Question about Nissan Rogue
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: car dies while driving
I bought my 89 Reatta in 2000 with less than 10,000 miles on it. It ran perfect for a couple of months and then it would just die for no reason. No lights-nothing. This would seem to happen more often as I drove it. I finally zeroed in on the battery connector as the problem. I had my local Goodyear dealer replace the positive cable with a different type of connector and the problem disappeared. It has not ever happened again since replacing the battery cable. I hope this helps you.
Posted on Sep 21, 2008
When you put the jumper cables on, put the key in the drivers door lock and unlock the door to deactivate the factory alarm.
Posted on Nov 03, 2008
Have you had the battery and alternator checked yet? If not, you should. It may be that the control units connected to the CAN aren't being supplied the correct voltage(too low) to operate properly.
CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads required data only.
Component Parts and Harness Connector Location
1. ABS actuator and electric unit (control
unit) E125 (with ABS)
2. IPDM E/R E121
3. Display control unit M95 (with NAVI)
4. BCM M18 5. Combination meter M24
6. Data link connector M22
7. TCM F56 (with A/T) 8. ECM F54
Posted on Jan 11, 2009
SOURCE: car wont start
Sounds like you have a shorted wire causing a drain. I recommend disconnecting the alarm all together which should stop the short so battery can remain fully charged.
Posted on Jul 09, 2009
Tips for a great answer:
Jun 30, 2016 | Cars & Trucks
Nov 08, 2015 | Jeep Cars & Trucks
Mar 11, 2015 | 2012 Hyundai Genesis
CAR NO START PROBLEMS:-----
can be the issue with weak battery or faulty battery or if battery is ok,then
its faulty starter causing the issue.
start to end troubleshooting these problem i suggest you to click the link
below and follow its procedure:-----
What to Do When Car Turns Over But
Nov 28, 2012 | 2012 Hyundai Elantra
Apr 08, 2017 | 2004 Nissan Altima
Jan 06, 2012 | 2005 Chevrolet Colorado
Jan 14, 2011 | 1997 Ford Taurus
Feb 13, 2010 | 2001 Kia Sportage
Sep 04, 2009 | 1999 Toyota Camry
Jun 11, 2009 | 2001 Lexus Gs 300
42 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: