Question about Cars & Trucks

1 Answer

I appreciate your quick response, but you wrote replace the hightlight switch, did you mean the headlight switch??????

I have no high beams, I've replaced the dimmer switch, but that didn't help.....

Posted by on

Ad

1 Answer

You replace (nothing) until you do some testing
to find a problem & the solution is to replace a
part that failed a test

Posted on Nov 15, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
freetek
  • 5568 Answers

SOURCE: no high-beam headlights

It may not be the switch; most hi-lo changes are via relay to prevent the higher currents from flowing through light-duty switches.

Locate the relay cluster (it might be near or with the fuses) and if they aren't marked, pull wach one of them and plug back in several times to wipe possible corrosion from the blade contacts.

If they are marked, look to see if the same relay is used elsewhere (part number should be visible) and swap them temporarily to see if the relay is at fault.

Some vehicles will use separate relays for hi-lo beams and another for flashing since that often turns on both beams momentarily.

Posted on Aug 26, 2008

  • 1 Answer

SOURCE: How do I replace a

don't know if this helps much...have same problem. have to take the whole dimmer and turn signal switch off. pop up (don't take off) the top cover of the steering column. The turn signal handle is attached to the switch (all one unit) and held in place by those small plastic hinges (should be one on top and one on the side). unhook those, and you should be able to lift the switch up and should slide right out. Now, the problem is the parts stores (Autozone, checkerauto, NAPA, etc.) don't carry that item at this point (they may as of this writing [checked last this past weekend]). You have to get it from the dealer at a cost of $150+

Posted on Oct 22, 2008

  • 412 Answers

SOURCE: 02 dodge caravan headlights

SOUNDS LIKE INTEGRATED POWER MODULE(UNDERHOOD FUSEBLOCK)IS DEFECTIVE..ALSO CHECK FOR CORRODED TERMINALS IN CONNECTORS ON FUSEBLOCK..HAVE SEEN THIS BEFORE AND NEW FUSEBLOCK WAS NEEDED AND REPAIRED PROBLEM

Posted on May 31, 2009

  • 713 Answers

SOURCE: How to replace high/low beam switch on 2004 Ford Focus LX?

Should be fairly easy. Make sure to disconnect the positive battery cable. Remove the cover from around the column behind the steering wheel. Should take a star driver to remove the screws holding the cover together. Once the screws are removed pop the cover apart and you will see the multifunction switch on the column, should have two to three screws holding it to the column remove the screws and it should come out pretty easy replace with new one and put back together.

Posted on Oct 02, 2009

Testimonial: "Thank you so much!"

arauzvictor1
  • 466 Answers

SOURCE: Headlights do not work on high beam. The blue

it works for blue light but high beams do not work check the high beam relay if it reviews the bulbs.

Posted on Nov 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Driver side headlight goes dim on high beam while passenger side is bright


bad connection or bad earth check all connection or bulb

Jan 24, 2016 | Cars & Trucks

1 Answer

My headlights pop up but don't turn on.have changed switch and control module. Any ideas?


Assuming you checked the fuses. I would go after the turn signal(TS) switch. Both the high and low beams run threw it. Actually, all the exterior lights run threw it except the high mount brake light. You need a wiring schematic. First I would check for power going to it. No power means the wire is broke between the fuse and TS switch. If power is going to the TS switch, then replace the switch. A quick check for TS switch is if you have high beams, but no low beams. Or vise versa. Neither one , you have to check for power to it first.

Mar 18, 2015 | 2000 Pontiac TRANS AM

1 Answer

I appreciate your quick response, but you wrote replace the hightlight switch, did you mean the headlight switch??????


As I have never heard of a hightlight switch I'm guessing yes, headlight switch.

Nov 14, 2014 | Cars & Trucks

1 Answer

High beam headlights stuck on replaced switch same problem


It can be issue with headlight switch,but as its already been replaced.Try disconnecting high beam headlight wiring from headlight assembly and reconnect direct external wire from headlight switch to headlight assembly,then by switch see if headlight is getting off and turning on or not.
See below related help links,similar to your issue.Click the link below:----
Only high beams work but head lights not working on Ford F350?

http://howtobyme.blogspot.com/2011/11/only-high-beams-work-but-head-lights.html

----------------
Only high beams working on GMC Savana?---------- High beams stopped working but headlights still work? http://howtobyme.blogspot.com/2011/11/highbeams-stopped-working-but.html
---------- Working of Headlight switch? ----------

Both headlight bulbs blow together?
----------

Car headlight bulbs don't last long?

------------ Only one head light works on 2001 Dodge Caravan? http://howtobyme.blogspot.com/2011/11/only-one-head-light-works-on-2001-dodge.html

----------
these will help.
Thanks.

Nov 06, 2012 | 2007 Chevrolet Tahoe

1 Answer

The headlights and high-beam search lights on my 1987 Toyota land cruiser wont turn on. Is this a fuse problem? If so where is the corresponding fuse/fuse-box located? I've already look on the und


The left and right headlights are on different fuses. If both are not working, you need to check the fusible link, headlight relay, and the switch itself. See diagram below.
0900c1528004d7e2-dwbgzyjx1s1bj3innjxcfx0i-3-0.gif

Jun 15, 2017 | 1987 Toyota Land Cruiser

2 Answers

Camry headlights not working


it sounds like a bad light switch

Mar 25, 2010 | 1993 Toyota Camry V6

2 Answers

High beams wont turn on.


First place to start is with headlight switch. I did have a case many years ago when both high beams were blown out at once, but this is rare. When you have the headlight switch out, jump power from te low beams to the high beam contacts. If high beams come on, replace switch.
Bill

Nov 19, 2008 | 2004 Ford Explorer Sport Trac

4 Answers

Low beam headlights do not work, but high beam headlights do


Clyde,

I've been troubleshooting this same problem on a different vehicle this week, and I can give you the steps I'd take.

1. If both sides went out at the same time, the problem is *NOT* likely to be the bulbs.

2. Check the fuses to see if both low beam lights are on the same fuse. Many cars have one fuse for low beam and another for high beam, so both lights out at the same time typically means fuse blown.

3. If the headlights are OK and the fuses are OK, then the problem is *LIKELY* the headlight switch. In my case, AutoZone has one and it can be installed easily; but in your case, that may not be as simple.

Please post your findings or comments.

Jul 16, 2008 | 1991 Nissan Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...