Question about 2005 Peugeot 307 1.6

1 Answer

My Peugeot 307 stalled, it no longer displays mpg and the button at the end of the wiper stalk now only toggles between Radio and CD. How do I reset this, and get back the mpg display?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Peugeot Master
  • 1,207 Answers

Use an original Chip Lexia-3 lexia3 V48 PP2000 Diagnostic Tool, It can work well for Peugeot cars.

Posted on Nov 15, 2014


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 215 Answers

SOURCE: "when do i change the cam belt on a peugeot 307 sw diesel"

usually you should do it for peugeot diesel at 122000 miles along with water pump and the tensioner roller that runs under the cambelt too. But to be on the safe side do it at 100000 and save the fortune.
It took me (DIY job) about 6-8 hours as i wanted to save 450 pounds.

Posted on Sep 04, 2009

  • 17970 Answers

SOURCE: how can i reset the engine management light on


The following is from bot seems to be valid for all models:
1. Switch the Ignition Off
2. Press and hold the tripmeter (mileage reset) button on the dash
3. Now switch the ignition to the ON position
4. Keep the button pressed for 10 seconds
5. The display will read '0' and the service symbol will extinguish.

Also, can disconnect the battery for a few minutes. This should clear the code. Unless you have fixed the problem that set the code it will come on again.

I hope help you with this (remember rated this help) Good luck.

Posted on Oct 06, 2009

  • 583 Answers

SOURCE: Peugeot 307 diesel 307 - Unblock diesel filter

if it says the diesel filter, then that is what it means,a fuel filter.normal service requirement on any vehicle and can be done for small dollars at any garage

Posted on Dec 04, 2009

  • 25 Answers

SOURCE: how to reset peugeot 307 electro-power steering?

but did you buy it new? if yes you need to go to a peugeot dealer to have programmed, if not and broken you have to replace it if you want to be sure disconect the cable from power steering motor and you will find all full of oil ciao

Posted on May 28, 2010

  • 1 Answer

SOURCE: what does this display message mean "plip battery

what does the word plip battery spent mean on a peugeot 307. It says that when i first turn on the ignition.

Posted on Dec 15, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:


Peugeot 307 service reset procedure

  1. Press and hold trip reset button.
  2. Turn the ignition on.
  3. Continue pressing the button while countdown is displayed on the odometer.
  4. When countdown reaches 0 release the button.
  5. Turn the ignition off.

on Dec 20, 2015 | Peugeot 307 Cars & Trucks

1 Answer

What does . Cons1 13.4 mpg mean

driver information display is telling you the average mpg since the meter was last reset , to set it again if you have just got the vehicle press and hold the button on the end of the indicator stalk (ignition on)untill it displays dashes

Jan 31, 2013 | 2004 BMW X5 3.0i

1 Answer

Why have I no radio reception on peugeot 307?

go step by step to find the fault.
check antenna connection behind the radio
check roof aerial and wire connection underneath it.
Take an old radio's antenna and connect it to your car's radio antenna input and check whether your car radio is working properly.

Apr 15, 2012 | Peugeot 307 Cars & Trucks

1 Answer

How to set the clock on a 2000 BMW 325i

Hi, on your signal stalk (left side), see the "BC" button?

Push this BC button repeatedly, and you will notice the display inside your dash go from:

Time-Temperature-MPG-Range-Ave speed-(and back to)Time.

Notice there're also 2 buttons (stalks) sticking out from your dash.

ONLY while the display is showing the TIME (not anything else), TURN and HOLD the right button inside the dash. You will find that the time will adjust on both your dash and your radio display. It will move faster as you keep holding on.

You may also switch from 24hr format to AM/PM format by pushing the right button instead of turning it.

Jun 02, 2011 | 2001 BMW 325

2 Answers

Hi i have just had my car Renault Clio on a 06

- By dancer23 on Feb 18, 2010 -

Earlier i posted a question requesting how to switch off the service light on my Renault Clio, i have found an answer to thios, as follows.
How do you reset the service indicator light 2007 renault clio?

Turn on the ignition, but don't start the car. On the right stalk there is a toggle switch that hinges up and down, and is used for going through the different features of the display. When the display shows 'Service Due' press and hold the top part of this switch for 10 seconds until the dispaly resets and it shows 30,000km or whatever until next service.
Turn on the ignition, but don't start the car. On the right stalk there is a toggle switch that hinges up and down, and is used for going through the different features of the display. When the display shows 'Service Due' press and hold the top part of this switch for 10 seconds until the dispaly resets and it shows 30,000km or whatever until next service.

all of the above is correct apart from pressing the toggle button. if you instead press the bottom toggle button for 10 seconds the display will start to flash. Keep button depressed and 5 seconds later the service counter will reset.
I know this works as i have just done it myself,
I hope this will help many others .

Feb 18, 2010 | 2006 Renault 181

1 Answer

The mpg display has a fault.

you have switched the trip computer to instantaneous fuel consumption rather than average.the switch on the end of the wiper the switch until you get back to average consumption ,i think it shows a circle with a line through it from memory

Jan 21, 2009 | 1995 Volkswagen Passat

1 Answer

My Peugeot 406 radio is losing signal intermittently.

Mine did the same .. Peugeot garage quoted £300+ & 6 weeks to replace it (ha ha)

I pulled it out, got a 'facial panel' from Halfords (about £20) and a cheap radio from Agros ...

Only problem is the 'stalk controls' (on the steering wheel) no longer work == Halfords make radios that are 'compatible' with 'industry standard' stalk controls but you will have to get them to fit it since the connectors aren't too standard and you will want Halfords to sort it out ...

Nov 19, 2008 | 2005 Peugeot 405

1 Answer

Main computer display panel Audio estate A6 5 years old

There is a button on the bottom of your windshield wiper control arm. Push it once to turn on or off the computer display. Hold it to clear the current information. At the end of the arm is a "up/down" button for changing which info you would like to see (miles to empty, current mpg, etc.)
Happy driving!

Sep 05, 2008 | 2007 Audi A6 Avant Wagon

Not finding what you are looking for?
2005 Peugeot 307 1.6 Logo

291 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

mike hayward

Level 2 Expert

279 Answers

Wahs Team

Level 2 Expert

215 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides