All service/technical data for engine rebuild
SOURCE: torque specs 7.5 inch rear axle 96 ford ranger
Differential bearing caps 70-85 ft lb
Ring gear bolts 70-85 ft lb
Pinion bearing preload if using original bearings 8-14 lb-in, if installing new bearings 16-28 lb-in
SOURCE: Engine tappet clearances
According to http://freespace.virgin.net/tommy.sandham/databook.htm# Rocker Adjustment, the cold clearance is .008" intake/.018" exhaust in the non-GT 1500cc, and .012" intake/.022 exhaust on the GT. Sweet little car!!!
SOURCE: timing belt broke -2000 ford focus zx3
Hello mawbea: My name is Roger I will answer your question. You did not say which engine is in your car. So if you have a 2.0 SOHC engine. If the belt broke you should be Ok. If you have the 2.0 DOHC engine. The likely hood of bending the valves are just about a guarantee. How ever with any engine using a timing belt it is possible to bend a valve.Should you need more help please just ask.
Please rate the quality of your answer as this way we know you received helpful information.Thank You for using Fix Ya, Roger
SOURCE: torque wrench settings for ford focus thermostat
There is a set spec, but for the DIY mechanic,,
Using a !/4 " drive, with the correct long socket, apply a FIRM effort on the wrench, but obviously not too much, as to sheer the studs. Always use a NEW gasket on all mating surfaces.
Regards,DT
Testimonial: "a specific torque setting would be better !!"
773 views
Usually answered in minutes!
×