Question about Cars & Trucks

Open Question

Need help wiring Lanzar OPTIMC91BT to my metric bike. Instructions make no sense and tech support definitely didn't help. I'm trying to figure out how to get power to the amp when it says to use example A wiring harness. There is no place to plug the harness into amp. Really do not want to take to professional shop when I have everything else installed. Thank you

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Stereo wiring harness diagram

google!! i found it!

Posted on Jun 20, 2008

gandergmm
  • 145 Answers

SOURCE: speaker wire colors

http://www.host-comp.com/281774/va124760.pdf
or
http://www.host-comp.com/281774/va124761.pdf
since there were 2 stereo system versions :)

Posted on Oct 01, 2009

mindreader
  • 578 Answers

SOURCE: 2001 Ford Taurus - won't start. Cranks really good

George,
Lots of possible choices... but junk yard coil as a replacement (easy for you to do) can eliminate that potential problem for just a few dollars.

If that fails, have a friend help you confirm that you have spark - by pulling a plug wire and holding it against (near) a good ground. If it sparks over 1/2 inch - it is not spark.

If that fails, pull a plug wire off a spark plug. Crank the engine for 10-15 seconds. Now remove and inspect the plug for gas wetness. If wet, it is not fuel flow.

If that fails, it could be timing, timing belt, or a large number of other issues - most cheap to fix but time consuming to locate.

Do the above tests then come back and let us know what you find!!

Posted on Oct 13, 2009

Hitchguy84
  • 44 Answers

SOURCE: where is the trailer wiring harness connector in a

It may be tapped in with another bundle of wires. Attached is a picture of the plug and location.84108bd.jpg

Posted on Feb 03, 2010

  • 1 Answer

SOURCE: wiring diagram for 01 isuzu rodeo stereo

A few weeks ago I bought a new JVC stereo for my 2001 Isuzu Rodeo. I was advised that using a wiring harness would be the best option to install it. I spent an entire Saturday going from one store to the next (Autozone, Advance Auto Parts, Radio Shack, etc.) looking for the wiring harness specific to an Isuzu Rodeo but, to no avail. I searched several online sites looking for one and finally found it at http://www.beachaudio.com/ . The cost of the harness was under $10 and with express shipping I only paid about $20. Since I ordered it on a Wednesday night with 3 day express shipping, I assumed that I'd receive it the following Monday given any processing time and the weekend but, it was delivered to me just two days later. My husband installed my new stereo that Sunday using the harness that I purchased and it works great! Hope this information helps.

Posted on Jul 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace a starter


buy starter , get under car ..ugh
have metric set ready
2 bolts
2 wires
dirty place . worth the smiles when it works
you might have to have shims
use gloves an a mask or youll put ur eye out

Jul 26, 2014 | 2004 Ford Taurus

1 Answer

I got 2006 dodge grand caravan and can't figure


Most vehicle bolts are a Metric Size
Have to know how to measure & figure
that out, or try some spare bolts in there
Ask a repair shop

Jul 18, 2013 | Cars & Trucks

1 Answer

I have changed alternator and battery twice in 6 months and battery lite comes on and the battery is only showing me 12 volts or les while running


HONESTLY AS A CHRYSLER TECH I HAVE NEVER SEEN THIS. BUT I HAVE A COUPLE QUESTIONS THAT MAY HELP US FIGURE THIS OUT. ARE YOU CHECKING THE VOLTAGE WITH A DVOM OR BY THE GAUGE IN THE DASH? ARE YOU BUYING YOUR PARTS FROM A SECONDARY PARTS STORE? AUTOZONE, ADVANCED? HAVE YOU DONE A RESISTANCE TEST ON THE SENSING WIRE OF THE ALTERNATOR? PLEASE LET ME KNOW

Feb 22, 2013 | 2006 Jeep Grand Cherokee

1 Answer

Chevy Astro rear window is loose, how do I fix it


Sounds like the glass tech either didn't clean the area good enough,didn't use a good adhesive,or just hurried to much.You can get the stuff you need at a good parts place(NAPA or Carquest are my favorites for professional products).3M adhesives are typically the best.Use a "piano wire" removal tool to take the glass out.Clean everything down to the bare paint with solvent."Glue in" window glass is usually installed with a urethane adhesive in a caulk gun tube.Read the side of the tube,make sure you have any primer it may call for before taking it home.(The manufacturer's instructions are the best to follow-they want you to like their product's results so you'll buy it again!).This IS a job the average gearhead can handle.Hey-the last "pro" you took it to didn't do it right anyway,so what'll it hurt for you to take a shot at it?

Jun 13, 2012 | 2002 Chevrolet Astro

1 Answer

How do i change the fuel filter on a dodge 3500 diesel dually


Hello aboadwine -- You didn't say what year model, but for the 6.7 cummins they didn't change very much.

Here is a link with instructions, even has pretty pictures for you.
You will need a good filter wrench, ratchet, & extension...cause they do get tight.
I hope this helps... good luck with the Ram.

http://www.cumminsforum.com/forum/6-7l-tech-articles/177185-6-7l-fuel-filter-change-how.html

Sep 21, 2011 | Dodge Ram 3500 Cars & Trucks

1 Answer

2005 Buick Park Ave Odometer reads about twice as fast as actual speed. Looking back went from 150K mi to 195K mi in two years. But only drive about 10 mi per week + a couple 180 mi weekend trips. Any...


Did you accidentally push a button the dash to make the car read in metric? That would make sense if things were in kilometers instead of miles. Can't remember exactly how the 2005 model was but there should be buttons on the left side of the dash and one of those would change from miles to km. If your dash isn't like that, let me know and we can figure it out.

Mar 28, 2011 | 2005 Buick Park Avenue

1 Answer

I have a 91 toyota mr2 which need to change the clutch line from clutch master cylinder to slave cylinder. Where can i get the aftermarket parts? or i can just replace the rusty part, but where can i get...


I hate this particular project. Yes, you need metric ends at least. The problem of course is that auto parts stores don't carry long lines with metric ends. I ended up getting a "pipe flaring tool" so that I could put my own metric ends on the standard pipe. I then bought a short 7" metric line from a parts store, and cut it to use the ends on new standard size line. You will either want to get a nice one on loan from a friend or take the car to a shop. The cheap $30 tool I bought at one of the big auto parts stores didn't even work correctly out of the box. Ended up buying a $150-200 one that works great! Still a lot of work and expense if you are doing it yourself. The line is hard to get to once it gets up to the front of the car, so cutting out the bad rusty part and putting ends on is the easier do-it-yourself project - if you have the brake line flare tool. I would take it to a shop. Good luck!

Nov 11, 2010 | 1991 Toyota MR2

1 Answer

My hyundi accent is leaking oil form the head cover gasket? what do i need to do to fix it?


You need a valve cover gasket set a metric socket set and some common sense. It's not rocket science to do this job.

May 14, 2010 | 2002 Hyundai Accent

1 Answer

What tools do i need changing front brakes on a mazda 1993 626


get common metric tools and tork ot metric allen sockets and a suitable pad depresser and use common sense

Mar 14, 2010 | 1995 Mazda 626

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...