF level check when transmission oil temperature is too low results in overfilling, when too high results in underfilling.
2. CAUTION: Too much or too little ATF will affect the operation of the transmission. The ATF level must be checked at regular intervals.
3. The oil level is correct if a slight amount of oil runs out when ATF temperature is between 86 Fahrenheit degree (30 Celsius degree) and 113 F deg (45 C deg) (caused by increase of oil level when heated). For warmer climates, 122 F deg (50 C deg).
4. Hang filled ATF reservoir VAG 1924 as high as possible.
5. Shift lever in "P" position, engine running at idle.
6. Place oil drip pan under transmission oil pan.
7. Remove ATF filler plug (at the bottom of the automatic gearbox you will find 2 threaded plugs on below surface. First (in front of the car) is for emptying, and second is for filling up.
8. With ATF temperature between 86 Fahrenheit degree (30 Celsius degree) and 113 F deg (45 C deg), for warmer climates, 122 F deg (50 C deg), a slight amount of oil will flow from filler hole when ATF level is correct.
9. If necessary drain or top off ATF to attain correct oil level. Top ATF with filler hook from VAG 1924 ATF reservoir. Insert VAG 1924 (tool) ATF reservoir filler hook into filler hole and top off until a slight amount of oil flows from filler hole.
NOTE: Fit filler hook into one of the oil deflector cap slots placed on the filler opening.
CAUTION: Do not press filler hook upward or oil deflector cap can be pushed off.
10. Reinstall ATF filler plug. Tightening torque is 24 Nm.

Dec 01, 2010 | 1996 Audi A4

1 Answer

95 ford aerostar were do you add transmission fluid


The dipstick tube usally has a red top that says transmission. Withthe stick removed you add the fluild where the stick was. At places theat sell the trans fluild they will also sell you a transmission filler funnel. Also all the quick oil change places will check and fill the oil for you and if you ask they'll show you how it's done.

Feb 10, 2010 | Ford Aerostar Cars & Trucks

1 Answer

How do I change the tranny fluid in my 1998 cadillac catera


Fluid - A/T: Service and Repair
Transmission Fluid and Oil Filter Changing
REMOVAL PROCEDURE
1. Raise and suitably support the vehicle. Refer to Vehicle Lift Points.
2. Place drain pan under pan
3. Remove oil pan bolts from front and sides only.
4. Loosen the rear oil pan bolts approximately four turns.
5. Lightly tap the oil pan with a rubber mallet or pry to drain the fluid from main case.
6. Remove the oil pan bolts from rear oil pan and gasket.
7. Remove front oil pan bolts leaving one corner bolt in loosely.
8. Lightly tap oil pan with rubber mallet or pry to drain fluid.
9. Remove the following remaining components:
^ The front oil pan bolts
^ The oil pan
^ The gasket
10. Remove the oil filter bolts and filter.
11. Clean the following components:
^ The transmission case
^ The front adapter case
^ The oil pan gasket surfaces with solvent
^ Air dry
^ All traces of gasket material must be removed
INSTALLATION PROCEDURE
1. Install the gasket.
2. Install the oil filter.
3. Install the bolts.
^ Tighten the transmission oil filter bolts to 20 Nm (15 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
4. Install the front oil pan.
5. Install the front oil pan gasket
6. Install the front oil pan bolts
^ Tighten the front oil pan bolts to 11 Nm (96 inch lbs.).
7. Install the following components:
^ Install the pan
^ Install the gasket
^ Install the bolts
^ Tighten the oil pan bolts to 11 Nm (96 inch lbs.).
8. Refill the transmission with DEXRON III through oil pan fill plug on the side of the (main case) oil pan. Fill the transmission to lower edge of oil
pan fill. Fill plug opening using and oil suction gun.
^ Tighten the oil pan fill plug to 45 Nm (33 ft. lbs.).
9. Lower the vehicle.
10. Check the transmission fluid level. Refer to Transmission Fluid Checking Procedure.

Sep 13, 2009 | 1998 Cadillac Catera

2 Answers

I need to fill the transmission fluid on my 1989 Ford Festiva.


use a very small funnel placed into the dipstick tube check frequently with the dipstick so you don't overfill

May 25, 2009 | 1989 Ford Festiva

1 Answer

Replaced the transmission pan...how do i refill it?


I think this model has a 4t40e trans. The fill is a cap Near the top of the bell housing. It is a red screw cap that says trans fill on it. There is a plug just above the lip of the bottom pan gasket near the passenger cv shaft. Remove the plug and fill the trans until oil runs from the plug hole. Now start the car and continue to fill until oil runs from the plug again. When the trans oil is running out with the engine running it is full. Reinstall the plug.

Apr 28, 2009 | 2001 Saturn L-Series

1 Answer

Where do u put transmission fluid in a bmw 740il 2001


Here is the procedure:

The transmission temperature must be between 86° to 130° F (30° to 55° C) before checking With engine running, switch on AC While holding vehicle with brakes, place transmission into each gear briefly With engine running and transmission in park, remove Fill/Check plug. If a small amount of oil runs out, fluid level is correct. If no oil runs out fluid level is low, add fluid as required through Fill/Check plug hole. When level is correct, reinstall Fill/Check plug and tighten to correct torque.

Feb 10, 2009 | 1984 BMW 5 Series

2 Answers

Place to check and fill Transmission oil in Mazda Protege 1993


Don't listen to the other guy, I own a 1990 1.8L mazda protege with a manual transmission. Yes it will make it easier to hoist it up. I am not going into extreme detail so as long as you know a little about cars this will be a great help.
on the transmission locate the drain plug, it will be on the bottom of the transmission. don't loosen it yet you want to make sure you can fill the transmission before you drain it. there is no fill plug, you have to fill the transmission through the hole the speedometre cable is attached to the transmission. the speedometre cable is straight up and down/vertical, it should be above the passenger side cv shaft coming out of the transmission.
remove the small bolt holding it in place and then pull it straight up and out of the transmission. now drain the transmission. put the drain plug back in and start filling, make sure not to overfill you are not supposed to fill it right full.
Make sure to check the fluid level as you fill, the transmission is at the right level when the gear oil is just at the top of the speedometre gear that is on the end of the cable that is inserted into the transmission.
I believe these transmissions take 75w 90.
Hope this helped you, and maybe future people who view this looking for help.

Nov 12, 2008 | 1993 Mazda Protege

2 Answers

Add transmission fluid


On 91 vehicles there's a 17mm allen screw on the side towards the left front wheel. Open it add the oil there on a level surface and fill till oil reaches the hole and starts coming out. DO NOT FILL OIL FROM THE TOP where what seems to be a plug. It's actually the timing marks and houses the clutch. Put oil there and you'll need a new clutch.

Nov 01, 2008 | 1991 Volkswagen Jetta

1 Answer

How do i check the transmission fluid


transmission fluid you can check easy way the gear box is one oil to be so you can see in the middle of the gear box filling plug remove that with spanner if you see oil coming from hole that is fine you don't put more just putted back and tight. if you don't see any oil just use your finger front part through if the front part of your finger touch the oil that is also fine means ok. but is the oil is very low from that place you must fill.
To get the level if you fill the oil you stop filling when you see oil is draining so you wait until oil stop clean the aria then you fixed back the filling plug or bolt tight.

that is my advice sorry any mistake of my tipping.

Oct 26, 2008 | 2003 Oldsmobile Alero

Not finding what you are looking for?
2003 Cadillac CTS Logo

Related Topics:

35 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...