Question about Cars & Trucks

1 Answer

2010 sebring chrysler especial edition everytime i start up they got a noise sound in my engine what is that? My engine is 3.5

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 90 Answers

U need to b way more descriptive about the noise to get helped out

Posted on Nov 13, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: CLICKING NOISE WHEN TRYING TO

My daughters did the same thing 2001 Sebring--red cable under manifold lose try moving it toward you a little this cable goes to the starter and runs to the battery thats located in wheel well of all places

Posted on Sep 18, 2008

Intimowdater
  • 1 Answer

SOURCE: Chrysler Sebring Problem

along the buttom of the rocker pannel there is a seam that gets bent from jacking in the wrong place ,that seam is where the drains are,screw driver and pry apart at the drain ,the drain is a tube shaped bump molded in the steel on the inside part of rocker panel

Posted on Oct 26, 2008

dealt_soul
  • 296 Answers

SOURCE: 2003 chrysler sebring

Could be starter, or neutral switch in the tranny.

Posted on Jan 18, 2009

  • 2 Answers

SOURCE: replace air filter 2002 Chrysler Sebring convertible

you need to loosen the clamp on the throttle body and unplug the map sensor then there are two clips on the other end pull that out and you should be able to pull the filter out you don't need to take the box off.

Posted on Apr 28, 2009

polarcycle
  • 1392 Answers

SOURCE: 1999 chrysler sebring, transmission doesnt shift

find out why the light is on and fix it. This will most likely be a trans wiring issue that the light is on for.

Posted on Jul 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Runs rough when it's warm. comes and goes. has a 2.7. and then a 99 dodge carvan with a 3.3 does the same thing.


Chrysler Sebring Questions - Car running very rough ...

www.cargurus.com > Questions > Chrysler > Sebring

CarGurusMar 27, 2011 - It seems after car gets to a certain temperature it runs very rough. ... 2011 at 12:16 PM about the 1998 Chrysler Sebring 2 Dr LXi Coupe ... it.one day it washot out and it was running sluggish with rough idle.and ... I changed the altnator and battery its runs like its brand-new.now ... 2002 Chrysler Sebring LXi.

Chrysler Sebring Questions - Engine Power Loss After Car ...

www.cargurus.com > Questions > Chrysler > Sebring

CarGurusNov 3, 2011 - Engine Power Loss After Car Is Warmed Up - Major loss of power after car has ... When vehicle is cold runs ok, sometimes a little rough but not bad. Full power. Allowed vehicle to run for over 45 minutes last night at idle, died on its own, car sat approximately 20-30 minutes. ... 2002 Chrysler Sebring LX.

* Chrysler Sebring/200 Convertible Club * • View topic - Rough ...

www.sebringclub.net/board/viewtopic.php?p=69097

Dec 29, 2006 - 5 posts - ‎3 authors
However, the vehicle still suffers from rough idle under certain conditions: ... been resolved (I don't think he noticed that it happened only when warm though). .... The test will tell you its general condition without having to dig it out of the fender, ..... Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group rough ...
15 posts
May 24, 2010
Low idle rpm
15 posts
Mar 8, 2007
More results from www.sebringclub.net

Jan 01, 2016 | 2002 Chrysler Sebring

1 Answer

Noise in engine area


probably a water pump bearing if the hose goes to the radiator or power steering pump. if the hard hose goes to the steering

Aug 14, 2014 | 2010 Chrysler Sebring Limited

1 Answer

2002 chrysler sebring blower motor is loud but works


Sounds like debris in the blower assy. Probably leaves, or my favorite - kids\' candy wrapper. Start with the thinnest extension you can find for your vacuum. Make sure the engine is off, blower off, key off. Squeeze it down through the vent nearest the blower motor. Wiggle it around to get as far into the blower assembly as possible. You may have to pull leaves out with the hose, they\'re too big to suck up.

Jan 29, 2013 | 2002 Chrysler Sebring

1 Answer

2004 sebring won't start at all


sounds like you might have lost the altanator. Check the battary to see if it is very low, if so it was running of the battery and not the altanator. try charging the battery and see if it will run. If it does, checkthe voltage on the battery. it should be above 13 volts when runnig.If not it is the altanator.

Sep 15, 2012 | 2004 Chrysler Sebring

1 Answer

2006 Chrysler sebring High Pitch Noise Screeching Sound


The belt is slipping or the compressor and/or clutch is bad.
If the compressor won't turn freely with the engine off, it may be locked up which will make the belt screech.

Jun 27, 2012 | 2006 Chrysler Sebring 2.7

1 Answer

Engine makes squeeling noise when first started


Check the belts are still tight enough, sometimes they slacken off with use and then start to squeal, especially in cold/damp weather.

Jan 13, 2012 | 2004 Chrysler Sebring

1 Answer

I have a 99 Chrysler Sebring. My brother changed my water pump and timing belt. Now it won't start. He tried to reset the timing, but he can't get the steering bracket off to check the top timer. The motor...


Your Chrysler has what is called an "Interference" engine. This means if the Timing is off the Valves will hit the pistons. That is the "sounds like something is hitting inside" noise.
You should NOT continue trying to start you car until the timing of the cam shaft and crankshaft is guaranteed correct. The valves and pistons may already be hurt, but if you get everything timed right you may get lucky. Really nothing to lose by timing it right and see what happens.
I am sad about this situation, especially when a brother is just trying to help out.
Wayne

Feb 09, 2011 | 1999 Chrysler Sebring

1 Answer

Wiring for IAT sensor connector on 2010 Chrysler Sebring, 3.5L engine.


i need a pic of the location of the iat sensor for a 2010 chrysler sebring limited

Sep 04, 2010 | Chrysler Sebring Cars & Trucks

1 Answer

Clicking noise under hood of 2001 Chrysler Sebring


Sounds like you have a dead battery. You either need a jump start with jumper box or clean battery terminals and see if that works

Dec 02, 2008 | 2001 Chrysler Sebring

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...