Question about 2008 Dodge Magnum
Spray the hell out of the releqse mechqnism under the hood with WD40. Put a small screwdriver in there and manually pull that release lever in the direction opposite of spring tension.
once opened, spray it more and wire brush.all ruaty areas. Check.latch for damage to make sure its in right position when closing
Posted on Nov 15, 2014
Use a plastic putty knife and pry it up. pry between the hood and front near the center of the car. good luck then lube it with white grease
Posted on Nov 14, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Nov 14, 2014 | 2008 Dodge Magnum
Aug 25, 2012 | 1997 Ford Expedition
Feb 06, 2011 | 2000 Ford Focus
Locate the interior hood-release lever under the dashboard on the driver's side of the interior of the car.
Lift up and toward you on the hood release lever. The lever is connected to a cable that releases the hood. The hood will pop up about 1/2 inch when you pull the lever.
Move to the front of the car and locate the exterior hood-release lever under the front of the hood. It is located near the middle of the vehicle, just beyond where the front edge of the hood meets the body. Lift up on the inner lever.
Lift up on the edge of the hood while holding the inner lever in place. When the hood is up, find the hood prop and raise it, setting its tip in the hood-prop mount on the hood, to hold the hood up while you work in the engine bay.
Nov 26, 2010 | Mitsubishi Lancer Cars & Trucks
Sep 20, 2009 | 2006 Dodge Magnum
Aug 09, 2009 | 2000 Dodge Intrepid
83 people viewed this question
Usually answered in minutes!