Question about 2008 Ford F-350

1 Answer

Where is the horn relay location on a 08 ford f350 with a 5..4 liter

Horn comes on by its self

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Filmmaker:

    Uploaded 5 video answers.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 12 Answers

Sadly, the horn relay is built into the Smart Junction Block (passenger fuse box)
see diagram.
I think you may have a bad/sticking horn switch, which is part of the drivers airbag module. if there are no concerns with the speed control or airbag lamp on, the clock spring in the column is ok.

all the switch does is complete a ground circuit to the relay. you may have a wire pinched under the airbag in the wheel.


Where is the horn relay location on a 08 ford f350 - 25277987-y12x0o0o0lm2kgfxdyqglnjp-1-0.jpg
since an airbag is involved, I would recommend a dealer check this part. Airbags are dangerous.

Rick

Posted on Nov 23, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

cj2176
  • 520 Answers

SOURCE: where is the horn located on a 1998 ford explorer

The horn is usually between the radiator and grill Assembly. The fuse is in fuse panel under the dash on the drivers side. Look at the lid and it shows the fuse placement and there use.

Posted on Jun 12, 2009

sscullys
  • 984 Answers

SOURCE: where is located the ford f-150 horn

If you slide under the front bumper, in front of the passenger side front wheel, and look up, the high and low note horns should be on a bracket right there.

9f6a205.jpg

Posted on Nov 28, 2009

ZJLimited
  • 17970 Answers

SOURCE: Location of the Horn Relay on a 2005 Ford Taurus

In the checkthe Cavity 38, Fuse 15A for Horn, Diagnostic Connector (ODB II).

Also can review the 2005 Ford Taurus - Owners Manual (page 178, Fuse Description).

56dd6cb.gif

Hope helps with this (reemmber rated this help). Good luck.

Posted on Jan 12, 2010

sscullys
  • 984 Answers

SOURCE: HORN RELAY ON MY 1999 F150 LOCATION

Engine Compartment Fuse panel, Relay 205

If you did not get an owners manual with your truck ( purchased used ), you can download one from Ford :
https://www.fleet.ford.com/maintenance/owners_manuals/default.asp

Posted on Mar 13, 2010

Testimonial: "THANK YOU FOR THE INFO IT WAS HELPFUL."

  • 5 Answers

SOURCE: 1988 Ford Crown Vic Horn Relay Location

The horn relay IS NOT located in a box toward the front of the engine. It is located just behind the radiator overflow reservoir and attached to the inner fender next to two other relays. It is the only one without a plastic cover over the top of it. FYI, our Crown Vic horn didn't blow, and the cruise didn't work. I changed the relay and still no horn. I decided to check the horns themselves. Found wires disconnected from terminals. Touched wire to horn terminal and horn blew incessantly. (previous owner had disconnected horn rather than diagnose why) Pulled the horn "button" from steering wheel and disconnected the wire leads and horn quit. Disassembled the "button" assembly. Foam had degraded over time between the contacts. (Ford has discontinued this part). Cleaned and replaced foam with Scotch foam mounting squares with holes punched out over contacts (2 layers thick). Re-assembled and viola! Horn and cruise control both work! Relay was bad as was horn button.

Posted on Jul 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where can i find my horn relay on my 2006 Toyota hilux


you have to register for these forums.

  • NewHilux.net • View topic - Horn relay www.newhilux.net/phpbb/viewtopic.php?t=10814
    • LAST UPDATED: 2014-08-26
    • 6 POSTS
    • FIRST POST: 2011-08-23
    NewHilux.net the Ultimate resource to the late model Toyota Hilux Ute ... Anyone know where the horn relay is ... When my horn died it was also clicking but the ...
  • horn relay?? - Hilux Surf Forum hiluxsurf.co.uk/showthread.php?t=74439
    • LAST UPDATED: 2012-01-31
    • 5 POSTS
    • FIRST POST: 2012-01-05
    guys im trying to fit a new more powerful horn i need to replace the relay does anyone know where ... FIRE UP THE HILUX ... Horn Relay Located Right hand side ...
  • Feb 05, 2016 | Toyota Cars & Trucks

    1 Answer

    Where is the horn relay located on a 2007 ford edge sel


    It is located in the SJB - smart junction box an it is a non- serviceable part . soldered to the board inside . Where do you hear the clicking noise coming from ? The SJB is located behind the left side kick panel .
    SECTION 413-06: Horn 2007 Edge/MKX Workshop Manual DESCRIPTION AND OPERATION Procedure revision date: 10/30/2006 Horn The horn system consists of the following components:
    • Horn switches (part of the steering wheel)
    • Clockspring
    • Horn relay (part of the smart junction box [SJB])
    • Horn
    For removal and installation of the steering wheel, refer to Section 211-04 .
    For removal and installation of the SJB, refer to Section 419-10 .
    Principles of Operation
    The smart junction box (SJB) supplies the control and switched voltage to the horn relay (part of the SJB). When the horn switches (part of the steering wheel) are pressed, ground is supplied through the clockspring to the horn relay. The horn relay is then energized directing voltage to the horn and enabling the horn to sound. When the vehicle security system is armed, the SJB provides a momentary ground to the horn relay control side to indicate the system is armed, and an on and off ground when an intrusion is detected or the panic alarm is activated.
    If your horns are not working ,you have a wiring problem or the clock spring is open . If the relay is bad the whole SJB has to be replace an the dealer would have to do that . Needs to be programmed ,with factory tool .
    Symptom Chart Condition Possible Sources Action
    • The horn is inoperative
    • Fuse
    • Circuitry
    • Horn
    • Clockspring
    • Steering wheel switch harness
    • Horn switches (part of the steering wheel)
    • Smart junction box (SJB)
    • Go To Pinpoint Test A .

    You

    Dec 02, 2015 | Ford Cars & Trucks

    1 Answer

    I need the horn fuse number for ford explorer 2002 4.o liter


    The fuse for the horn (horn relay) is in the power distribution box located in the engine compartment (see picture below). That fuse in in the number 28 position (see other picture below) and the horn relay itself is located in the number 47 position. This information should be in your owners manual if you have one. If you need an owners manual for your vehicle you can email me at csautomotivecars@att.net with your make, model and year of your vehicle and what you need and I will be happy to email you a copy and don't worry no cost to you. I hope this helps you and good luck. Here's your pictures:


    clifford224_154.gifclifford224_155.gif

    Apr 15, 2011 | Ford Explorer Cars & Trucks

    1 Answer

    HORN DOESN'T WORK. lOOKING FOR FUSE SO WE CAN REPLACE IT.


    Hello hthmases: My name is Roger and I will help with your question> The horn fuse is located in the fuse box under the hood. The fuse is in location (R) in the box. Look on the cover for the location it will be a 15 amp fuse and blue in color. If the fuse is ok I would have some one push the horn pad while I listened for the relay to click. The relay is located on the left fender in the corner to the right of the master cylinder. If the relay does click I would suspect a bad horn. If there is power at the horn its self the horn would be bad. Should you need further help please just ask. Please rate the answer you received. Thank You for trusting Fix Ya for your answer . Roger

    Dec 18, 2010 | 1994 Ford Econoline

    1 Answer

    2001 f-150 ford pick up truck . horn will not work


    Did you check the fuse for the horn ? Engine compartment fuse panel, fuse #7, 20A

    You can pull the horn relay, and jumper the normally open contacts to see if the fuse, horn and grounds for the horn are in working order ( this operates the horn without needing to use the horn button ).
    The Horn relay is a half size Ford ISO relay in the engine compartment fuse panel ( check your owners manual to locate relay 206 ).

    Diagram to jumper the horn relay, with this in place, the horn should sound as long as the jumper is in place
    sscullys_15.jpg

    If you did not get an owners manual with your truck ( purchased used ), you can download one from Ford :
    https://www.fleet.ford.com/maintenance/owners_manuals/default.asp

    Nov 12, 2010 | 2001 Ford F150 Styleside SuperCrew

    2 Answers

    My horn doesn't work for my 1988 Crown Victoria


    check fuse and also check the wire going to the horn and check the inside of the horn too and check the ground

    Jul 04, 2009 | 1988 Ford Crown Victoria

    2 Answers

    1988 Ford Crown Vic Horn Relay Location


    The horn relay IS NOT located in a box toward the front of the engine. It is located just behind the radiator overflow reservoir and attached to the inner fender next to two other relays. It is the only one without a plastic cover over the top of it. FYI, our Crown Vic horn didn't blow, and the cruise didn't work. I changed the relay and still no horn. I decided to check the horns themselves. Found wires disconnected from terminals. Touched wire to horn terminal and horn blew incessantly. (previous owner had disconnected horn rather than diagnose why) Pulled the horn "button" from steering wheel and disconnected the wire leads and horn quit. Disassembled the "button" assembly. Foam had degraded over time between the contacts. (Ford has discontinued this part). Cleaned and replaced foam with Scotch foam mounting squares with holes punched out over contacts (2 layers thick). Re-assembled and viola! Horn and cruise control both work! Relay was bad as was horn button.

    Jun 27, 2009 | 1988 Ford Crown Victoria

    2 Answers

    1999 Chevy Cavalier Horn Relay Location


    The relay is located under the glove compartment. Little difficult to get to but if you peek your head just underneath, you'll see it. Easy to take out and replace. Ive replaced mine and still have a problem. I hear a clicking noise and even can feel the contact when horn is pressed. I changed the horn about 1yr ago and now am wondering if the horn could have gone out so soon.

    Jun 17, 2009 | 1999 Chevrolet Cavalier

    1 Answer

    I don't know where the horn is located on my 1992 ford bronco, where is it? and what color are the wires the come out of the relay because I want to use the factory horn button and factory relay but put a...


    Look between the radiator support and the front grill on the left and right hand sides.
    Also,,there is no need to replace the Horn Relay when replacing the horn unless the relay is faulty.

    Jan 19, 2009 | 1992 Ford Bronco

    Not finding what you are looking for?
    2008 Ford F-350 Logo

    641 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts

    yadayada
    yadayada

    Level 3 Expert

    75822 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    fordexpert

    Level 3 Expert

    5501 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...