Question about 1999 Daewoo Lanos

2 Answers

My dawoo lanos car idle speed is going to fast when hi star it and stop what could it be

My car idle spped is going to high what could this be and why thanks

Posted by on

Ad

2 Answers

A Vacuum Leak could be a factor

Any Idle solenoid that can not function
properly for some reason

You have to have the car diagnosed to find out
why you lost idle control

When you start a vehicle, it will idle up to 1300 rpm
& then settle in at 700 to 780 rpm depending on the
vehicles strategy

Posted on Nov 07, 2014

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Daewoo Master
  • 5,720 Answers

Could be IAC sensor.

Posted on Nov 07, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

MobyMech
  • 106 Answers

SOURCE: fuel pump on Daewoo Lanos 1.3

Hi

If my memory serves me right the Lanos has an immersed pump, and therefor you need to be looking either under the rear seats or in the luggage compartment for a round metal or plastic cover which when removed will uncover the top of the pump and fuel sender unit.

It is probably held in place by a large plastic or metal ring which either has to be unscrewed or just turned slightly to disengage the securing lugs.

PLEASE DISCONNECT THE BATTERY NEGATIVE TERMINAL BEFORE MESSING WITH THE PUMP OR YOU MAY HAVE AN EARLY FIREWORKS DISPLAY!!!

Just as a matter of interest, I assume when you say FLUIDS you actually mean FLOODS, in which case, the problem isn't the pump.

If the car doesn't start, or struggles to do so, and there is a smell of fuel or the plugs are getting wet, then the problem is more likely to be a lack of spark than anything else.

There are other scenarios, such as a faulty coolant sensor (cold engine), a faulty O2 sensor (hot engine), a faulty throttle position sensor (hot or cold engine), and a few others I could mention.

If you require any further help, just click ASK ME under my strange white round faced picture (which my MRS reckons looks just like me!!) and I shall be more than happy to assist you further.

Regards

Geordie

Posted on Jun 25, 2008

stevenhurc
  • 450 Answers

SOURCE: my car daewoo nubira 1998 stopd at idle speed and the center luck

these vehicles had a zylux immobiliser fitted at point of entry to Australia others had after market system fitted they didnt actuall build them with these features.you need to go to a dealer to repair or program new remote, have you got a second key remote? this one might still work

Posted on May 28, 2009

stevenhurc
  • 450 Answers

SOURCE: car wont idle

idle stepper motor(IAC) controls idle speed it is located on throttle body
f33d4ad.jpg IDLE LEARN PROCEDURE
Whenever the battery cables, the electronic control
module (ECM), or the ECM fuse is disconnected or replaced,
the following idle learn procedure must be performed:
1. Turn the ignition ON for 5 seconds.
2. Turn the ignition OFF for 5 seconds.
3. Turn the ignition ON for 5 seconds.
4. Start the engine in P/N (park/neutral).
5. Allow the engine run until the engine coolant is
above 85_C (185_F).
6. Turn the air conditioning (A/C) ON for 10 seconds, if
equipped.
7. Turn the A/C OFF for 10 seconds, if equipped.
8. If the vehicle is equipped with an automatic transaxle,
apply the parking brake. While pressing the
brake pedal, place the transaxle in drive (D).
9. Turn the A/C ON for 10 seconds, if equipped.
10. Turn the A/C OFF for 10 seconds, if equipped.
11. Turn the ignition OFF. The idle learn procedure is
complete.

Posted on Jul 04, 2009

  • 6 Answers

SOURCE: Daewoo Lanos 1.4 1997 Idling really high - Idle Rev Valve?

hi there the problem describe is a common problem you need to take the car into your dawoo/chevrolet dealer as there was a reprogramme that need s to be downloaded to your ecu to fix the problem should only take about 30 mins so should not cost you to much i used to have around 10 to 15 a week to do

Posted on Dec 20, 2009

  • 120 Answers

SOURCE: 1998 Daewoo Lanos went into Daewoo servicing

try checking the throttle position sensor

Posted on May 04, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whare is speed sensor on 2001 dawoo lanos


On front wheel drive vehicles they would be located in transmission, not internally bolted or screwed into the side of bellhousing. There will be two wires attached to it

Mar 16, 2013 | 2001 Daewoo Lanos

1 Answer

1985 gmc k1500 wipers only move at 1 slow spped, interminttent doesnt work at all. How fast is fast and why is fast not working?


Slow is the same speed as 'mist'. Mist is when you twist the control arm backwards to induce a single swipe. If you hold it, you will run the wipers in low speed. Fast is faster than that. Probably by 30% or more.

Turn the wipers on high speed. Wiggle the connector at the wiper motor. If the wipers run sporadically as you wiggle the connector, you either have a bad connector or a bad circuit board on the wiper motor.


Jan 15, 2010 | 1985 GMC K1500

3 Answers

Engine idle speed too fast some times. idle speed


Three things to check for:

1) High idle switch is on..*(vehicle thinks AC is running but it isn't.
You can try turning on the AC and see if the engine slows down to confirm this one.

2) Sticking or worn out Idle Air Control or IAC, You might get a check engine light with this one.....you might not if it's a mechanical failure.

3) Simplest of all. A vacuum leak. You can get the engine vacuum read while running if you go to a mechanic with a vacuum guage or an OBD 2 ecu code reader. There should be specs on what vacuum levels are normal for you car at idle.

Good luck and be careful!

Dec 29, 2009 | 1996 Isuzu Trooper

2 Answers

Coolant bottle in 200o Daewoo Lanos 1.6 is leaking


Replace the bottle.

It's to hard to weld together again...

Oct 31, 2009 | 2000 Daewoo Lanos

1 Answer

High idle speed when the engine is cold


The high idle speed at start up is normal. As the engine temperature increases, the engine idle should kick down automatically. Insofar as the emissions results, if there were a problem, the check engine light should be on. If it is, take the car to an autoparts store and have the fault codes read. Most parts stores will perform the scan for free. If the check engine light is not on, and the idle question was all you were worried about, you are good to go! Hope this helped and best wishes.

Jul 31, 2009 | 2002 Toyota Camry

1 Answer

How to take old gear knob out


Cut it off. Sorry, its the easiest way

Jul 26, 2009 | 2002 Daewoo Lanos

2 Answers

Hi the idle speed is to high on my daewoo lanos 1600, there is a soultion but i dont know where the power lead that goes to the speed valve in the solution it says top of engine, but i dont know what it...


there is a screw at the end of the throttle cable. get someone to rev the engine an your see it move.turn the screw anticlockwise and the idle should slow. clockwise will raise the idle speed.

Apr 02, 2009 | 1999 Daewoo Lanos

2 Answers

Daewoo Lanos 1.4 1997 Idling really high - Idle Rev Valve?


hi there the problem describe is a common problem you need to take the car into your dawoo/chevrolet dealer as there was a reprogramme that need s to be downloaded to your ecu to fix the problem should only take about 30 mins so should not cost you to much i used to have around 10 to 15 a week to do

Nov 23, 2008 | 2001 Daewoo Lanos

2 Answers

Engine Reving excessively


1. Engine on-dissconect the power lead to the [idle speed control valve] located on top of the engine.
2. turn engine off-
3. turn engine on, you may need to use throttle to start and to reach and hold tick over speed. Once tick over is achieved, re-connect the power lead the idle speed control valve.

You should now have normal tick over speed!

Jun 25, 2008 | 1999 Daewoo Lanos

Not finding what you are looking for?
1999 Daewoo Lanos Logo

175 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

yadayada
yadayada

Level 3 Expert

77499 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...