Fuel tank pressure sensor in a Kia Rio LX 06 - 2006 Kia Rio

Fuel cut-off switch ? ' Kia Forum

kia-forums.com https://www.kia-forums.com > threads > fuel-cut-off-s...
Jul 22, 2017 - It is located on the passenger side of the engine compartment up by the cowl. It has a rubber cover on it. Push it in and if it resets you will ...

Inertia Fuel cut off? - Kia Forum
Aug 1, 2019
Fuel Inertia switch location ' Kia Forum
Jan 23, 2011
Kia Rio Fuel Delivery Problem
Aug 1, 2019
Sorento does not start after accident??? - Kia Forum
Aug 1, 2019
More results from www.kia-forums.com
https://www.google.com/search?q=2007+Kia+Rio+LX.+Where+is+the+fuel+cutoff+switch

copy and paste

https://www.kiapartsnow.com/genuine/kia-sensor-fuel-tan~314352h500.html

You have 2.https://www.justanswer.com/kia/4ffyz-kia-rio-kia-rio-oxy-sensor-location.html

I have a 2007 kia sportage lx 2.0, and just replaced the fuel tank pressure sensor after getting check engine light and consistent P0452. After finding 2 access ports under each back seat looking all over. No sensor found. No helpful info online found anywhere as to location. So bought repair book. It is under car, under evap canister. Hope this helps.

Where is the fuel tank pressure sensor located on a 2007 kia rio sx 1.6

check fuel reg., fuel filter, fuel pressure, gas cap seal

Hi, first check the connector on the knock sensor. If the connector looks good and tight, replace the sensor. This should clear the trouble code and restore some power. If the car continues to lack power, check the fuel pressure at the fuel rail on top of the engine. If the pressure is under 40 psi, replace the fuel filter and check the pressure again. If the pressure is low after replacing the filter, replace the fuel pump. Please let me know if you have more questions, and thanks for using fixYa.

Autozone.com

had similar problem, 2003 rio 1.6l idle fine and die when trying to accelerate or lurch and die ran fine in reverse change timing belt,wires plugs, had codes for multi cyl misfire and low injector voltage, still same lurch and die. try wiggle test on sensor plugs and main engine harness between battery and engine . i did this and found car smoothed out,tried wiggle again and car died,took harness apart where i wiggled it and found broken wire to crank sensor.good now

its i your gas tank doesnt need to be replaced