Question about 2008 Chrysler Pt Cruiser

2 Answers

I just replaced a fuel pump in a 2008 pt cruiser. Getting good power to the pump. Asd relay is good. Wiring is good. Still won't pump fuel. Thoughts?

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 20 Answers

Have u checked the fuel filter and the fuel pressure regulator look there next ...

Posted on Nov 09, 2014

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Check to see if there is a fuse for the fuel pump, then check if there is a impact shut off switch like the fords, and sometimes the fuel pump will run till after the ignition is cranked over....

Posted on Nov 08, 2014

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1999 oldsmobile silhouette van won't start. no power to fuel pump

I have a silhouette and it had the same problem
Follow the fuel pump wiring harness to where it plugs into the floor of the van--pull the connectors apart--they will probably be corroded, and you will possibly have to change both wiring harnesses or connectors.

Posted on May 25, 2009

  • 412 Answers

SOURCE: 2002 PT Cruiser fuel pump and filter

FUEL PUMP IS LOCATED IN FUEL TANK..FILTER IS LOCATED ON TOP OF PUMP MODULE..A NEW PUMP WILL NORMALLY COME WITH THIS FILTER..YOU MUST REMOVE FUEL TANK FROM VEHICLE TO REPLACE THESE COMPONENTS..IF YOUR NOT SURE YOU CAN DO THIS,I WOULD TALK TO A REPAIR SHOP..FUEL CAN BE VERY DANGEROUS

Posted on Jun 23, 2009

c17hydro
  • 2984 Answers

SOURCE: Where is the asd relay on my 1990 dakota?

ASD is in the engine compartment fuse block.

The pump relay should be there also. Check your fuse panel in the truck though.

Fuses, Relays & Circuit Breakers The fuse panel box is to the right of the glove box with the glove box door opened or beneath the instrument panel (dashboard) on 1989-93 models.

2d26fdd.gif
Pull out the fuse panel for access to the blade type fuses

Posted on Oct 18, 2009

  • 134 Answers

SOURCE: where is the fuel pump relay on a 06 pt cruiser

I do not see a specific fuel pump relay on this vehicle.. The auto shutdown relay however is located on the drivers side firewall right below the windshield. If you are standing at the drivers side fender.. look toward the engine and it will be on your right hand side.. Hope this helps.. There is a starter relay in this location too...The ASD relay will be on the right hand side..

Posted on Aug 18, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 pt cruiser keeps blowing fuel pump fuse,replaced fuel pump, no change.runs rough at idle and stalls,blows fp fuse,also replaced ign.coil,plug wires and plugs also changed relays


There are two fuses for the fuel pump relay. One fuse is load side of relay, that fuse also sends voltage to load side of asd relay, the asd relay sends voltage to several systems, two of which are the fuel injectors and ignition coil. I'm not telling you to replace, anything, but, you need to do some testing.
The other fuse goes to control side of relay, smaller amp fuse. I don't know the amp rating of the fuse that keeps blowing.
See that fuse, it supplies voltage to load side of fuel pump relay and also to asd relay.
26322929-c15bjyrfwzlf33vqjpu1ik1c-2-0.jpg

Oct 22, 2016 | 2004 Chrysler PT Cruiser

1 Answer

The red immobilizer light is staying on,the engine cranks but wont start..


You then have a ant-theft system problem an need to have the vehicle checked for DTC'S - diagnostic trouble codes . The ASD - relay supplies power to the ignition coils an too the fuel injectors .The ASD- auto shut down relay is energized by the engine computer - PCM . With the red anti-theft light on the PCM will not turn on the ASD relay cause a no start condition . You can check fuse an relays all you want ,not going to do any good . You need to see what the ant-theft systems problem is .

Feb 29, 2016 | 2003 Chrysler PT Cruiser

1 Answer

On a 2008 Chrysler PT Cruiser, why is no fuel getting through to start the car?


Bad filter, no injector pulse (use noid light to check this), bad fuel pressure regulator (test pressure key on engine off).

May 04, 2015 | 2008 Chrysler Pt Cruiser

1 Answer

What would cause a 2006 pt cruiser 2.4 liter to crank and run for a few seconds and then die even after a fuel pump has been installed


Could be a couple of things. Camshaft sensor, crankshaft sensor, ASD relay failing, ignition switch, wiring issue..... Are you loosing spark, or the fuel pressure dropping while it is shutting down....

Aug 10, 2014 | Cars & Trucks

1 Answer

No Spark


The relay for the fuel pump is working but have you checked that the pump is actually pressurising the system . Next you have power at the coil but is it getting to the spark plugs from the distributor.

Feb 15, 2014 | 2003 Chrysler PT Cruiser

1 Answer

2005 PT Cruiser no crank


sounds like the crank position sensor. check continuity and 5volts reference at sensor. you can have it checked by someone with a Good scanner(SNAP-ON). If it happens to start up,drive the car till it wont start up again; unplug the crank position sensor and count to 5 then plug it back in. If it starts then its the crank sensor.(just a quick way to test it and get you home or to a shop)

Jan 01, 2014 | 2005 Chrysler PT Cruiser

1 Answer

06 pt cruiser no start/no fuel presure


fuel pump fried need new fuel pump check your fuel pump relay make sure its good.

Feb 17, 2013 | 2006 Chrysler PT Cruiser

1 Answer

Not getting fire


You may be geting gas from the fuel pump but are the injector working or do they have power going to them. You can check the dark green & orange wire at any injector. Also check for power at the plug of the coil (there are two together but both get power from one place). The power wire for the coil also happens to be dark green and orange. If you are not getttting power to either one, check the auto shutdown relay (ASD). This relay stops power to the injectors and the coil but the fuel pump will still work. It doesn't shut down the fuel pump. You can let me know here or you can email me directly at csautomotivecars@att.net with all your information and I will be happy to help and no there is no cost. Just need to be sure if this is the case first (the ASD relay) to go any further. Also if you have a turbo this information isn't correct as far as the wire coloring goes.

Apr 05, 2012 | 2007 Chrysler PT Cruiser Touring Hatchback

1 Answer

2005 pt cruiser won't start won't crank, everything works


When you turn the key on the ASD relay should turn on the fuel pump and power the injector, Do this lets cheat the system go to the ASD rely open the cover expose the inside have some one turn the key on does the ASD make contact? If not turn the key on collpase the ASD so it make contact do you hear the fuel pump come on? Now try this just as how you iopen the ASD do the same to the starter relay. Put the car in gear e brake on someone in the vehicle in case the car start and you are in front of it and it runs you over so at least they step on the brakes. Key on ASD exposed as your collapse the starter relay does the ASD relay turn on? Here why if you can control all the relay from under the hood you will need a ignition switch (the eletrical part)

Feb 22, 2012 | 2005 Chrysler PT Cruiser

1 Answer

Where is the fuel pump relay on a 06 pt cruiser


I do not see a specific fuel pump relay on this vehicle.. The auto shutdown relay however is located on the drivers side firewall right below the windshield. If you are standing at the drivers side fender.. look toward the engine and it will be on your right hand side.. Hope this helps.. There is a starter relay in this location too...The ASD relay will be on the right hand side..

Aug 18, 2011 | 2006 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

332 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...