Question about Cars & Trucks

1 Answer

My nissan pickup 2004 model is a manual gear box why wont it my car move forward or back.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 179 Answers

Need to know if you can get it into gear or not. Sounds like a problem with the clutch.

Posted on Nov 08, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 109 Answers

SOURCE: nissan sentra 1997 starts but wont go when put in gear

is it a manual or automatic?if it's manual check clutch.if it is automatic check transmission fluid.

Posted on Dec 02, 2008

  • 1 Answer

SOURCE: 2004 Nissan Murano, back door can't open

I had a similar problem with a sienna and sometimes the cable ( inside the door) between the handle and the latch gets stuck in the sleeve. Kind of like the brake cable on a bike.
take the panel off by removing all the screws you can see on the panel and pull the panel off. There will be plastic pins holding it. Some of them may pop off and some will break off.
Drip oil down the sleeve so the cable slides freely. I used bike chain oil. Do not use WD40. This is **** and will not work for very long. Try the handles a few times before you put the panel back.

Posted on Mar 03, 2009

  • 4 Answers

SOURCE: 2003 Nissan Altima hesitates

take the car to autozone and have them run a code search on it.

Posted on May 01, 2009

hardinfarms
  • 144 Answers

SOURCE: car does not drive forward but works in reverse

Sad to say but your automatic transmission has bit the dust.

Posted on Jul 24, 2009

  • 1 Answer

SOURCE: no reverse gear

This question should be deleted. Aside from the obvious illiteration, there is nothing in the known universe that could be stuck in an oil filter that could cause the transmission to fail, nor could the oil pressure. What most likely happened is someone did a neutral drop and blew a solenoid in the transmission. Rebuild/replace transmission, or drive without it.

Posted on Jan 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

MY CARRIER BEARING IN MY 1989 NISSAN PICK UP WONT STAY IN


check to see that the mount for the bearing has been installed correctly. IF the drive shaft slip joint is in the back of the gear box then check that the travel up and down of the diff is not excessive and that the diff is where it is supposed to be Check radius rods --springs --centre bolts as something is pulling on the centre bearing and making it move out of the rubber support.

Feb 01, 2014 | 1991 Nissan Pickup

1 Answer

1984 Nissan Pickup no reverse


MANUAL TRANS I TAKE IT? YOU HAVE MOST LIKELY LOST YOUR REVERSE SYNCRONIZER GEAR OR SIMILAR PART......INTERNAL TRANS REPAIR...OR USED TRANS

Jul 30, 2012 | 1984 Nissan Pickup

1 Answer

I was wondering if you can help me out, I have a 1992 Nissan Terrano 3Lt V6 4x4, its just an old farm truck, Well today I was driving it down the paddock and all of a sudden it wont move in any gear,...


If it is an automatic, and absoloutely no movement it sounds like the torque convertor has failed. Either impellor or turbine. If it is a manual the clutch may have gone. If it is a manual, place it in gear and get a friend to rock the car back and forward. See if you notice any movement of the harmonic balancer/belts in the engine bay?

Jan 24, 2011 | 1994 Nissan Pathfinder

2 Answers

Car will start but will not move forward or backwards can u help?


Mke sure that the transmission is working. you can tell if the engine rpm changes when you put it gear (forward or reverse) if it does not then you need to check the level of the transmission fluid for an automatic or you may have clutch problems if it is a manual transmission. if you have more details on the transmission type (auto or manual) and if it is doing anything when you try to get it to move that would be helpful.

Nov 20, 2010 | 1991 Nissan Maxima

1 Answer

Driving up hills with my nissan pulsar


It does sound like a gear box issue. 1st and reverse do share some hardware inside. Have a good transmission repair person take a listen to it if you can.

Jul 22, 2009 | 2004 Nissan Armada

1 Answer

95 NISSAN PICK UP WONT MOVE IN DRIVE


Test the transmission module. It controls everything the transmission does, the timing of shift points, gear selection, overdrive, etc

Jul 28, 2017 | 1995 Nissan Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...