Question about 2003 Ford ZX2

1 Answer

Need wiring diagram for relay for fog lights on 2003 zx2

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Ford Master
  • 2,503 Answers

Its listed under escort zx2 chassis electrical wiring diagrams in autozone library,i just looked it up.

Posted on Nov 08, 2014


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 88 Answers

SOURCE: need wiring shematic for fog lights 2005 toyota corolla

im pretty sure these cars were already prewired for fog lights .there should be some plugs behind the bumper to fit them.if not get back i will explain how to wire them of luck.

Posted on Oct 17, 2008

  • 11 Answers

SOURCE: serpettine belt diagram

Google Image5def4ad.jpg

Posted on Oct 21, 2008

  • 463 Answers

SOURCE: i need a wiring diagram for fog lights oem to my toyota

The link below is a Typical fog lamp / driving lamp hookup. Keep in mind that in most states, for these lamps to be 'legal' (and thus pass inspection), you must wire them such that:

1. You can cut them off (in other words, there must be a switch installed to turn them off)


2. They may only be operated with the low beams. (therefore, you must power your on/off switch from the low beam circuit)

Posted on Feb 28, 2009

  • 175 Answers

SOURCE: Need Fuse Map Diagram BMW 318i 1993

check the internet for a bmw e36 ETM ( electronic troubleshooting manual) everything you need is there.

Posted on Jun 02, 2009

  • 230 Answers

SOURCE: i need a wiring diagram for a 93 honda accord fog

Please check this out:


Hope this helps.

Posted on Jul 04, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

2000 Chevrolet Tahoe Z71 fog light wiring diagram

I looked at 5.7l engine. The wiring diagram had old style and new style. The diagram is new style . At the fog lamp the purple wire is voltage, the black wire is ground, check them both. You can see fog lamp relay, the is a fog lamp fuse for you to check. Not only check the fuse, check the fuse circuit for voltage. Use a testlight. The fog lamp relay has no terminal numbers, sometimes that means the relay is soldered into the fuse box, you can't pull it out. Most relays have to sides, the load side, that line with arrowhead. The control side, left side in diagram, needs both voltage and ground. I couldn't get everything in one picture.
fog lamp-32b5fzfhtrs2eze10c3xu4au-5-0.jpg

Dec 18, 2017 | Chevrolet Cars & Trucks

1 Answer

How to install fog lights

To do it right you will need several things. Go to and register your vehicle to get a free wiring diagram and fusebox diagram.

This will help you wire the Fog lights. Here is how you plan this. You will need a light Relay to go inline between the lights and the Power supply. Get a Relay which needs a trigger wire to activate and fuse the power line going to the Relay.

This means that the Relay only needs power from the trigger wire to activate the connection between the power and the lights.

Then you need to pass the trigger wire through the Firewall(Cabin) in a manner that will not chaff the wire. This wire should be fused too! You can try to use an unused position in the Fusebox or inline fuse.

The power for this trigger wire should be controlled by the Ignition switch

This means that it will only have power when the Ignition is on. You do not want it to receive power when the Ignition is in ACC or OFF.

Wiring it in this sequence will prevent you from leaving the Fog lights burning without having the Ignition switch in the RUN position. Doing it this way will also let you leave the Fog lights switched ON between uses so you need not bother to turn the Fog lights off/on each time you get in your car.

Each power wire is protected by a fuse so if something shorts on one side of the Relay, the other end of the Relay may be unharmed.

Then it is just a matter of chosing the switch, lighted will indicate if the Fog lights are on, but not necessary to the basic operation of the switch. Then chose wisely for where you drill a mounting hole. Sometimes it is good to chose a panel that can be replaced if you change your mind about its' location.

Please rate my solution.

Oct 21, 2012 | 2011 Chevrolet Cruze

1 Answer

Need wiring diagram for headligt on 2003 chevy impala with 3.8 cu engine

Sounds like a short or the relay is going bad to the headlamps. You may be able to google for the diagram but probably will need to get a repair manual from the nearby auto parts store for appx $25.00. I would start by checking continuity with the battery disconnected on that side from the positive wire to a ground. Also start with checking the relay, they are usually generic and you should be able to swap two as long as the numbers match and see if that fixes the issue.

Jun 08, 2012 | 2003 Chevrolet Impala

1 Answer

Where does the hot wire for aftermarket fog lamps get wired in? hoping to use one of the empty buttons on the dashboard.

The factory wiring harness for the fog lights may already be there, if not you will need a relay and usually the relays have wiring instructions with them, if not the aftermarket fog lights DO have instructions on how to wire them, however you may need a wiring diagram for your vehicle, get a haynes manual it will have it.

Mar 29, 2010 | 2000 Mercury Cougar

1 Answer

Wiring for Bosch Hologen Fog Lights? Wiring harness has 5 wires from relay, Red to battery, 2 Black - 1 to each light?, 1 Yellow to?, 1 Blue to?, & where do the xtra Black and Green wires go to? These...

Look on the relay for the terminal numbers.
Terminal 30 goes to the battery positive.Red Wire
The two terminal 87 go to the fog lights.Black Wires
Match the color wire with what you have on the relay connection for the rest of the wires.
Terminal 86 should connect to your low beam headlight.
Terminal 85 should go to the fog light switch.
The fog light switch should connect to the terminal 85 and the other terminal on the switch will connect to ground.

Dec 21, 2009 | 1987 Nissan Pickup

1 Answer

Fog lights not turning on

Sounds good to me except, the switch light shout be on the relay primary circiut and light off until you turn it on. When you turn the switch on, it lights up and energizes the relay, the relay closes and completes the secondary circiut for ythe fog lights. VIOLA' I have a silverado. done deal thanks

May 28, 2009 | 2003 GMC Sierra

2 Answers

Ford 2003 ZX2 Blower does not work need fuse diagram

The fuse box is under the dash on the drivers side, the cover for it has a map showing which amperage fuse goes to what, includes the three most common sizes in the cover and a little plastic tool to remove them...hope this helps

Dec 22, 2008 | 2003 Ford ZX2

2 Answers

Fog light not working

The 15 amp FOG fuse is in the fuse box in the engine compartment, at the bottom, right between the fog light relay and the fan #1 relay. The fuse is by itself, there are no other fuses next to it. Hope this helps, and thanks for choosing FixYa.

Nov 22, 2008 | 2003 Toyota Corolla

Not finding what you are looking for?
2003 Ford ZX2 Logo

207 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides