Question about Cars & Trucks

1 Answer

Loose gas padel

Is it dangerous?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 14,585 Answers

Yes it is. You will most likely get rear ended.. No pedal when you need it most.

Posted on Nov 14, 2014

Testimonial: "Yes, I'm taking the car in for repairs in the morning. We use Mike's Tire & Auto in West End, NC. Thank you."


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

204 Jeep Gr. Ch. i 6 at speed, take my foot off gas and it pulls right, give it gas, pulls back to left. Why?

a very serious problem
do not drive it like that,
tires inflated
wheel bearing loose
tie rods about to fail and huge danger,
ball joints,
get the car checked now. great danger awaits..

Mar 11, 2017 | 2004 Jeep Grand Cherokee

1 Answer

Hello sir my car chevrolet equinox 2006 is gone safe mode as i press gas padel it mot gas proble it show me error p0700 and p1125 .so wht i do

Did you check the throttle positioning sensor mounted on you engine? This can usually be found near air intake on engine. There are two sensors, one on the gas pedal and one on the engine itself. May videos on on testing.

Sep 02, 2016 | 2006 Chevrolet Equinox

1 Answer

When press break padel stering shakes

What make? What model? This could be caused by brake problem, worn front end part (bad ball joint can be very dangerous), or even something simple such a worn tie rod end. If you want to test these things, put jack under lower A arm on one side and just lift the weight off the wheel and put on jack stand. Have a helper wiggle the steering wheel while you look underneath for loose motion at some part. Nothing? Then grab wheel at sides and try to wiggle wheel. Now repeat at top and bottom of wheel. A bad steering damper can also cause this. If you are not experienced at front end work, have alignment shop check things out. A bad ball joint can break and cause you to lose control of the car. GET IT FIXED asap.

May 19, 2015 | Cars & Trucks

1 Answer

Break padel is hard to push and gas is geting inti the breakbroster

Are you sure it is gas, and not brake fluid, from a failed master cylinder? I don't see how gas could get there from the vacuum line from the intake manifold.

May 03, 2012 | 1989 Ford Ranger

1 Answer

Nissan 1999 Sentra XE jurks sometime.

There are a few components that could cause your problem. Your Idle air control valve could be faulty,or your mass air flow sensor could be damaged or just loose. Last thing but not least Your EGR Valve could be stuck in open position or Leaking (Bad Gasket or Loose. The only other thing it could be is a Bad Fuel Pump, Or Plug Pump Stalking.

Feb 21, 2012 | 1999 Nissan Sentra

1 Answer

When I push my foot on the accelerator the car does not go faster and the throttle control system light on the dashboard remains lit. How can I fix this problem

there is a sensor on the gas padel that has went bad and needs replaced and it is right on the side of the padel its self

Dec 07, 2010 | 2008 Jeep Cherokee Grand

1 Answer

Toyota Camry 1994 xv10

After a long drive, if AC is still on while turning off the engine, next time, it may create trouble while starting.
The best way is to turn off engine and press gas padel for at least 10 minutes. Dont turn on the engine while pressing gas padel. Then try to start but dont press gas padel. Car should start if problem was due to unburned gas left inside cylinders..

Jul 02, 2008 | 1994 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides