Question about Mitsubishi Galant
Even the A.C light some are not working,can you advice me what need to do or check?
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
First you disconnect the 3 prong electric plug. To disconnect squeeze the side tabs together (hard) and pull away from the bulb, then you can pull off the protective rubber covering, (its a little snug so give it a tug from the 2 tabs on the top and bottom).
Next unscrew the little Phillips head screw to loosen the bracket that clips in the bulb (take note of how the clip is installed before you remove it, it holds the bulb securely in place).
Just loosen the screw as you do not need to remove it all the way. Pull out the old bulb and replace it with the new one.
The bulb has 3 spacing tabs on it so it can only go in one way. Make note of this when you remove it so you may replace it the same way. follow the steps in reverse and your done.
Note: The little wire clip that holds the bulb in can be a pain. Make sure you get a really good look at it, since it pops out as soon as you loosen the screw. If you get lost, you can always look at the other headlight. Oh, and don't do this in the dark.
Posted on Sep 28, 2009
First take off the negative battery cable or blow the alternator fuse, facing the back of the car reach UNDER the alternator and loosen the bolt on the bottom right side, now loosen the bolt on the adjuster block on top, you can now turn the adjuster bolt and move the alternator to change the belt. If you need to change the steering pump belt on the front of the motor, you need to loosen the nut on the back side of the idler pulley it holds the adjuster pulley in place . Then you can use the adjuster bolt to move the pulley to adjust the belt. Do not forget to tighten the pulley nut when finished.
Posted on Jan 11, 2011
Had this before and i found a fault on the fuse board ,no supply the printed circuit maybe as i didnt go any further i just looped it from another fuse that had power via ignition switch through the radio fuse and it all worked but the fuse for the radio wasnt the one i looped as that had power for the memory it was another one that done the interior light and a thin bit of telephone wire done the trick so check all the fuses for power ,pull them out and check with a little 12v screwdriver light thing from the chinese shop ,right star trek is about to start goodnight
Posted on Mar 02, 2012
Tips for a great answer:
Jul 16, 2014 | 1996 Mitsubishi Galant
Nov 02, 2013 | 2005 Mitsubishi Galant
Aug 19, 2012 | Mitsubishi Mighty Max Cars & Trucks
Feb 17, 2012 | 2003 Mitsubishi Galant
Jan 12, 2011 | 2004 Mitsubishi Galant
Oct 25, 2009 | 1994 Mitsubishi Galant
Jun 10, 2009 | 2001 Mitsubishi Galant
May 08, 2009 | 2003 Mitsubishi Galant
31 people viewed this question
Usually answered in minutes!