Question about Cars & Trucks

1 Answer

New battery putting out plenty of cranking amps

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Cars & Trucks Master
  • 1,243 Answers

Great! what kind of problem are you having with vehicle?

Posted on Nov 06, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1984 Nissan pickup with 2.4 not cranking new battery new starter just clicks

maybe starter jammed put it in first gear and turn the engine over careful car will lurch forward if it engages instantly depress clutch to stop forward movement, select neutral restart motor make sure you have plenty of room infront of you you can also do same procedure in reverse gear,if your not sure seek assistane

Aug 27, 2015 | Nissan Cars & Trucks

1 Answer

05 Chrysler Pacifica engine bucking , engine light comes on, battery light comes on. But battery is fully charged and alternator is working. When the battery comes out, it seems like the computer re

The Battery CCA Rating is to turn over the starter

CCA--Cold Cranking Amps
That is at zero degrees
Total cranking amps is at 32 degrees

The car runs off the alternator
It puts out over 14 volts

The 12 volt battery is 6 cells @1.2 v each = 13.2 v

You need 12.6 volts to test a car or you charge it first

You need over 13 volts to charge a battery,thus the alternator

The only other job the battery has is a stabilizer in the electrical

So you need to have the charging system diagnosed as the
various light you have on should be off when engine first starts

Dec 13, 2012 | 2005 Chrysler Pacifica

1 Answer

Car won't start

U might have 12 volts but no cranking amps try a jump start

Sep 20, 2012 | 2005 Chrysler Sebring Conv

1 Answer

My 2005 Aveo jumped time and replaced timing belt and pulleys, also had to rebuild the cylinder head. while had it apart decided to put a new starter on since it has 137,000 miles on it, got back together...

If the starter is pulling to many amps to crank the engine,it will drop the battery voltage too low for the fuel pump to operate at all or operate properly and the car will not start if it is not getting fuel at the proper pressure or no pressure.

Apr 08, 2017 | 2005 Chevrolet Aveo

1 Answer

Purchased new battery, had alternator checked, and it will only start if jumped of every time. Thank you for your time.

If you connections are good at the battery and the starter, you probably need a new starter-it is drawing more cranking amps than your new battery can provide, but the jump is putting it 'over the top' with more push (amps)-if it is very cold where you are, consider removing the battery and putting it inside to warm it up-but, you might have gotten a battery that does not have the minimum cold cranking amps (CCA) required for your vehicle.

Jan 24, 2011 | 2001 Chrysler Town & Country

1 Answer

Where is the starter and how do i get it out ?

    The starter is located alongside the engine, mounted below the head. The starter gear & head are inserted into the transmission bellhousing. You should be able to follow the + cable (large) to the starter motor. You should disconnect the negative battery cable, any other brackets or covers that block your path & disconnect the electrical connectors from the starter, remove the starter bolts, remove the starter. Reinstall & replace everything as you found it without overtightening & put back on the battery cable & give it a crank. Got a digital camera? Take plenty of before pictures of the bolts, wiring & anything you'll need to remove & you'll be able to review the connections & placement as it was originally. good luck

Jan 29, 2010 | 1999 Saturn SL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14309 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides