Question about Cars & Trucks

1 Answer

Is the oil well the same for the transmission on a 2006 vtx1300

The shift make a lot of noise when shifting mainly in low 1st gear.is the transmission well the same dip stick gor the tranny ?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 14,585 Answers

Yeah, both the same. You have a sun gear/ planetary gear problem. Basically a transmission rebuild.

Posted on Nov 14, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: 94 dodge neon auto tranny

Hi,

Here is some possible reasons why your transmission is having those problems .

* The gear shift linkage is binding
* There is an internal problem in the transmission
* The throttle cable is broken or disconnected
* The vacuum modulator on the transmission is faulty or the vacuum line is damaged
* The electronic transmission control circuit may be faulty

Posted on Feb 26, 2009

  • 158 Answers

SOURCE: transmission wont shift

check the kickdown/throttle valve cable. It may be bound up and stuck in the maximum position giving you extremely late shifts.

There ISN"T any modulators or vac lines on any Chrysler automatics

Posted on Apr 03, 2009

csmock132
  • 4669 Answers

SOURCE: 1997 Suburban 4x4 5.7L Transmission whines until it shifts

You rear planetary set is worn from a restricted cooler.

Posted on May 06, 2009

  • 2 Answers

SOURCE: 1997 sL1 Saturn manual transmission hard to change gears

The dipstick is behind the battery, below the master brake cylinder and is not the clutch reservoir. It has a red flip top handle instead of a ring like most dipsticks. It was hard for me to find due to engine grease. I had the same problem and was able to see that I was low on fluid (only a little) and adding fluid helped the problem. Questions? kurt1431 at comcast dot net.

Posted on Jun 29, 2009

juncro
  • 467 Answers

SOURCE: 1997 chevy k1500 pickup-transmission shifting problems

check the fluid level in the transmission, also change the transmission fluid and filter

Posted on Jul 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission making loud grinding/sucking sound, doesn't go when in drive or reverse


Is it an automatic John? When was the last time you checked the level of your ATF (automatic transmission fluid)?

There are many different types, so make sure you get the right one.

If it is a manual shift, check the gearbox oil level. If that is OK, you need a transmission specialist. Look in Yellow Pages.

Nov 26, 2015 | 2000 Pontiac Grand Am SE

1 Answer

The Pacifica will not shift past 4th gear. It shifts normally through 1st, 2nd, 3rd, and 4th gear. Their is no high reeving RPS, no clunking, no lurching. It will just not shift past 4th gear.


is there an OD button that might have been pressed .if it has lots of miles on it it could be needing a flush job . last one I got done was around 100.00 at jiffy lube.

Nov 12, 2015 | 2005 Chrysler Pacifica

3 Answers

I have a 2001 elantra. What would make it stay in reverse and 1st gear.it is a manual transmission


when you put it in reverse,first thing you feel a spring.after tthat you lift,
a security plate,this plate prevent you from going reverse into 1 gear.
cause the axel turn a little further when you allreddy has stop the car.
this takes two sec.thats why when putting it in reverse after you feel the spring you wait two seconds,then puch al the way in reverse.

Jul 26, 2014 | 2001 Hyundai Elantra

1 Answer

Manual transmission


The short answer, yes. M46 models with the type J or P overdrive (depending on year and market) require a certain level of oil in the overdrive. Additionally, the overdrive is a lot like a standard automatic transmission with one gear range in theory of operation. Therefore, the hydraulic properties of said transmission do come into play here, line pressure, shifting pressure, accumulator and piston function all work together to engage or disengage the unit. Always ensure the unit is disengaged before downshifting and of course, shifting into low reverse.

Feb 07, 2014 | 1988 Volvo 740

1 Answer

2006 ford fusion solenoid 2 mechanical failure the trains now only shifts between 1st, 3rd and reverse respectively. the fluid was burnt pretty bad so i did a full system flush it shifts smoother but still...


solenoids can be replaced with out affecting the transmission
however the burnt oil indicates that the transmission may need a band/ clutch pack adjustment
shifting problems are servo/ solenoids , TR sensor , VSS sensor or the TCM

Jun 23, 2017 | BMW X7 Series Cars & Trucks

1 Answer

My truck will not shift past 2nd gear. It shift 1st and 2nd and R. No matter what gear you manually shift into it will not go past 2nd gear.


Your transmission should have shift solenoids in it. You could have one that has failed or you could have other internal problems. To acess the shift solenoids you must remove the trans oil pan. If the oil is dark or smells kind of burnt I would suspect bigger problems than a shift soleniod. Also inspect the pan for chunks and a lot of debris. A little bit is normal but more than that is not good.

May 12, 2011 | 1993 Chevrolet K1500

1 Answer

Hummer H3 Losing power when shifting from 1st to 2nd gear.


as odd as this may sound, try replacing the fuel filter.

Aug 17, 2008 | 2006 Hummer H3

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...