Question about 2005 Volkswagen New Beetle

1 Answer

2005 new beetle 2.0 . So I just put new plugs and wires on. New ignition coil and new fuel pump and new fuel filter. Car starts first thing in the morning and If I turn the engine off and try to restart the car again right away it turns over but car does not start right away. normally, I have to wait about 5 minutes and then it cranks. ???????

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Check your starter this happens when the starter starts to go
It gets over heated and won't turn over till It cools

Posted on Nov 12, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

1984 Chrysler new Yorker 2.6l wont start. Replaced the fuel filter, new spark plugs and wires, new fuel shut off switch, new relay delay fuse, and a new ignition coil, oh yeah and a new starter. Ever hear...


Here's a quote from amy Chilton's manual for 1980-1987.

"Several types of fuel filters are used. One is located in the fuel tank of all the vehicles and is part of the fuel guage assembly. Second is a sealed paper element, in-line unit; mechanical system- located on the engine (above the fuel pump) or electrical system- located in front of the fuel tank. Third is a paper element, in-line fuel filter/vapor separator, housed in a fuel resevoir. Normally, the in-tank filter does not require changing. If it does, the fuel tank must be removed. "
This thing you describe sounds like the typical Chrysler in-line filter of its day. It is nothing more than the same generic in-line plastic see-thru filter you buy for your lawn mower except in the 70's and 80's it was covered in metal and had a Chrysler part number. A lot of guys added an extra filter in those days, it wasn't the best system. I would remove the outlet line and turn the fuel pump on, see if you get fuel. Replace if needed.

Nov 02, 2013 | 1984 Chrysler New Yorker

1 Answer

Car wont start


replace fuel filter.listen for fuel pump operation with ignition switch on position for 3 seconds should hear fuel pump running should have humming or churling noise if so fuel pump working if hear no noise fuel pump faulty or could have blowed fuel pump fuse or bad relay.if fuel system okay problem could be ignition timing off due to worn broken timing belt.could have faulty ignition module.bad crankshaft sensor or camshaft sensor best to have vechicle code scan first before buying alot of new parts.could have bad ECM. many things will cause no start problems i.dont know model type vechicle.could have bad spark plugs wires. distributor cap and rotor could be bad.ignition coil could be bad.

Mar 28, 2013 | Cars & Trucks

2 Answers

2005 volkswagon beetle won't start


There are 3 simple ways to troubleshoot this: Gas, Spark, or Air. The car is not getting enough of one of these. If it turns over you have battery power.

Gas - Is there enough?
Spark - Remove each plug and lay it close to the motor and have someone turn it over while you verify the spark for each cylinder.
Air - Verify the air filter is not clogged

May 06, 2012 | 2005 Volkswagen New Beetle

1 Answer

I put new spark plug and wires ,new battery so what should I do next to make start because it's cold here in chicago


WHEN TROUBLE SHOOT CAR CHECK FOR SPARK AT PLUGS FIRST IF NO.CHECK IGNITION FUSE TO IGNITION COIL OR COILS AND IGNITION MODULE.IF FUSE GOOD CAR NEED SCANNING FOR CRANKSHAFT SENSOR FAULT OR IGNITION MODULE FAULT.IF IGNITION SYSTEM OKAY CHANGE FUEL FILTER IF NOT BEEN CHANGED LONG TIME..CHECK TO SEE IF YOU HEAR FUEL PUMP RUN IN FUEL TANK WHEN YOU TURN IGNITION KEY ON FOR 3 SECONDS.THE FUEL PUMP WILL TURN ON 3 SECONDS THEN TURN OFF.IF YOU HEAR NO FUEL PUMP.CHECK FUSE AND RELAY.IF BOTH GOOD.STILL HAVE CAR CODE SCANNED FIRST.

Jan 24, 2011 | Chevrolet Blazer Cars & Trucks

1 Answer

1997 Mazda 626 2.0 DOHC New timing belt, dist., wires, plugs, crank sensor, air filter, cats, air intake sensor and sundry other little things. It dies suddenly on the freeway. It runs perfectly otherwise....


When the car stops driving, at that time check the starter, if its got very hot, then this can be starter over heating issue. There are many other things to be checked.

Try this troubleshooting: ----If your engine cranks normally but will not start because it has no spark, or it stalls and won't restart because it has no spark, the problem may be due to any of the following:

1) A bad pickup inside the distributor, a stripped distributor drive gear (common problem with plastic distributor drive gears), broken, loose or corroded wires from the pickup to the ignition module or PCM. 2) A bad crankshaft position (CKP) sensor or broken, loose or corroded wires from the sensor to the PCM. 3) A bad ignition module or A bad ignition coil .

4) A bad rotor or distributor cap (cracks or carbon tracks that are allowing the spark to short to ground). 5) Faulty ignition switch.

------------

You can also do a test to confirm the problem .The procedure to do the test is as follows: --

If your engine has spark plug wires, disconnect one of the plug wires from a spark plug and place the end of the wire near a metal surface on the engine. Then insert a small Phillips screwdriver into the end of the wire (the plug boot), or a small bolt or nail to provide a conductive path. Then crank the engine and look for a spark to jump from the screwdriver, bolt or nail in the end of the plug wire to the engine. If you do not see a spark, there is an ignition problem.

OR---If your engine has a coil-on-plug ignition system with no plug wires, In that case remove one of the coils from the spark plug and insert an old spark plug, a spark plug tester or a screwdriver into the end of the coil. Ground the spark plug or plug tester to the engine, then crank the engine and look for a spark. No spark indicates an ignition problem. Possibilities to be checked in this problem are as follows:-- If the engine has no spark, check for voltage at the coil positive terminal when the ignition key is on. If NO voltage, then problem is on the trigger side of the coil (pickup, crank sensor, ignition module or primary wiring circuit).But If there is NO voltage at the coil itself, then in that case the problem is on the supply side (the ignition switch or ignition wiring circuit). But if the coil has voltage, then problem may be a bad high voltage output wire from the coil to the distributor, hairline cracks in the coil output tower, or cracks or carbon tracks inside the distributor cap or on the rotor. ------A car that cranks over but doesn't start, in many cases will be due to a bad fuel pump, a broken timing belt, an inoperative cam sensor or crank sensor. Also these problems are related to faulty spark plug. Check the spark at spark plugs when you start the car. Do you notice any spark. Actually you should see. If in case there is no spark then it's a spark plug problem. Also the coil pack gives power to spark plug. So check the voltage at coil pack. It will show 12 volt. If there is no voltage noticed at coil pack then its faulty coil pack that has to be replaced. If all the possible options checked out ok then check the car starter. The starter gets power from battery to start the car. If the starter is faulty then it will not let the car to start. Also check and confirm that there is fuel in the car. If its very low fuel then in some cases this causes the problem. Also check and confirm that fuel pump is functioning properly and the fuel filter is not clogged. One of the easiest ways to check for a fuel pump related problem is to spray a little starting fluid into the air intake while trying to start the car. If the car starts momentarily, then there's a good chance the fuel pump is not working or the car is out of gas. You can also listen for the fuel pump's humming sound when the key is first turned on. Also if a inoperative fuel pump is suspected, a good technician will always check to verify there is power and ground being supplied to the pump, to eliminate the possibility of a bad relay or electrical issue. Fuel pressure can be checked with a pressure gauge and if there is pressure, pulse can be checked at the fuel injectors in several ways including the most common, with the use of noid lights. If the injectors don't have pulse the engine won't start.---------- This troubleshooting tips will help you to solve the problem. Thanks. Helpmech.

Jan 07, 2011 | 1997 Mazda 626

1 Answer

Wont start


is the your car engine cranking when you try to start, first check spark plugs ignition coils, remove one ignition coil and spark plug fix the spark plug in to the ignition coil then connect ignition coil to wiring and keep spark plug body touching on ground of engine head mettle parts, ask some one to crank engine then you can see is the plug sparking or not, do the same way to all the coils and plug otherwise you have to buy a ignition spark tester, is the all the coils and spark plugs are OK then check the fuel pump, it's sitting in under rear seat, before that do one thing disconnect oxygen (O2) sensor wiring and crank engine, the thing is if your oxygen sensor completely dead fuel pump will stop working, if engine start after disconnect O2 sensor, replace new O2 sensor, otherwise need to check fuel pump relay fuse and fuel pump. is this information helped you? please vote me and give a comment.

Oct 15, 2010 | 1998 BMW M3

1 Answer

Car didn't want to strart, had low fuel pressure. Replaced fuel pump, filter and fuse and it still doesn't start. 2005 Sunfire.


There are some possibilities which you will have to check in this case:--
1) First of all check the power and voltage to the battery. With meter it will show exact 12 volt if the battery is charged. If the voltage is less get the battery charged at local auto repair shop. If the battery is internally drained and not getting charged then its time to replace the battery.
2) When you crank the car do you see spark coming at the spark plug? If no then its time to check the spark plugs and coil pack. If the spark plugs are not worn out and looks new then its time to check coil pack. The spark plug gets power to spark from coil pack.
3) The other thing to check in this case is the starter solenoid of the car. If the battery is charged and you start the car then it gives power to the starter to start the car. But if starter is faulty or not connected properly then car will not start.
4) The other thing to check in this case is fuel in the car. If there is fuel in the car then check the blockages in the fuel pump if the fuel pump looks proper then check the fuel filter above the fuel pump.
5) If all the above possibilities mentioned above checked out OK/perfect then it’s a electrical issue and the wiring's in the car needs to be checked. The car gets power from the battery to get started. so the wires from battery needs to be checked one by one.
Thanks. Keep updated for any more query. You can rate this solution and show your appreciation.

Aug 17, 2010 | 2005 Pontiac Sunfire

1 Answer

New fuel pump and still wont start


1 Inspect Battery Battery Discharged or Faulty. 2 Inspect Battery Cable Corroded, Broken, Shorted or Poorly Connected Battery Cable. 3 Inspect Distributor Cap Distributor Cap Cracked or Burned. 3 Inspect Fuel Filter Clogged or Dirty Fuel Filter. 5 Inspect Coil - Ignition Faulty Ignition Coil. 6 Inspect Wireset Worn, Damaged or Faulty Spark Plug Wire(s). 7 Inspect Spark Plug Incorrectly Gapped or Fouled Spark Plug(s). 8 Inspect Starter Starter Motor Faulty. 9 Inspect Fuel Pump Low Fuel Pressure. 10 Inspect Solenoid Switch Faulty Starter Solenoid Switch. 11 Inspect Relay - Fuel Pumpat Faulty Fuel Pump Relay. 12 Inspect Fuel Injector Pressure Regulator Faulty Fuel Injector Pressure Regulator. 13 Inspect Ignition Switch Improperly Connected or Faulty Ignition Switch. 14 Inspect Starter Drive Faulty Starter Drive. 15 Inspect Fuel Injector Dirty or Worn Fuel Injectors. 16 Inspect Fuel Pump Strainer Clogged or Dirty Fuel Pump Strainerat. 17 Inspect Engine Control Computer Incorrect Operating Information Being Delivered and Sent From The EEC. 18 Inspect Fuel Tank Fuel Tank Empty. 19 Inspect Carburetor Carburetor Flooded or Faulty Choke. 20 Inspect Distributor Worn, Loose, or Incorrectly Installed Distributor.

May 22, 2010 | 2000 Dodge Caravan

1 Answer

2000 beetle- starts and then dies. think its the fuel filter?


YEP IT COULD BE STOP UP FUEL FILTER. BAD FUEL PUMP RELAY OR.BAD FUEL INJECTOR.CHECK THE WIRES GOING TO THE IGNITION COIL AND ALTERNATOR MAKE SURE NOT LOOSE.IF CHANGING FUEL FILTER DONT HELP.IF SPARK PLUGS + WIRES GOOD.HAVE CAR SCANNED COULD BE IDLE SPEED CONTROL BAD.

Mar 21, 2010 | 2000 Volkswagen Beetle

Not finding what you are looking for?
Cars & Trucks Logo

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...