Question about Hyundai Elantra

1 Answer

Hyundai Elantra A/C clicks on and off. Is it the blower transistor or the resistor? It has both items.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Hyundai Master
  • 42,825 Answers

The ac starting and stopping is from high head pressure (too much gas/blockage) or thermostat settings If you have a climate control module that also controls the heat then it may be the module that is faulty. have it checked out by an accredited ac specialist shop.

Posted on Nov 09, 2014

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
roniecon
  • 6826 Answers

SOURCE: Where is the resistor on the 2005 Hyundai Elantra?

The blower resister controls the speed only,not the high blower,it is located next to the blower motor,mounts with about two screws,and has about 7 wires plugged into it.

Posted on Jan 29, 2010

emissionwiz
  • 76164 Answers

SOURCE: How do I access the

Hello
In order to gain easier access to the blower motor resistor you must remove the glove box liner/insert, then you can see and replace the resistor. Also if you go to the Hyundai Service site at the link below and register with the site as an owner you can gain access to factory repair manuals of all systems on the truck. The service is free to owners.

http://www.hmaservice.com/

Posted on Aug 31, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 santa se 2.4L Temp gauge reads normal, but heat from vents excesivlly hot.will not start after running for a while until it sits 1/2 hr.


There is a blower control resistor (manual system) or a blower transistor (automatic temp system) located behind the glove compartment in the HVAC box and this is a high failure item.

Mar 19, 2014 | 2004 Hyundai Santa Fe

1 Answer

2004 Hyundai Elantra blower speed control switch?


If the fan blows at half speed on high, it could be that the blower motor is toast.
You would need to check the motor for power and ground in all speeds, and the ohms resistance of the motor with the plug disconnected.

Jan 28, 2013 | Cars & Trucks

1 Answer

The heater blower dont work


If it doesn't work on any speed check the fuses, if it only works on full or a few speeds the resistor block mounted in the cold air chamber has failed and will need to be replaced. If the fuse is ok but the fan still doesn't work at all check the plug is fully pushed in at the switch, the resistor block and the fan motor. It could be a burnt out fan motor but check the other stuff first.
Hope this helps

Terry

Nov 25, 2012 | 2000 Hyundai Elantra

1 Answer

Problem whith a/c speed control


Near the AC blower motor under the dash is a resistor called the blower motor speed control resistor, it is defective, it must be replaced to cure this problem

Jun 27, 2012 | Hyundai Motor 2002 Elantra

1 Answer

A/c& heater control fan only works on #4 setting


If the blower motor only works on high speed then the blower motor resistor has burnt out on the lower settings, and will only send power on the high setting because it is straight battery power.

Jul 20, 2011 | 2004 Hyundai Elantra

3 Answers

I have a 2002 Elantra. Yestreday the lower fan speeds on the air conditioner fan stopped working (positions 1,2,3). The High speed (position 4) works. Any ideas how to correct?


The blower motor resistors or fan switch itself are defective.
High speed has no resistors B+ goes straight to blower motor.

Jun 03, 2010 | 2000 Hyundai Elantra

1 Answer

Where is the resistor on the 2005 Hyundai Elantra?


The blower resister controls the speed only,not the high blower,it is located next to the blower motor,mounts with about two screws,and has about 7 wires plugged into it.

Jan 29, 2010 | 2005 Hyundai Elantra

3 Answers

Hyndai Sonata air conditoning blower only works on high


I agree with 'motgor1258'... replace the blower resistor (it's actually a power transistor).
ea7d1d5.jpg

Jun 19, 2009 | Hyundai Motor 2004 Sonata

1 Answer

Heater & ac


this is usually a bad blower motor resistor. It is usually where your blower motor is and it could be behind or under your glove box.

Jan 23, 2009 | 2001 Hyundai Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...