Question about 1997 Chevrolet Blazer

1 Answer

How do i replace a accelorater cable on a 1997 blaser

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Chevrolet Master
  • 2,494 Answers

Disconnect cable at throttle butterfly undo the retainer bolt on firewall and pedal leaver slide old cable and new one in the same position.

Posted on Nov 08, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Just bought a used chevy blaser....iv'e been having dead battery problems, with possibly a bad alternater, it sounds like a bearing....but im wondering if i pushed a wrong button or somthing...

Check that the alternator is not working. This is common for a car to turn over and not completely start. The alternator is not charging the battery hence your electrical charge drains to low. If you are handy with a voltmeter, check that there is charge at the battery and if the voltage is higher when the car runs assuming you can start it again.

Feb 01, 2015 | Cars & Trucks

1 Answer

Hodo I fix a sticking accelorater on a 1995 ford aerostat

check the throttle cable for binding or fraying, then check the movement of the throttle shaft with the cable unhooked as they can wear and cause binding. if the cable is worn replace if the throttle shaft is binding replace assembly. check to make sure the gas pedal is not binding as well.

Sep 24, 2014 | 1995 Ford Aerostar

1 Answer

I have a 2001 grand marquis and when i switch it on the red light on my dash starts blinking really fast and never gos off my fuel pump keeps pumping the car is reading that its hot but the car want even...

your problem is the eath cables are not earthing out,,what happens is that with not having an earth the car will try to find 1 it will even try to earth an accelorater cable,or any other piece of metal,,got to be care full as it will make cables to get hot if you crank to long

Oct 31, 2013 | Cars & Trucks

1 Answer

Four wheel will not engage on 1996 s10 blaser

Check your vacuum lines under your hood, if one is sucking in alot of air, then it needs to be replaced. Once it's replaced, everything should work fine!

Dec 14, 2009 | 1996 Chevrolet Blazer

1 Answer

I have a 89 chevy blaser with an electral problem

how to replace a tailgate switch for a 1989 chevy silverado blazer

Oct 27, 2009 | 1989 Chevrolet S-10 Blazer

1 Answer

98 chevy blaser is hard to start when is cold the fuel presure is fine

Check for the ground to the engine and to the body, chevys comes with a lot of grounds everywhere but the most for starting are the one on the engine and the one on the body, check for the correct gauge of the cables, fell the cables if they are warm whe you try to start, it supose to be a gauge bigger.
goodf luck.

Jul 08, 2009 | 2000 Chevrolet Blazer

1 Answer

Transmission slips in drive

bro, i think your clutch is mess up. have it replace

Feb 28, 2009 | 1988 Honda Prelude

Not finding what you are looking for?
1997 Chevrolet Blazer Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

79851 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides