Question about Mitsubishi Colt

1 Answer

Mitsubishi Colt 2l injectors 16 valves continuous smoking. Just fitted New cylinder head

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Cylinder seal are not fitted up properly gas getting into the oil

Posted on Nov 14, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 155 Answers

SOURCE: 2004 Lincoln navigator misfire on cylinder 8 error code p318

Replace the coil pack once more. I went through 2 new ones on my f150 on one cylinder. One worked, the other didn't (both new off the shelf). Condensation build up in the boot caused mine to misfire. Anytime you replace a coil pack, squirt a little silicone grease inside. This will prevent condensation from hitting your plug. Fords are notorius for this problem, especially if you live in a humid area. Also, make sure and clear the codes after you make the repair.

Posted on Jun 10, 2009

  • 17 Answers

SOURCE: how to make remote key for Mitsubishi colt 2006?

do you have a remote key at all?
if yes then you can take the key go to a keymaker shop and thei will be able to clone the key code and duplicate a new remote key for you.

Posted on Nov 05, 2009

  • 3 Answers

SOURCE: 4M40 engine lacking power and blowing black smoke.

http://www.delicaclub.com/load.php?id=20

Install the egr mod, will stop it smoking in no time
Delica owner...

Posted on Dec 21, 2009

  • 3 Answers

SOURCE: 98 mitzi l200 2.8 l eng 4M40

White smoke is a sign of unburnt diesel fuel, check your glowplugs as thats the most common cause when starting .It will start but not hot enough to burn fuel at start up, also check glowplug relay if not the plugs
Delica Owner 4m40

Posted on Dec 21, 2009

  • 334 Answers

SOURCE: serpentine belt diagram for 2003

Hello avatar15.jpgeleblanc1234,

Below is a diagram of the belt routing.


8_21_2011_4_43_36_pm.png

I hope this helps.

Regards,

Jerry

Posted on Aug 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mitsubishi Colt 2L injectors 16 valve with new cylinder head fitted but continuous smoking what could be the problem ?


black smoke --over fuelling, incomplete combustion
white smoke --too lean , water getting into the combustion chamber ( gasket)
blue smoke-- valve stem seal incorrectly fitted( old or worn,hard),oil ring failure, cylinder bore damaged, worn main/big end bearings overloading the oil ring,fauty pcv valve or EGR system

Nov 14, 2014 | Mitsubishi Colt Cars & Trucks

1 Answer

What is the torque settings for a mitsubishi colt hiline 2.0i cylinder head?


There is no torque value. Commonly, Head bolts are tightened and then removed in sequence as you step threw 3 values: 23/33/45 ft lbs then the final value is achieved by rotating the bolts 90 degrees so the final value is unknown.

You have to get either a hayes manual or follow a procedure online if you are replacing the head gasket. If you are not replacing the gasket do not "re-torque" the head bolts thinking that you can fix a head gasket leak.

Jul 29, 2014 | 2005 Mitsubishi Colt 1.1

1 Answer

My discovery 2 is a pain to start when it's cold sounds like it's only firing on two cylinders it's deisel,I've had a new head and head gasket fitted it smokes really bad and gradually picks up revs when...


would need to play with it and try it myself when its cold, but i would be inclined to check out the glow plugs and maybe even have the injectors reset before playing with teh injector pump ,also fitting a non return valve in the fuel inlet line and one in the return in case the valves in the injector pump are starting to play up

Nov 10, 2010 | 1998 Land Rover Discovery

2 Answers

My vitara p reg 2L started smoking on start up, now it is misfiring any ideas where i start, I can't see any spark plugs in the engine-maybe i'm blind or stupid


Many new cars hide most of the engine underneath plastic covers that must be removed to find anything. The smoking problem may or may not be serious, but it's likely that the spark plugs will show black oily deposits on the interior insulators. Cleaning or replacing the plugs will usually make the engine run ok for awhile, but with continued smoking, it will foul the plugs again. If all the plugs are fouled, then look for something like a bad PCV valve that creates crankcase pressure when plugged. Worn out valve seals which allow oil to leak into the cylinders can account for smoking only on start-up. These seals can usually be replaced without pulling the cylinder head. Hope this helps!

May 21, 2010 | 1999 Suzuki Vitara

1 Answer

Won't idle properly, smokes, does not shift right


Black smoke is usually too much fuel to the engine. Check main computer that controls fuel injection and timing.
Blue smoke is usually oil getting sucked past worn piston rings or valve seals.
White smoke = water getting into cylinders, bad head or intake manafold gasket, or cracked cylinder head or engine block.

Aug 04, 2009 | 2002 Jeep Liberty

1 Answer

Oil dripping from exhaust manifold


Either the cylinder head is cracked or, Is it possible that a stud had once been broken off in the hole(s) and when they were drilled out the drill went a bit to deep and punctured the cylinder head? That is about the only reason their would be oil coming out of the manifold stud holes as the holes are not connected internally to anything.

Dec 10, 2008 | 1997 Mitsubishi Galant

1 Answer

Blowing black smoke on acceleration 2.5 exceed turbo intercooler I have a Mitsubishi 2.5 diesel with what sounds to be a similar problem except it happens when you rev the engine suddenly but stops...


1 Inspect Piston Ring Set Worn or broken piston rings. grey_line.gif 2 Inspect Valve Stem Seal Cracked or brittle valve stem seals allowing oil to enter combustion chamber. grey_line.gif 3 Inspect Head Gasket - Performance Head gasket leaking coolant into cylinders grey_line.gif 4 Inspect Fuel Injector Rich injector grey_line.gif 5 Inspect PCV Valve Plugged or damaged pcv valve. grey_line.gif 6 Inspect Engine Worn or scored cylinder block grey_line.gif 7 Inspect Piston Worn or damaged piston. grey_line.gif 8 Inspect Valve Guide Worn valve guides

Nov 26, 2008 | 2001 Mitsubishi Montero Sport 4WD

1 Answer

Misses and lots of white smoke on start up when sitting for 10-12 hours. New glow plugs and injectors. 141000kms. Non return fuel valve fitted between filter assembly and injector pump. Cheers stu.


first question is it smoke or steam ? if if ligers in the air behind you as you drive with little dissipation or if its steam it will dissapear more quickly . either way , head gasket is first . once saw a car do that excessive engine oil put in by owner . giant flumes of white smoke . if you ever want a true smoke scren to get away then adding about 2 to 4 quarts of oil extra . man it is something to see

Aug 01, 2008 | Mitsubishi Pickup Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...