Question about Cars & Trucks

1 Answer

Holden ve commodore engine lights on check engine stability control and power loss

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,679 Answers

Get the OBD codes read to narrow down the sensor/switch , component that is at fault

Posted on Nov 14, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: holden rodeo turbo diesel 2007

I KNOW SOMEONE WITH EXACT PROBLEM.
CONTACT ME ON 0400432502 U CAN SHARE YOUR INFOS.
TA21

Posted on May 07, 2009

  • 60 Answers

SOURCE: Holden Commodore VP, leak in one year old radiator,

Hi there i probably wouldnt use thread tape as those lines you have described are the transmission cooler lines and you dont want theread tape in your trans. remove the radiator make sure the fitting are dry and clean and use sikaflex around fittings and let it dry for 24 hours. this should fix yuor problem. I cant beleive they dont list holden. regards Ben

Posted on Aug 06, 2009

t_aforrester
  • 93 Answers

SOURCE: how to change cool'nt in a VE commodore holden

to change the coolant in any engine you need to firstly remove the bottom radiator hose when the engine is cold not when the engine is hot and drain the whole system.
You then need to get some coolant from your local supplier and it will tell you on the container the proper ratio of water to cool it. Once you have put to cool it in top up the system with clean water.Regards

Posted on Feb 19, 2012

  • 2 Answers

SOURCE: stability track

This is a common problem with GM's. The TPS sensor goes bad in the throttle body. Throws out a message to service Stabilitrac. Not SO!!!
The kicker is that the whole throttle body has to be replaced because the TPS sensor is actually part of the throttle body!!! Costs around $250.00 for aftermarket.

Posted on Oct 23, 2012

alicantecoli
  • 22156 Answers

SOURCE: I got 2005 Holden commodore v6 . How can I change the air con fan control knob pls.

looks more like an opel insignia dash to me but whatever you will need to remove the front centre console facia panel and i think they just clip in .

Posted on Nov 19, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a v6 ve commodore with a HBE engine can I put a HBE engine in it what is the diffrence Ta garry


yes possible
will create electronic miss- matches to be sorted

Holden Commodore VZ VE V6 Alloytec Motor Engine HBE engine code AUD 1 250...

best ve commodore owners forum around
https://forums.justcommodores.com.au/forums/ve-holden-commodore-2006-2013.75
s-l1600-534lvbbiedo0ovj13canlnto-4-0.jpg

Apr 30, 2017 | Cars & Trucks

1 Answer

Toyota lexen 98 ,got hard to start,battery failed ,got jump,drove loss of power gauges stop, speed warning light goes on ,no display,after @5km motor stops ?


speed warning is settable using the mode buttons

a toyota lexen is a VT commodore clone
just badged for holden

the problem could be the (EDIT DFI under the coil packs
check for corrosion and clean contacts

you can get the VT repair manual free off the internet

with a paper clip in pin 5 and 6 of the obd2 plug you can get the fault codes as flashes of the engine check light
two pins top row closest to the drivers door

this is a free owners forum of the VT commodores
https://forums.justcommodores.com.au/forums/vt-vx-holden-commodore-1997-2002.102c4435b9-d8d0-4f15-9a83-a4949c25585d.jpg

Mar 08, 2017 | Toyota Cars & Trucks

1 Answer

Where is the fuel filter located on 2007ve holden commodore


filter is within fuel pump module in tank. Unless you are a mechanic advise take it to Holdens. Not an easy job rear sub frame has to be lowered. A lot of work involved and it may not be your the filter causing the fault.Get a proper diagnosise it may save money in the long run. you can always get a quote 1st.

Feb 05, 2017 | Holden Cars & Trucks

1 Answer

Have Holden Cruze 2010 JG. Malfunction indicator lamp comes on and Electronic stability control and traction control system off both light up!Car has spent more time getting fixed then driving it


That's a common issue with the Holden cruz as well as as the Ve commodore. I've had many come in with this issue and most of the time there is nothing wrong other times a bit of dirt/grit builds up on a sensor and throws up an error being the light and ESC/TC,It just needs resetting with a scan tool. Some places will do it for nothing others will charge depends on the mechanic!. It only takes a minute

Oct 06, 2016 | Holden Cars & Trucks

1 Answer

We have a 1999 commodore vt sedan an we just put new battery an alternator in it last week an the battery light just came on an now it wont go offcan anyone help please


The battery is charged by the alternator which has computer (PCM)controlled voltage regulation, this makes for a much more precise engine and stable voltage for the engine management system.

Mar 25, 2014 | 1998 Holden VT Commodore

1 Answer

How to change cool'nt in a VE commodore holden


to change the coolant in any engine you need to firstly remove the bottom radiator hose when the engine is cold not when the engine is hot and drain the whole system.
You then need to get some coolant from your local supplier and it will tell you on the container the proper ratio of water to cool it. Once you have put to cool it in top up the system with clean water.Regards

Feb 19, 2012 | Cars & Trucks

1 Answer

How to fit a tow bar to a ve commodore


How to fit a tow bar to a ve commodore

Jan 28, 2012 | 2006 Holden Commodore SS

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

393 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...