Question about Cars & Trucks

1 Answer

I WONT TO KNOW WHAT A CONTROL MODULE LOOKS LIKE.

WONT COME OUT OF 2 WHEEL DRIVE.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 14,585 Answers

Year, make ,and model? Plus the module you are looking for. Modules start at 2 inch square up to 8 inch square.

Posted on Nov 08, 2014

Testimonial: "99 gmc sonoma not sure on the size of the module."

  • Vonda Lynn Kidd
    Vonda Lynn Kidd Nov 08, 2014

    At frist it would stick in 4 and would not come out till the motor warmed up the it would go back in 2 But now it is in 2 and wont come out. All so when the temp is 45 or below it takes for every to start. But after the mortor gets warm you can shut it off and will start every time till it gets cold again. It just started doing this after i put a new gas cap on it.

  • Randy Ohler Nov 09, 2014

    Take it some where and have the codes read.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On 05 chev Tahoe 2 wheel drive it want crank code co292 what do I do to fix it


C0292
Lost Communications with Engine Control System
EBCM
DTC C0290 or C0292 in Antilock Brake System
Your best bet ! Take it to a quaified repair shop . Do you know what Class 2 data bus is ?

Class 2 Serial Data Line
The class 2 serial data line on this vehicle is a star configuration. The following modules communicate on the class 2 serial data line:
• Audio Amplifier, w/UQ7 and Y91
• Body Control Module (BCM)
• CD Changer (CDX), w/U1S and Y91
• Digital Radio Receiver (DRR), w/U2K or U2L
• Driver Door Module (DDM)
• Driver Seat Module (DSM), w/AN3
• Electronic Brake Control Module (EBCM)
• Electronic Suspension Control (ESC) Module, w/Z55
• Front Passenger Door Module (FPDM)
• Generator Battery Control Module (GBCM)
• HVAC Control Module
• HVAC Control Module - Rear Auxiliary
• Instrument Panel Cluster (IPC)
• Powertrain Control Module (PCM)
• Radio
• Rear Seat Audio (RSA) Controller, w/UK8
• Rear Seat Entertainment (RSE) Assembly, w/U42
• Rear Wheel Steering Control Module (RWSCM)
• Inflatable Restraint Sensing and Diagnostic Module (SDM)
• Transfer Case Shift Control Module (TCSCM), w/NP1/NP8
• Vehicle Communication Interface Module (OnStar), w/UE1
• Vehicle Theft Deterrent (VTD) Module, w/VD1
The class 2 serial data line allows a scan tool to communicate with these modules for testing purposes, checking for DTCs, and to activate/enable/disable functions. These class 2 serial data circuits are bused together via three splice packs and DLC:

Mar 27, 2017 | Cars & Trucks

1 Answer

Cant locate four wheel drive on off switch


sound like you have the automatic four wheel drive system where the transfercase control module controls the 4WD system if you dont see shifter knob on console you have automatic 4WD drive system.

Jan 17, 2013 | 1998 Mercury Mountaineer

1 Answer

2001 Nissan PAthfinder 4-wheel drive malfunctioning'


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

Oct 11, 2012 | 2001 Nissan Pathfinder

1 Answer

1999 Rav4 Idot now How set it to 4 weel Dr pleas tellme How


1999 Rav4 has a 2-Wheel drive option. If you have 4-Wheel drive (check with dealer) there is no need to set it to 4-Wheel drive as the 4-Wheel drive mode is controled by the Powertrain Control Module (On-Board Computer) as needed.

Jan 30, 2011 | 2008 Toyota RAV4

1 Answer

On a 2000 Isuzu Rodeo 2 wheel drive 3.2 V6 I need to know where my power control module is located


The powertrain control module(pcm) is located behind the lower trim panel in the center of the dash. Right in front of the shifter.
I hope this helps.

todytwo

Feb 27, 2010 | Isuzu Rodeo Cars & Trucks

1 Answer

Four wheel wont engage.Are the wires from trans case,where do they lead to


Hi:
Your push button 4 wheel drive system has the push button panel, a shift control module, which is located behind the center console, and a shift control motor, which is on the side of the transfer case. If your transfer case is still ok, you can unbolt the shift control motor, and cycle the shift buttons to see if it moves. Most likely failed part is the shift control module,

Dec 16, 2009 | 2003 Chevrolet S-10

1 Answer

Put it in drive and stays in high gear wont shift


Bad connection where the wires from the tranny plug up or you have a bad transmission control module, located I think underneath the dash next to the ECU module, looks like it except smaller.

Oct 08, 2009 | 1997 Geo Metro

1 Answer

I HAVE A 93 PONTIAC TRANSAM 5.7 AND ITS GUAGE LIGHTS WONT WORK


might be ur instr control module goto rockauto.com it'll show a pic of what it looks like it somewherer underdash by the steering wheel column

Mar 22, 2009 | 1993 Pontiac Firebird

1 Answer

My 4 wheel drive went into 4 wheel high while my switch was in 2 wheel high and it wont go back. i checked the fuses and they are ok.


there is a comfort control module under the dash that controls this function. mine got wet from a leak in the windshield (OE seal) it is on the drivers side. i replaced it and all is fine. (it had water stains inside it)

Feb 03, 2009 | 1997 Ford Expedition

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...