Question about Saturn SL2

1 Answer

95 Saturn sl2 new sensor, relay fan still not working help checked fan it is working

Cooling fan not coming on when up to temp

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Saturn Master
  • 33,322 Answers

The powertrain control module (PCM) also controls the cooling fan.

Posted on Nov 10, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: 2000 Saturn SL2 with DOHC

Did you check fuses?

Posted on Jul 27, 2008

leetamara
  • 702 Answers

SOURCE: Cooling fan wont work

The water temp sensor is located near the thermostat housing. This sensor is what tells the ECM to turn the fan on/off. The water temp sending unit is located near the same area. You know you have the correct sensor is because the water temp sensor has a 2 prong plug. The water temp sending unit only has 1 prong.

Posted on Sep 27, 2008

motor1258
  • 6674 Answers

SOURCE: 1996 saturn sl2 fan coming on late an over heating

Start with engine cool, & remove radiator cap. Check level in rad & fill to an inch or so from top of rad. Start car & turn heater on.(not defrost)
Now let it run until engine gets up to normal operating temperature & let it run until rad fan comes on & off, 2 or 3 times. Rev engine slightly every so often just to help disperse air in system faster. Fill rad as needed during this time. After you do that, and fan has come on & off 2 or 3 times, put rad cap back on & fill return bottle to proper mark, then see how it is.
I suspect it's just air in system & this should cure that . If not get back to me.

Posted on Jun 27, 2009

  • 176 Answers

SOURCE: Does a 95 cutlass supreme have a fuse for the

There are three fuses and two relays for your coolant fan. They should all be in your underhood fuse box. They may not be marked "coolant fan", so check them all, (2) 60 amp , (1) 20 amp, (1) 15 amp. If all the fuses are good, you may have a bad fan switch (temp sensor). It tells the fan when to turn on, follow the wire from the fan motor to find it.

Posted on Dec 19, 2009

  • 270 Answers

SOURCE: Does a 95 cutlass supreme have a fuse for the

Yes, in the underhood electrical center, a 60 amp with a red wire going to relay 1 and a 20 amp with an orange wire going to relay 1 and a 15 amp with a brown wire going to relay 2 and another 60 amp with a red wire going to relay 2. The diagram doesn't show a temp sensor, but it does show dark blue and dark green wires going to the power train control module, so it must get the temp input from there. The second fan usually comes on when the A/C is turned on and it apparently gets that signal from there also. Hope this helps.

Posted on Dec 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What Switch or control makes the radiater fan come on? and need the diagram for the radiator control switch, 1993 saturn sl2.


Ok. The way your system is set up,you have a fan switch located in the engine block,usually near the top.That fan swtich sends the voltage to the fan motor or to a fan relay then to the motor.You can jump the fan motor directly to make sure the motor itself is not burned out by unplugging the motor and running a jumper wire from your battery pos terminal to the terminals on the fan motor itself..If you have checked the motor and it does work,then the easiest thing to do is simply replace the fan switch.You should have a Coolant temp switch and a radiator fan switch and possibly and Radiator fan relay.I would try the radiator switch first,then replace the relay.The coolant temp sensor is for the computer and usually doesnt tie into the radiator fan switch.try that and repost.Good luck

Aug 23, 2011 | 1993 Saturn SL2

1 Answer

06 vue cooling fan wont shut off tried new relay swich and the 40a fuse is obviously good. what could it be, temp sending unit?


The power for the fan comes from 2 relays in the
junction block on the left fender. One is a high fan relay 40amp the other is the low fan relay 20amp.
If either one is stuck, it will power the fan. Also if the
engine coolant temp(ect)sensor is bad, it can send a
false signal to the engine control module(ecm) and powering the fan. With the engine cool, if the fans still
running. Unplug the ect sensor(on thermo. housing)
if the fan stops replace the sensor. If not pull the relays one at a time. And see which one stops the fan. If none of this works it may be an ecm problem.
Hope this helps.

Mar 21, 2010 | 2005 Saturn VUE

3 Answers

I always have to turn on my ac so that the fan can cool my engine


never seen a saturn in my life ,but if it is a 1999 model then it should be in the radiator ,only newer cars have them in the head ,but their are exceptions to this rule but few and far between and mainly *** or french

Aug 13, 2009 | 1999 Saturn SL

1 Answer

95 saturn sl, cooling fan will turn on if ac is on, checked the fuse and relay, still good. what is the problem


make sure enough freon and cooling system has been bleed (get air out) if so ,change coolant temp sensor

Jul 03, 2009 | 2002 Saturn Sl

2 Answers

1996 saturn sl2 fan coming on late an over heating


Start with engine cool, & remove radiator cap. Check level in rad & fill to an inch or so from top of rad. Start car & turn heater on.(not defrost)
Now let it run until engine gets up to normal operating temperature & let it run until rad fan comes on & off, 2 or 3 times. Rev engine slightly every so often just to help disperse air in system faster. Fill rad as needed during this time. After you do that, and fan has come on & off 2 or 3 times, put rad cap back on & fill return bottle to proper mark, then see how it is.
I suspect it's just air in system & this should cure that . If not get back to me.

Jun 27, 2009 | Saturn SL2 Cars & Trucks

2 Answers

Radiator fan will not run but motor is good


follow the wires coming off the fan they will lead you to the relay from that the relay will run to the temp sensor which trips the relay for the fan

Mar 04, 2009 | 2002 Saturn Sl

2 Answers

1998 saturn sl2 fan not coming on


It could be a fan relay.

Aug 26, 2008 | 1999 Saturn SL

1 Answer

Cooling fan always runs with ignition on


try putting the electrical connector on the other way

Jul 29, 2008 | 1992 Saturn SL2

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...