Question about Cars & Trucks

1 Answer

News a diagram to rebuild starter and solenoid from Napa auto parts

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers


Posted on Nov 09, 2014

3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 5495 Answers

SOURCE: Starter solenoid on 1993 Ford E350 nwith 7.5 liter

It sounds like the small tickler wires may be reversed to the Solenoid.

If no success, call Itasca and ask if there were any changes for this Solenoid. There are several types of Solenoid with the grounding being the major internal difference. Most likely your wires are switched.

Posted on May 25, 2010

  • 271 Answers

SOURCE: 1992 Ford explorer auto hub parts and repair diagram.Where can I find this info.

I don't know about the auto hub parts, but I know repair diagram at, you can view it for many kinds of auto diagnostic tool.

Posted on Oct 29, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why cant i find a wiring diagram for a 2003 chrysler pt cruiser anywere?

You can. Try a Chilton's manual or the how to books sold at auto parts stores. The starter solenoid wire goes directly to the ignition switch The fuse marked IGN controls power to the starter solenoid.

Jul 17, 2014 | 2003 Chrysler PT Cruiser

2 Answers

2008 dodge grandcaravan selenoid part

Assuming the battery and it's connections are okay, it sounds as though you have a bad solenoid in the starter. I replaced my starter, but I think perhaps you could get a solenoid rebuild kit from an auto parts store. When I pulled my old starter apart, it was obvious where the problem was. I hope this answers your question.

Mar 27, 2014 | 2004 Dodge Grand Caravan

1 Answer

1999 cadillac starter

Unless these starters are rebuilt by AC Delco, Bosch, or other major player rebuilders they are likely very poor quality rebuilds. It sounds like the problem you have may be the starter solenoid contacts are burnt. When they rebuild the starter at the cheap shops they only replace what is showing up as defective, so not all worn parts are replaced. As a professional tech for over 35 years and a ASE Master technician I only use OEM rebuilds, never Autozone or other so called discount auto parts stores rebuilds. If you want to order from a site that has quality rebuilds at cheap rebuild prices go to the website at the link below.. I have seen people who bought 4 starters to get one good one, same goes for Alternators
RockAuto Parts Catalog

Apr 25, 2017 | 1999 Cadillac DeVille

1 Answer

1996 aerostar solenoid wire diagram

you need a haynes repair manual, you can buy one at any auto parts stores like auto zone, advance auto parts.

Sep 01, 2012 | Cars & Trucks

1 Answer

Every so often, when I try to start my car, it just clicks. after a couple of tries it will crank and be just fine for weeks. we think it might be the starter, but auto zone says starter is okay. could...

Sounds like Solenoid. U can replace it if you know how to do a starter rebuild. Go to local auto store and see if they have it or a rebuild kit. Otherwise just buy a new/ rebuilt starter and put that in.

May 05, 2011 | 2001 Mitsubishi Galant

1 Answer

Low voltage at starter when ignition switch is turned

Make sure the battery is fully loaded, check voltage when the key is turned to START. If voltage drops below 10vdc, jump start vehicle and have starting/charging system at AutoZone or similar auto parts store. If voltage at the battery is good, check wiring from battery to starter solenoid, make sure terminals are free of rust and corrosion and tight, wiggle the wires to make sure no loose connections exist. You should get the same voltage at the starter solenoid as you did at the battery terminal, if not replace cable. If you get same voltage at the starter solenoid, the solenoid itself or the starter may be worn/defective. There is a starter rebuild kit available at auto parts stores for a fraction of the price of a new starter.
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.

Mar 19, 2011 | 1996 Jeep Grand Cherokee

1 Answer

Trying to find a starter for a 98 monte carlo ls 3.1

Try craigslist ads in your area,Ebay,,junk yard,, Where I live we have a altenator,starter shop that rebuilds them,,,Try Parts store Napa,,auto zone There are still 1000,s of those on the road today.should not be a problem at all

Mar 11, 2011 | 1998 Chevrolet Monte Carlo

1 Answer

Dodge truck - transmission solenoid stuck in off -how do i repair this -where do i buy the part -where do i find a diagram to repair this

Not sure what year Dodge Truck you have, you can get the part from Napa or similar Auto Parts stores. You find diagrams and complete service manuals with step by step instructions from I hope this helps.

Jul 15, 2009 | 1999 Dodge Ram

1 Answer

Starter Relay???

There's no relay. Either the solenoid is bad or you need to have your starter rebuilt or replaced. For help with repairs and finding parts check out saabnet dot com You can remove the starter and have it tested for free at some auto parts stores. Look up auto electric in your yellow pages for alternator and starter rebuilding, and save up to 50% vs a rebuilt starter from the parts store.

Feb 07, 2009 | 1991 Saab 900

1 Answer


just get on look up starter there only 30 to 50 used this will save alot of run around trying to rebuild . disconect battery remove 2 starter bolts , drop it down and remove wires from starter be careful it they look rust use wd 40 if rusty

Aug 28, 2008 | 1993 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides