Question about Mercury Sable
Time for a rebuild
Can't fix slipping
The internal damage is done
When your pulling out from a stop your in 1st gear
OD comes in at 42 mph or above
Posted on Nov 09, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 96 merc sable
When u drive and it does this, turn on the vents or the air to let the fans move and if it starts runnin good again, u have a clogged radiator take to a shop and get filtered
Posted on Dec 11, 2008
There are two 10 millimeter bolts that must be removed. Place these in your pocket or a convenient place so they will not be mispalced or lost. Also you need to pull upwards and remove an aluminun locking tab(coated in black plastic). After this is done carefully slide assembly foward. Press down on the wiring harness clip to remove it from the headlight bulb assembly, Turn the locking ring on the bulb to the right and remove so you can remove the bulb. Twist bulb out. When replacing new bulb do not touch the glass portion of the bulb. If you do so clean off with alcohol. Oil from your fingers left on the bulb will cause the bulb to overheat and fail prematurely. Replace bulb and secure with locking ring. You may also want to change the yellow parking/signal light bulbs at the same time. Clip wiring harness back on and slide headlightassembly back into place. Slide aluminum locking tab back into place. Now hand thread 10mm bolts back into place, Then tighten, do not over tighten. Now do the other side. First time might take you about 10 minutes per side. After that you could do it in a couple of minutes. Info on performing this maintenence can be foud in the owners guide or by downloading the guide from the following link http://www.motorcraftservice.com/pubs/content/~WO1SAB/~MUS~LEN/40/01sabog3e.pdf
Hope this info helped.
Posted on Jan 04, 2009
Check disconected vacumm line hose,
change spark plugs do a tune up.Increase idling speed.
Put a can of fuel cleaner injector cleaner into the fuel. Then put another one the next day after driving for 100 km.
Posted on Sep 09, 2009
Rebuilding the transmission. That's quite a few miles on your transmission and the seals are finally letting go.
Sorry to be the bearer of bad (and expensive) news,
Posted on Sep 16, 2009
Tips for a great answer:
Mar 24, 2016 | Cars & Trucks
Feb 04, 2013 | Cars & Trucks
Dec 30, 2009 | Mercury Sable Cars & Trucks
Sep 28, 2009 | 2001 Mercury Sable
Sep 16, 2009 | 1997 Mercury Sable
Sep 09, 2009 | 2004 Mercury Sable
47 people viewed this question
Usually answered in minutes!