Question about Cars & Trucks
2002 911 turbo
Almost certainly not a fuse. Both tail lights will be on the same fuse. More likely a bad connection at the tail light socket.
Posted on Nov 09, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
your socket may not be grounded properly, I have seen this before, and the simplest way to fix is change the socket with a new one.Not another used one it may also be bad.
Posted on Sep 06, 2008
you give some good clues. because your third brake light works but not the other two, and because you sometimes get brake lights if you have turn signals on at the same time, i would say that some wires got crossed up with your other taillights. check out the power wires back in the taillight assembly and the wires that run back to the taillights. something is mixed up back there, now you just have to find it. if all else fails after you isolate which wires are the brake light wires get some new wire, same gauge and roughly same length, remove a bit of insulation but don't cut the wire in two, and put the new wire in as an overlay. if having the new piece of wire there makes the brake light work you found the break in the wire. you can cut out the bad piece and fasten the new piece in. you can solder it if you have the equipment to do that, or you can buy some squeeze in place connectors at the car parts store. either way, good idea to tape it up when you are done. hope that helps
Posted on May 31, 2009
I have a 2000 ford focus no brake lights. with the brake lights the transmission would not go into drive .replaced the brake light switch checked fuse replaced turn signal switch with no results then i moved onto the wiper switch and replaced it as much to my supp rise it fixed the problems
Posted on Aug 06, 2009
I had this problem, and to be honest, it happened to the left side about a week later...it's the board that the bulbs plug into...it's a very common problem with this model. So popular that you can normally get the socket board off the shelf at a parts store! it's extremely simple to replace, and I replaced all the bulbs at the same time!
Posted on Oct 11, 2009
Tips for a great answer:
Feb 09, 2018 | 2008 Ford Escape
Feb 01, 2013 | Chevrolet Cars & Trucks
Sep 30, 2012 | 2005 GMC Envoy
Apr 26, 2011 | Chevrolet S 10 Cars & Trucks
Jun 06, 2010 | 2004 Dodge Dakota
Jun 04, 2010 | 1990 Lexus LS 400
Sep 09, 2009 | 2000 Ford Crown Victoria
Mar 28, 2009 | 1985 GMC K1500
Nov 12, 2008 | 1991 Jeep Cherokee Limited
Jun 26, 2008 | 2003 Chevrolet Venture Passanger
60 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: