Question about 1995 Ford Aspire

1 Answer

Ok I have a 1995 ford aspire im trying to figure out how to replace the oil pump

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Ford Master
  • 1,493 Answers

Disconnect the motor mounts and jack the engine to remove the oil pan. Remove the oil pan, replace the oil pump you'll find at the end of a pick up tube, replace the pump and put the pick up tube back on the new pump making sure it's in the same low position it was when removed, replace the oil pan gasket and put the oil pan back on, lower the engine and put the motor mount bolts back in. Put in the proper amount of oil and go.

Posted on Nov 22, 2014


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 79095 Answers

SOURCE: is it hard to replace the oil pump in a 1995 ford

very difficult job, the engine mounts must be disconnected and the engine raised off the mounts, a real pain on the ground, u will need a good floor jack and safety stands, the job will take around 4-6 hours.

Posted on Aug 10, 2009

  • 437 Answers

SOURCE: I have a 1995 540I bmw..fuel pump doesn't

if you have 12 volts at the pump and it doesn't run it's the pump.
If you have 12 volts at the pump it means the relay is doing its job and the fuse is ok

remove the pump and run 12v to it directly from the battery to test the pump.

Posted on Nov 05, 2009

  • 262 Answers

SOURCE: where is the fuel pump on a 1995 ford aspire

The pump is in the tank. 32454e8.gif Hope this helps. If you need further assistance just ask! WFServices...

Posted on May 12, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I need to change a fuel pump and filter in a 1995 ford Aspire 1.3 litre fuel injected 4door hatchback and all I'm looking for is a schematic.

Have you tried one of the aftermarket automotive repair manuals such as Haynes ? ( check spelling ) I find them to be excellent for the do-it-your-selfer.

Jul 13, 2011 | 1995 Ford Aspire

1 Answer

Im just trying to figure out how to replace the ckp sensor and i dont know exactly where its located

The Crankshaft Position sensor is by the Oil Filter, or right above the oil filter. Here is a picture:

Here is a picture of the CKP Sensor:

Feb 17, 2011 | 1995 Eagle Talon

2 Answers

Where is the fuel pump on a 1995 ford aspire

The pump is in the tank. 32454e8.gif Hope this helps. If you need further assistance just ask! WFServices...

May 09, 2010 | 1995 Ford Aspire

1 Answer

My car is not pumping oil a 1997 Ford Taurus I replaced the oil pump

Im guessing you need to replace the gear on the camshaft position sensor! it also drives the oil pump. its a common failure its made of plastic or fiber. im sure you also have a camshaft position sensor code. replace that gear and hopefully your motor is ok! good luck!

Mar 05, 2010 | 2005 Ford Taurus

1 Answer

Fuel pump fuse keeps bpowing

the fuel pump is drawing too much current and is starting to go. Assuming you have correct size fuse. I would replace it.

May 13, 2009 | 1995 Ford Explorer

1 Answer

1995 aspire wont start

with little infomation i would say that you need to replace the fuel pump or you shoul start with the fuel filter then if that doesnt help try the fuel pump replacement . see when you push it motor is turning faster than starter motor meaning need less fuel to start it so when you push it motor is winding faster than with starter motor good luck with this project

Jul 01, 2008 | 1995 Ford Aspire

Not finding what you are looking for?
1995 Ford Aspire Logo

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

79077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5677 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides