Question about Cars & Trucks

1 Answer

Mechanical error came up on my screen as I was driving this morning then went away

The car is only 4months old and done 7000 km

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 16,210 Answers

IF it went away, then it was nothing major and the problem corrected itself.

Posted on Nov 11, 2014

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: my 300zx got smoke issue but im not sure.smoke

It sounds like you may need valve seals.
The oil sits in the head after the engine is cut off and leaks around the seals into the cylinder.
When you start the engine it burns the oil and sends the smoke out of the tailpipes.
It does not hurt anything much if it is not to bad.

Posted on Jun 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chrysler 200 2013 62te transmission with 3.6 V6 P0729 code and nothing else. Replaced oil/filter 2X and solenoid pack. All looks good. What is wrong?


code p 0729 refers to gear 6 --incorrect ratio===causes ---fluid level---wiring---TR( transmission ratio) sensor /switch---shift solenoids---transmission mechanical fault
the box is operational so no need for mechanical failure to figure in the diagnosis
if you never use 6th gear, it is possible that the solenoid may be a bit rust inside or a wire has failed from corrosion
at this point I would be checking wiring , connections and pins are not corroded and then consider the TR sensor / switch replacement

Apr 30, 2017 | Chrysler Cars & Trucks

2 Answers

Toyota Vitz 2007, 1.0 L, check engine light comes on at 100 km/h and goes off after turning off engine but comes back again at high acceleration like 100 km/h. change oxygen sensor as well.


That code is actually due to the fuel pressure being too low and causing a lean condition that the oxygen sensor picks up. It is common in that vehicle. Check the fuel pump pressure, filters etc.

Feb 08, 2017 | Toyota Cars & Trucks

1 Answer

I was driving my tiburon home i was doing about 90 km then i felt my car die out and my rpm's went to 0 and my car wouldnt start anymore it jus kept rolling over n rolling over **** would never ca


The following are the general instructions on the start of diagnosing any electronically controlled engine or transmission problem.

The engine and the automatic transmission (transmission control is only for automatics, engine is still computer controlled no matter the transmission type) in this vehicle are computer controlled and in most cases when a fault occurs a fault code is stored in the memory of the computer control module. There are exception to this, such as the Mass Airflow Meter and fuel pressure problems. What must be done is to have all the basic testing done such as a scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct and what isn't, then based on careful diagnostics done from a factory repair manual the correct part is replaced or the wiring repaired or the computer replaced (known as the PCM), which is very rarely the problem. Other basic checks must be done as well such as mechanical problems with the engine as well as engine state of tune and mileage on the engine. The transmission can have mechanical issues as well such as no gear engagement at all or a failed pump or other pressure related problems. Also engine mechanical problems ca cause many drive-ability related problem such as rough idle and other symptoms


Oct 15, 2012 | 2003 Hyundai Tiburon

1 Answer

2003 audi a4 1 8t po722 output speed sensor code Problem


2003 Audi A4
This morning while driving my rpm's went from 2-4 and my km dropped then my rpm's dropped as well, after that I was unable to move
plz help

Aug 01, 2011 | Audi A4 Cars & Trucks

1 Answer

Hey, Just recently bought a 2001 Petrol Golf gti that'd done 99,000kms and hadnt had the timing belt done. I'm currently on 101,000... I know it is probably not recommended I drive anymore, but...


Volkswagen recommends only to check the timing belt & tensioner first time at 90,000 km, then every 30,000 km. Renew as necessary.
CAUTION: The most important fact is that the car is 10 years old. Do NOT drive the car without timing kit renewal !!!

Jun 27, 2011 | Volkswagen GTI Cars & Trucks

1 Answer

I have 2000 S type. In the mornings when I start the car it sort of shakes the car. ( it sound like it is miss timing) Once it warms up this goes away. No engine light but I have checked the coils all...


WELL TIMING CHAIN CHANGING TIME IS 120000. DO A LITTLE TUNE UP.CHANGE SPARK PLUGS AND CHANGE FUEL FILTER AND AIR FILTER.CLEAN FUEL INJECTORS.SEE WHAT HAPPENS.DOING A MINOR TUNE UP CAN HELP PIN POINT IF YOU HAVE A MECHANICAL PROBLEMS LIKE INTAKE VACUUM LEAK OR LOW ENGINE COMPRESSION.

Sep 22, 2010 | 2000 Jaguar S-Type

1 Answer

My 300zx got smoke issue but im not sure.smoke come both sides when i start the car.it got little oil leak from turbos.but once engine got hot the smoke goes away.when driving it doesnt smoke.but it...


It sounds like you may need valve seals.
The oil sits in the head after the engine is cut off and leaks around the seals into the cylinder.
When you start the engine it burns the oil and sends the smoke out of the tailpipes.
It does not hurt anything much if it is not to bad.

Jun 04, 2009 | 1990 Nissan 300ZX

2 Answers

Transmission slips- Honda accord 2001


cost more to bulid than 2 replace with a used one

May 05, 2009 | 2001 Honda Accord

1 Answer

Transmission slips- Honda accord 2001


did you have a transmission flush? because its bad for older cars to get flushed because the acids they use eat away the seals and mess up your transmission more...i would recomend using some transmission conditioner 

Apr 24, 2009 | 1993 Honda Accord

1 Answer

4 month old 2008 x5 with 4,000 miles .Are away on vacation 500 miles from home. Car sat out in the rain and heavy fog overight. This morning I started the car,put it in drive and started to move when the...


This happen to me after I got into a small fender bender. The dealership stated this only happens when something is not closed correct (door, hood, etc)

Aug 13, 2008 | 2007 BMW X5 3.0si SAV

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...