Question about 2006 Jaguar S-Type 2.7

Open Question

How do I remove front bumper from S type jaguar

How to remove bumper to gain access to parking assist sensors

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

MNfisherman
  • 11896 Answers

SOURCE: s type front bumper crome strip how to get it off

The strip is held on with really tacky glue. You will have to pry off one end and pull off the remainder of the strip.

Posted on May 23, 2009

  • 14 Answers

SOURCE: The rear parking sensors on my jaguar xtype not working

replace them

Posted on Oct 29, 2009

  • 56 Answers

SOURCE: Jaguar x type 2004 front bumper

Front bumper removal is quite easy. To start with there is 4 10mm bolts one by each headlamp ( with the bonnet open) remov them. There is 3 T30 screws that hold the under tray to the subframe and there is also a small corner trim that is on the bumper side of the front wheel arch here is 3 T30 screws holding them on on each side. Finally remove the front wheel arch lining so you can get acsess to the inside of the bumper. You will then see a 10mm bolt towards the top of the bumper that is reversed to you. Remove then the bumper should then just pull away.

Becareful not to damage the fog lamp harness upon removal

Posted on Apr 24, 2010

  • 4102 Answers

SOURCE: HOW DO I REMOVE AND

Hi
CLICK HERE

the link above will take you to a site that gives you step by step instructions plus pictures on how to remove the front bumper, when you have had a look through that send me a message back then ill send you the details for the rear bumper, make sure you dont short any wires as the airbags can be set off from what i can remember.

send me a message back and ill send the details for rear bumper ok

Posted on Jan 23, 2011

  • 1 Answer

SOURCE: S Type Jaguar rear bumper removal

how do you remove a front bumper off of an jaguar s type?

Posted on Mar 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to chang a reverse sencor on a s type jaguar


If the faulty sensor is one of the inner sensors the bumper has to come of. If it is a outer sensor only half the bolts on that side have to be removed. Start by partly removeing the under wing shield and there is access to the bolts,open the boot remove plastic shut trim and more bolts. Pull back side carpets remove the black side plates to get to more bolts remove bumper and replace the faulty sensor leave the bumper connected and pointing away and test before refitting.

Mar 24, 2015 | 2002 Jaguar S-Type

1 Answer

Location of airbag sensors


Are you talking about impact sensors? Two are located on front right and left frame support. They are accessible from the bottom but its easier to take the bumper off to gain easy access to them. Another two are locates on bottom of B pillar around the area where the driver and passenger seatbelt tensioners are. You have to remove the door seals and plastic cover of the B pillar to gain access to them. Last two are mounted below C pillar behind the seat back cover. You have to remove cushion and back piece to gain access to them. Some people say there are versions without the sensors under C pillar tho, but I worked on one that had those sensors.

Jun 27, 2014 | 2013 Honda Accord

1 Answer

Removing front bumper


there will be bolts behind the bumper , to gain access remove the inner wheel arch linings and look under front of vehicle as should be able to see the bolts there as well ,may have an under tray to remove to gain access there as well

Jun 07, 2014 | 1997 Geo Tracker 2 Door

1 Answer

Jaguar parking sensors


Most likely a failed pdc sensor in bumper. Needs a scan to identify which one.

Mar 31, 2014 | 2006 Jaguar S-Type

1 Answer

Removing jaguar s type rear bumper..


disconnect the connector from the park aid module push the connector and grommet out of the back panel remove screws from lower rear of wheel arch liners remove boot floor trim remove plastic boot closing panel trim remove both boot side trims you wil find a number of 10mm headed bolts around the boot at the sides and back remove these and get someone to help you remove the bumper liner the 2 outer sensors can normally be changed without removing the bumper liner on some models

Mar 26, 2013 | 2003 Jaguar S-Type

1 Answer

Jaguar x type 2004 front bumper


Front bumper removal is quite easy. To start with there is 4 10mm bolts one by each headlamp ( with the bonnet open) remov them. There is 3 T30 screws that hold the under tray to the subframe and there is also a small corner trim that is on the bumper side of the front wheel arch here is 3 T30 screws holding them on on each side. Finally remove the front wheel arch lining so you can get acsess to the inside of the bumper. You will then see a 10mm bolt towards the top of the bumper that is reversed to you. Remove then the bumper should then just pull away.

Becareful not to damage the fog lamp harness upon removal

Apr 08, 2010 | 2004 Jaguar X-Type

1 Answer

How do i replace the headlights


Front bumper requires removal to gain acsess to the lower 10mm bolts. Bumper comes off by removing the 2 10mm bolts on the top of the bumper then unscrew the 2 T30 screws in the front wheel arch liner (bumper side) and then you will be able to see a 10mm bolt reversed into a bracket at the top of the bumper from a inside veiw, remove and repeat for the other side. Then its 3 10mm bolts that secure the front under tray (if yours has one). Then there will be another 10mm bolt to the wing side of the headlamp from a above veiw. Bumper should then just pull off and watch for the connector for the fog lamp harness.

Just the 2 lower headlamp bolts andit should pull from its housing

Mar 29, 2010 | 2003 Jaguar S-Type

1 Answer

How do I remove the headlamp unit on a Jaguar S type 2001 I can only see two nuts one top centre and one to the left and three or four inches lower slightly to the right of the main beam looking from the...


Front bumper requires removal to gain acsess to the lower 10mm bolts. Bumper comes off by removing the 2 10mm bolts on the top of the bumper then unscrew the 2 T30 screws in the front wheel arch liner (bumper side) and then you will be able to see a 10mm bolt reversed into a bracket at the top of the bumper from a inside veiw, remove and repeat for the other side. Then its 3 10mm bolts that secure the front under tray (if yours has one). Then there will be another 10mm bolt to the wing side of the headlamp from a above veiw. Bumper should then just pull off and watch for the connector for the fog lamp harness.

Just the 2 lower headlamp bolts andit should pull from its housing

Mar 04, 2010 | 2001 Jaguar S-Type

1 Answer

S Type Jaguar rear bumper removal


how do you remove a front bumper off of an jaguar s type?

Mar 09, 2009 | 2004 Jaguar S Type

2 Answers

Parking assist "disabled"


It's the park assist module, located in the rear deck, not from the truck, remove seats, carpet deck and it's on the left side of center. its a small black box with one screw

Aug 09, 2008 | Lincoln Town Car Cars & Trucks

Not finding what you are looking for?
2006 Jaguar S-Type 2.7 Logo

240 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...