Question about Cars & Trucks

1 Answer

2001 pt cruiser. Car jerks when in drive and stopped at stop sign or red light. Its not the torque converter is it?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 89 Answers

You need to get the auto box serviced and re set to your engine I am not sure if you are in the uk but you need a place similar to these who are happy to give free advice. http://www.d-k-automatics.co.uk/

Posted on Nov 10, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 39 Answers

SOURCE: error code po742 torque converter

check and see if your pressure regulator valve is stuck

Posted on May 08, 2009

  • 40 Answers

SOURCE: engine light is on ,code P0171, hesitates when start driving

you will need a code reader to turn light off

Posted on Jun 02, 2009

  • 5 Answers

SOURCE: 2001 PT Cruiser: How too remove crankshaft pulley 2001 PT Cruiser...

GET A 3 SPOKE PULLEY EXTRACTOR AND SCREW IN THE BOLT BUT IN THE CRANKSHAFT HOLE PUT A MUCH SMALLER SCEW SO YOU WOUNT MESS THE INSIDE UP

Posted on May 26, 2010

pctech1
  • 1940 Answers

SOURCE: 2005 pt cruiser. convertible top

  1. This is a common problem with the 2005 PT Cruisers, and the worst case scenario is you will have to take it to the dealership for a software upgrade.
  2. Many times, if you disconnect the battery for 30 minutes or so, and then reconnect the battery, the convertible top and windows will start working again. I would try this a couple of times if the fuses are found to be good.
  3. If it still fails to work, check with the dealership to see about getting your computer reprogrammed.
  4. If all else fails, you may have a bad window switch and convertible top switch, but is unlikely that both would have gone out at the same time.

Posted on Mar 18, 2011

  • 1 Answer

SOURCE: 2005 Pt Cruiser idles rough at stop lights/ poor gas mileage.

i hav a 2003 pt cruiser 2.2 crd touring it wont go over 3000 revs engine light cums on. error code p0243 i hav replaced wastegate solenoids cleaned egr valve cud it be the mass air flow sensor that has a problem thanx

Posted on Jun 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dodge caravan shuts off at stop sign or red light


Either a brake light switch or torque converter clutch solenoid needs to be replaced.the vehicles talk converter clutch is not disengaging when activated by the brake light switch. Therefore one of these two items is defective.

Jan 30, 2015 | 2003 Dodge Caravan

1 Answer

2002 Mitsubishi Eclipse, I came to a stop and my car would just rev when I pressed the gas. Noticed my neutral light blink, Car won't move in drive or reverse just rev. help please!


This just happened to my 02 eclipse gt automatic on Thanksgiving 2012 . Its ur torque converter , the torque converter engages forward and reverse drive... Sorry to say but u need a transmission rebuild.... I just swapped mine to a 5 speed for around $2000

Jan 10, 2013 | 2001 Mitsubishi Eclipse

1 Answer

Installede plugs and wires in a 2004 pt cruiser now it runs rough at idle


Inspect pugs for propper gap, cracks... check wires for arching and replace as needed. Verify firering order is correct.

Sep 29, 2012 | 2004 Chrysler PT Cruiser

1 Answer

PO744 code 2001 infiniti qx4 how do i fix


CODE PO744 AUTOMATIC TRANSMISSION TORQUE CONVERTER CLUTCH SOLENOID VALVE FAULT. POSSIBLE CAUSE FAULTY TCC SOLENOID.CHECK TCC SOLENOID WIRING FOR DAMAGE.OR YOU COULD HAVE FAULTY TCM OR ECM. IF THE TCC SOLENOID IS FAULTY YOUR ENGINE WILL STALL OUT AT A RED LIGHT OR STOP SIGN.YOUR ENGINE WILL STALL OUT AT EVERY STOP THAT WOULD BE SIGN FAULTY TCC SOLENOID.IF ENGINE DONT STALL OUT THE TCC SOLENOID COULD COULD BE STUCK OPEN, IF YOUR TORQUE CONVERTER FAULTY IT WILL CAUSE PREMATURE LOCKUP STALLING OUT THE ENGINE.

Nov 01, 2011 | 2007 Infiniti QX4

2 Answers

2005 Pt Cruiser idles rough at stop lights/ poor gas mileage.


i hav a 2003 pt cruiser 2.2 crd touring it wont go over 3000 revs engine light cums on. error code p0243 i hav replaced wastegate solenoids cleaned egr valve cud it be the mass air flow sensor that has a problem thanx

Sep 18, 2009 | 2005 Chrysler PT Cruiser

2 Answers

EXACT SAME PROBLM


either your cat has melted. Or your trans is shot

Aug 15, 2009 | 2002 Chrysler PT Cruiser

1 Answer

My 2001 crown victoria jerks at 40 mph


sound like torque converter problems.scan it to check torque converter.make sure it is applying and releasing .if not you got a bad torque converter solenoid.or a stop up screen.restriction in oil passages .or the o-ring seal cut or damage.also check for low oil pressure.

Jun 25, 2009 | 2001 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...