Question about Cars & Trucks

1 Answer

",My 2004 chevyimpala 3.4engine, engine light is not on, the meter shows noproblem,but when I drive my car the engine starts running fast I turn of the key and start the engine ,its back to normal HELP!!!

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Expert
  • 34 Answers

Tps throttle position sensor

Posted on Nov 11, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 625 Answers

SOURCE: 2004 Dodge Intrepid cuting off

try to replace your crank sensor but before that top on computer with car runing and see if stalls if it does your computer is not good most of times the computer is located by the drivers front fender at front side in engine compartment

Posted on Jun 01, 2008

  • 1 Answer

SOURCE: 1996 Saturn SL, 4 cylinder,

I also had the same problem with my 1996 Saturn SL1, and it also was the starter. I thought it was an electrical problem until, just on a whim I pulled the starter. One of the brushes was almost gone and the commutator looked like hell. I cleaned up the commutator and brushes, and it spun like a top for about a month, until the worn out brush finally died. I also ordered a new starter the same day of the cleaning. Just a word of advice if you will be buying a new starter, go on Ebay Motors and find the store dbelectrical. They sell brand new starters for $49.95 with no core charge plus $12 UPS shipping. So $61.95 vs $150+ at your local parts store....Myself and my friend from work have both bought and daily use starters from them with no problems or complaints to report.

Posted on Jul 31, 2008

  • 6 Answers

SOURCE: will not drop down from fast idle when first started

It sounds like an automatic choke system. Let it warm up for 5 minutes and then give it gas up to 2000rpm and release.

Posted on Nov 19, 2008

  • 1 Answer

SOURCE: 2004 Dodge Ram 1500 Hemi Sport Quad 4WD

on my 2004 ram 2500, I had to depress the trip odometer button and turn on the Ignition. all lights on instrument panel will illuminate, continue to hold button in and tach/speedomenter will run full up and back down. once this has completed, the obd codes will be shown in the odometer.

Good Luck

Posted on Jan 09, 2009

  • 20 Answers

SOURCE: 2004 Ford Focus LX, was sputtering while driving

change the fuel filter. and clean the mass air flow sensor usein a can of carb cleaner from any parts shop. depending on the miles on your car the timing belt mit have jumped a tooth. have to change it every 120.000 km.

Posted on Apr 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dodge intrepid 2004 showing code p1687, check engine came on and air bag light, speed ometer and tack gauge dropped to zero but started working 5 seconds later light is still on and showing this code. Can...


the lamps all change at engine stall , did it stall.
at about 300 rpm all engines (gas) stall, and the ECU changes state.
all cars.
does car run, ok, drive ok ,start ok, and sound ok? just a clue here.

Sep 25, 2013 | 2004 Jeep Wrangler

1 Answer

1997 gmc jimmy starter motor not turning


You need a better battery. When you hook the amp meter and read 0.3 the ECM needs to sleep

Jan 05, 2012 | 1997 GMC Jimmy

2 Answers

I was putting gas into my 2004 Toyota Tundra and afterwards the truck would not start. I could turn the key to accessories and the dash would light up but when I tried to start the engine it would not...


It was, especially if you get the check engine light on after starting it but it should go out. It may also be a loose wire on the starter or ignition system.

Apr 13, 2011 | Toyota Tundra Cars & Trucks

1 Answer

My jeep Liberty starts fine when the car is cold. Once the car warms up, if the car is turned off, it will not start, not even a click, until the car cools back off ( about 3 hours). Could you tell me what...


Can't tell you without being there but check the starter relay and all connections at battery, starter and grounds both on engine and fender. Check with a test light or volt meter (Meter is better because it will show power drop off if any) Test with key in run position and in start position as well. Don't forget there is a neutral safety switch that can also fail so check in park and neutral also.

Oct 28, 2009 | 2004 Jeep Liberty

1 Answer

My 2004 Linc Ls keeps going into this fail safe


Sounds like your mass air flow meter is at faul.Replace it.Good luck.

Sep 02, 2009 | 2004 Lincoln LS

1 Answer

Maintenance light flashing


h) Engine Oil Replacement Reminder
Light (for vehicles sold in U.S.A.)
This light reminds you when to replace
the engine oil.
This light will come on when the ignition
key is turned to “ON” and will go off after
about a few seconds.
When you drive for about 8000 km (5000
miles) after the engine oil replacement,
this light illuminates for about 3 seconds
and then flashes for about 12 seconds
with the ignition key turned to “ON” position.
If you continue driving without the
engine oil replacement, and if the driving
range exceeds 12000 km (7500 miles), the
light will come on after the ignition key is
turned to “ON” position. The light will remain
on thereafter.
If the light is flashing, we recommend that
you replace the engine oil at an early
opportunity depending on the driving and
road condition. If the light comes on, replace
it as soon as possible.
You need to reset the light after the engine
oil replacement. Reset the light by
following the procedure below:
1. Turn the ignition key to the “OFF” position
with the odometer reading shown.
(For details, see “Odometer and two
trip meters” on page 136 in this Section.)
2. Turn the ignition key to the “ON” position
while holding down the trip meter
reset button.
Hold down the button until the light goes
off. Before the light goes off, it illuminates
for 3 seconds, flashes for 2 seconds and
illuminates for 1 second.
If the system fails to reset, the light will
remain flashing.


I copied this from page 143 of the owners manual for the 2004 4Runner

Jun 04, 2009 | 2004 Toyota 4Runner

1 Answer

Intrepid 1995 - speed o meter stopped working


You should try checking the connection on the speedometer also about the about 4 rpms to get going your transmission might be slipping

May 06, 2009 | 2004 Dodge Magnum

2 Answers

Dash Lights and radio turn off while driving


wire harness problem, have it checked or DIY if you have knowledge with a multi meter checking resistance and voltage.

Apr 10, 2009 | 2004 Honda Accord

1 Answer

2004 silverado will not start


the engine light will not go out until engine starts to run. need to find out if the fuel pump runs when you key up if not that may be suspect

Jan 12, 2009 | 2005 Chevrolet Silverado 1500 2WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...