Question about Cars & Trucks
Check all fuses in the engine bay, under dash, push type blade fuse needs replacement, 10 amp
Posted on Nov 11, 2014
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The tail lights and the brake/turn lights use the same bulb but, there is 2 filamants in the bulb. One for tail lights and one for brake/turn lights. So just because the brake lights and turn signals work doesn't mean the bulbs are good. If bulbs are good you can check to see if there is power getting to the tail light assy's by unplugging the connector at the assy and using a test light probe the connector (harness side) with the headlights on. If you are getting power to the assy the test light will light. To make sure, turn off the headlights and test light will go off. Hope this is helpful. Good luck.
Posted on May 29, 2009
there is a special tool for this job but I have cheated on this but you ned to be careful when doing this.The wishbone shaped mount on the front going from motor to front of vehicle, remove and it allows the motor to tilt.
Posted on Jun 19, 2009
Before going ahead and spending money on a new module, test it first. The module is located under the steering column. You'll find a Brown wire on one of the connectors (i just looked at a wire diagram). Do no disconnect anything. Back probe the brown wire, which is the power feed to your park lights. With the lights off, there should be 0 volts on you voltmeter. Turn the park lamps on, There should be 12V. If there is not 12V, disconnect the connector and try to check voltage at the pin that feeds to the brown wire, if still not 12V, replace the module. If you do get 12V, then module is ok, find where the 12v is being dropped before making it to the lamps.
Posted on Aug 09, 2009
need to take car somewhere to have the code read with a scanner,try parts stores first some will do it for free if not the dealers have them
Posted on Sep 15, 2009
a lot of times GM from the late 90's and even present will put the fuses on the ends of the dash, you will have to have your door open to gain access to them, this was to prevent people from playing with their fuses while driving.
Posted on Jun 14, 2010
Tips for a great answer:
Nov 28, 2014 | 2000 Buick Park Avenue
Nov 11, 2014 | Cars & Trucks
Mar 22, 2014 | 2001 Buick Park Avenue
Apr 09, 2013 | 1991 Buick Park Avenue
Mar 11, 2013 | 1999 Buick Park Avenue
May 15, 2012 | 2000 Buick Park Avenue
Oct 27, 2009 | 1999 Buick Park Avenue
Aug 04, 2009 | 1995 Buick Park Avenue
17 people viewed this question
Usually answered in minutes!